Things are a little tricky because, unlike sun4u, we have
to:

1) do a hypervisor trap to do the TLB load.
2) do the TSB lookup calculations by hand
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

V9 requires a write memory barrier before the instruction flush.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

If we're just switching between different alternate global
sets, nop it out on sun4v.  Also, get rid of all of the
alternate global save/restore in the OBP CIF trampoline code.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

They are totally unnecessary because:

1) Interrupts are already disabled when switch_to()
   runs.

2) We don't use hard-coded alternate globals any longer.

This found a case in rtrap, which still assumed alternate
global %g6 was current_thread_info(), and that is fixed
by this changeset as well.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Instead of setting/clearing PSTATE_AG we have to change
the %gl register value on sun4v.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

As we save trap state onto the stack, the store buffer fills up
mid-way through and we stall for several cycles as the store buffer
trickles out to the L2 cache.  Meanwhile we can do some privileged
register reads and other calculations, essentially for free.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

And more consistently check cheetah{,_plus} instead
of assuming anything not spitfire is cheetah{,_plus}.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

When saving and restoing trap state, do the window spill/fill
handling inline so that we never trap deeper than 2 trap levels.
This is important for chips like Niagara.

The window fixup code is massively simplified, and many more
improvements are now possible.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This, as well as making the code cleaner, allows a simplification in
the TSB miss handling path.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

On uniprocessor, it's always zero for optimize that.

On SMP, the jmpl to the stub kills the return address stack in the cpu
branch prediction logic, so expand the code sequence inline and use a
code patching section to fix things up.  This also always better and
explicit register selection, which will be taken advantage of in a
future changeset.

The hard_smp_processor_id() function is big, so do not inline it.

Fix up tests for Jalapeno to also test for Serrano chips too.  These
tests want "jbus Ultra-IIIi" cases to match, so that is what we should
test for.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

There are several tricky races involved with growing the TSB.  So just
use base-size TSBs for user contexts and we can revisit enabling this
later.

One part of the SMP problems is that tsb_context_switch() can see
partially updated TSB configuration state if tsb_grow() is running in
parallel.  That's easily solved with a seqlock taken as a writer by
tsb_grow() and taken as a reader to capture all the TSB config state
in tsb_context_switch().

Then there is flush_tsb_user() running in parallel with a tsb_grow().
In theory we could take the seqlock as a reader there too, and just
resample the TSB pointer and reflush but that looks really ugly.

Lastly, I believe there is a case with threads that results in a TSB
entry lock bit being set spuriously which will cause the next access
to that TSB entry to wedge the cpu (since the TSB entry lock bit will
never clear).  It's either copy_tsb() or some bug elsewhere in the TSB
assembly.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The are distrupting, which by the sparc v9 definition means they
can only occur when interrupts are enabled in the %pstate register.
This never occurs in any of the trap handling code running at
trap levels > 0.

So just mark it as an unexpected trap.

This allows us to kill off the cee_stuff member of struct thread_info.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This way we don't need to lock the TSB into the TLB.
The trick is that every TSB load/store is registered into
a special instruction patch section.  The default uses
virtual addresses, and the patch instructions use physical
address load/stores.

We can't do this on all chips because only cheetah+ and later
have the physical variant of the atomic quad load.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

If we are returning back to kernel mode, %g4 could be live
(for example, in the case where we window spill in the etrap
code).  So do not change it's value if going back to kernel.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Since we use %g5 itself as a temporary, it can get clobbered
if we take an interrupt mid-stream and thus cause end up with
the final %g5 value too early as a result of rtrap processing.

Set %g5 at the very end, atomically, to avoid this problem.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

%g6 is not necessarily set to current_thread_info()
at sparc64_realfault_common.  So store the fault
code and address after we invoke etrap and %g6 is
properly set up.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Just flip the bit off of whatever it's currently set to.
PSTATE_IE is guarenteed to be enabled when we get here.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

No longer used, and move extern declaration to a header file.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

It is totally unnecessary complexity.  After we take over
the trap table, we handle all PROM tlb misses fully.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Instead of ugly hard-coded value.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Some of the trap code was still assuming that alternate
global %g6 was hard coded with current_thread_info().
Let's just consistently flush at KERNBASE when we need
a pipeline synchronization.  That's locked into the TLB
and will always work.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The TSB_LOCK_BIT define is actually a special
value shifted down by 32-bits for the assembler
code macros.

In C code, this isn't what we want.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

No longer needed now that we no longer have hard-coded
alternate global register usage.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

As the RSS grows, grow the TSB in order to reduce the likelyhood
of hash collisions and thus poor hit rates in the TSB.

This definitely needs some serious tuning.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This also cleans up tsb_context_switch().  The assembler
routine is now __tsb_context_switch() and the former is
an inline function that picks out the bits from the mm_struct
and passes it into the assembler code as arguments.

setup_tsb_parms() computes the locked TLB entry to map the
TSB.  Later when we support using the physical address quad
load instructions of Cheetah+ and later, we'll simply use
the physical address for the TSB register value and set
the map virtual and PTE both to zero.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Move {init_new,destroy}_context() out of line.

Do not put huge pages into the TSB, only base page size translations.
There are some clever things we could do here, but for now let's be
correct instead of fancy.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>