Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 10 8月, 2010 2 次提交
  3. 28 7月, 2010 1 次提交
  5. 27 7月, 2010 1 次提交
  7. 26 7月, 2010 1 次提交
  9. 21 7月, 2010 1 次提交
  11. 05 6月, 2010 1 次提交
  13. 03 6月, 2010 1 次提交
  15. 28 5月, 2010 1 次提交
  17. 25 5月, 2010 6 次提交
  19. 22 5月, 2010 2 次提交
    • J
      at24: Fall back to byte or word reads if needed · 7aeb9664
      由 Jean Delvare 提交于 
      Increase the portability of the at24 driver by letting it read from
EEPROM chips connected to cheap SMBus controllers that support neither
raw I2C messages nor even I2C block reads. All SMBus controllers
should support either word reads or byte reads, so read support
becomes universal, much like with the legacy "eeprom" driver.

Obviously, this only works with EEPROM chips up to AT24C16, that use
8-bit offset addressing. 16-bit offset addressing is almost impossible
to support on SMBus controllers.

I did not add universal support for writes, as I had no immediate need
for this, but it could be added later if needed (with the same
performance issue as byte and word reads have, of course.)
Signed-off-by: NJean Delvare <khali@linux-fr.org>
Reviewed-by: NWolfram Sang <w.sang@pengutronix.de>
Cc: Konstantin Lazarev <klazarev@sbcglobal.net>
      7aeb9664
    • C
      sysfs: add struct file* to bin_attr callbacks · 2c3c8bea
      由 Chris Wright 提交于 
      This allows bin_attr->read,write,mmap callbacks to check file specific data
(such as inode owner) as part of any privilege validation.
Signed-off-by: NChris Wright <chrisw@sous-sol.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
      2c3c8bea
  21. 14 5月, 2010 3 次提交
  23. 09 5月, 2010 1 次提交
  25. 25 4月, 2010 1 次提交
    • D
      VMware Balloon driver · 453dc659
      由 Dmitry Torokhov 提交于 
      This is a standalone version of VMware Balloon driver.  Ballooning is a
technique that allows hypervisor dynamically limit the amount of memory
available to the guest (with guest cooperation).  In the overcommit
scenario, when hypervisor set detects that it needs to shuffle some
memory, it instructs the driver to allocate certain number of pages, and
the underlying memory gets returned to the hypervisor.  Later hypervisor
may return memory to the guest by reattaching memory to the pageframes and
instructing the driver to "deflate" balloon.

We are submitting a standalone driver because KVM maintainer (Avi Kivity)
expressed opinion (rightly) that our transport does not fit well into
virtqueue paradigm and thus it does not make much sense to integrate with
virtio.

There were also some concerns whether current ballooning technique is the
right thing.  If there appears a better framework to achieve this we are
prepared to evaluate and switch to using it, but in the meantime we'd like
to get this driver upstream.

We want to get the driver accepted in distributions so that users do not
have to deal with an out-of-tree module and many distributions have
"upstream first" requirement.

The driver has been shipping for a number of years and users running on
VMware platform will have it installed as part of VMware Tools even if it
will not come from a distribution, thus there should not be additional
risk in pulling the driver into mainline.  The driver will only activate
if host is VMware so everyone else should not be affected at all.
Signed-off-by: NDmitry Torokhov <dtor@vmware.com>
Cc: Avi Kivity <avi@redhat.com>
Cc: Jeremy Fitzhardinge <jeremy@goop.org>
Cc: Ingo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      453dc659
  27. 07 4月, 2010 1 次提交
  29. 03 4月, 2010 1 次提交
  31. 30 3月, 2010 1 次提交
    • T
      include cleanup: Update gfp.h and slab.h includes to prepare for breaking... · 5a0e3ad6
      由 Tejun Heo 提交于 
      include cleanup: Update gfp.h and slab.h includes to prepare for breaking implicit slab.h inclusion from percpu.h

percpu.h is included by sched.h and module.h and thus ends up being
included when building most .c files.  percpu.h includes slab.h which
in turn includes gfp.h making everything defined by the two files
universally available and complicating inclusion dependencies.

percpu.h -> slab.h dependency is about to be removed.  Prepare for
this change by updating users of gfp and slab facilities include those
headers directly instead of assuming availability.  As this conversion
needs to touch large number of source files, the following script is
used as the basis of conversion.

  http://userweb.kernel.org/~tj/misc/slabh-sweep.py

The script does the followings.

* Scan files for gfp and slab usages and update includes such that
  only the necessary includes are there.  ie. if only gfp is used,
  gfp.h, if slab is used, slab.h.

* When the script inserts a new include, it looks at the include
  blocks and try to put the new include such that its order conforms
  to its surrounding.  It's put in the include block which contains
  core kernel includes, in the same order that the rest are ordered -
  alphabetical, Christmas tree, rev-Xmas-tree or at the end if there
  doesn't seem to be any matching order.

* If the script can't find a place to put a new include (mostly
  because the file doesn't have fitting include block), it prints out
  an error message indicating which .h file needs to be added to the
  file.

The conversion was done in the following steps.

1. The initial automatic conversion of all .c files updated slightly
   over 4000 files, deleting around 700 includes and adding ~480 gfp.h
   and ~3000 slab.h inclusions.  The script emitted errors for ~400
   files.

2. Each error was manually checked.  Some didn't need the inclusion,
   some needed manual addition while adding it to implementation .h or
   embedding .c file was more appropriate for others.  This step added
   inclusions to around 150 files.

3. The script was run again and the output was compared to the edits
   from #2 to make sure no file was left behind.

4. Several build tests were done and a couple of problems were fixed.
   e.g. lib/decompress_*.c used malloc/free() wrappers around slab
   APIs requiring slab.h to be added manually.

5. The script was run on all .h files but without automatically
   editing them as sprinkling gfp.h and slab.h inclusions around .h
   files could easily lead to inclusion dependency hell.  Most gfp.h
   inclusion directives were ignored as stuff from gfp.h was usually
   wildly available and often used in preprocessor macros.  Each
   slab.h inclusion directive was examined and added manually as
   necessary.

6. percpu.h was updated not to include slab.h.

7. Build test were done on the following configurations and failures
   were fixed.  CONFIG_GCOV_KERNEL was turned off for all tests (as my
   distributed build env didn't work with gcov compiles) and a few
   more options had to be turned off depending on archs to make things
   build (like ipr on powerpc/64 which failed due to missing writeq).

   * x86 and x86_64 UP and SMP allmodconfig and a custom test config.
   * powerpc and powerpc64 SMP allmodconfig
   * sparc and sparc64 SMP allmodconfig
   * ia64 SMP allmodconfig
   * s390 SMP allmodconfig
   * alpha SMP allmodconfig
   * um on x86_64 SMP allmodconfig

8. percpu.h modifications were reverted so that it could be applied as
   a separate patch and serve as bisection point.

Given the fact that I had only a couple of failures from tests on step
6, I'm fairly confident about the coverage of this conversion patch.
If there is a breakage, it's likely to be something in one of the arch
headers which should be easily discoverable easily on most builds of
the specific arch.
Signed-off-by: NTejun Heo <tj@kernel.org>
Guess-its-ok-by: NChristoph Lameter <cl@linux-foundation.org>
Cc: Ingo Molnar <mingo@redhat.com>
Cc: Lee Schermerhorn <Lee.Schermerhorn@hp.com>
      5a0e3ad6
  33. 25 3月, 2010 1 次提交
  35. 15 3月, 2010 1 次提交
    • W
      init dynamic bin_attribute structures · f937331b
      由 Wolfram Sang 提交于 
      Commit 6992f533 ("sysfs: Use one lockdep
class per sysfs attribute.") introduced this requirement.  First, at25
was fixed manually.  Then, other occurences were found with coccinelle
and the following semantic patch.  Results were reviewed and fixed up:

    @ init @
    identifier struct_name, bin;
    @@

    	struct struct_name {
    		...
    		struct bin_attribute bin;
    		...
    	};

    @ main extends init @
    expression E;
    statement S;
    identifier name, err;
    @@

    (
    	struct struct_name *name;
    |
    -	struct struct_name *name = NULL;
    +	struct struct_name *name;
    )
    	...
    (
    	sysfs_bin_attr_init(&name->bin);
    |
    +	sysfs_bin_attr_init(&name->bin);
    	if (sysfs_create_bin_file(E, &name->bin))
    		S
    |
    +	sysfs_bin_attr_init(&name->bin);
    	err = sysfs_create_bin_file(E, &name->bin);
    )
Signed-off-by: NWolfram Sang <w.sang@pengutronix.de>
Cc: Eric W. Biederman <ebiederm@xmission.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      f937331b
  37. 14 3月, 2010 2 次提交
  39. 13 3月, 2010 1 次提交
  41. 08 3月, 2010 2 次提交
  43. 07 3月, 2010 4 次提交
  45. 24 12月, 2009 3 次提交
  47. 18 12月, 2009 1 次提交