Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 12 10月, 2008 1 次提交
  3. 09 10月, 2008 2 次提交
  5. 06 10月, 2008 4 次提交
    • H
      atmel-mci: Add experimental DMA support · 65e8b083
      由 Haavard Skinnemoen 提交于 
      This adds support for DMA transfers through the generic DMA engine
framework with the DMA slave extensions.

The driver has been tested using mmc-block and ext3fs on several SD,
SDHC and MMC+ cards. Reads and writes work fine, with read transfer
rates up to 7.5 MiB/s on fast cards with debugging disabled.

Unfortunately, the driver has been known to lock up from time to time
with DMA enabled, so DMA support is currently optional and marked
EXPERIMENTAL. However, I didn't see any problems while testing 13
different cards (MMC, SD and SDHC of different brands and sizes), so I
suspect the "Initialize BLKR before sending data transfer command" fix
that was posted earlier fixed this as well.
Signed-off-by: NHaavard Skinnemoen <haavard.skinnemoen@atmel.com>
      65e8b083
    • H
      atmel-mci: support multiple mmc slots · 965ebf33
      由 Haavard Skinnemoen 提交于 
      The Atmel MCI controller can drive multiple cards through separate sets
of pins, but only one at a time. This patch adds support for
multiplexing access to the controller so that multiple card slots can be
used as if they were hooked up to separate mmc controllers.

The atmel-mci driver registers each slot as a separate mmc_host. Both
access the same common controller state, but they also have some state
on their own for card detection/write protect handling, and separate
shadows of the MR and SDCR registers.

When one of the slots receives a request from the mmc core, the common
controller state is checked. If it's idle, the request is submitted
immediately. If not, the request is added to a queue. When a request is
done, the queue is checked and if there is a queued request, it is
submitted before the completion callback is called.

This patch also includes a few cleanups and fixes, including a locking
overhaul. I had to change the locking extensively in any case, so I
might as well try to get it right. The driver no longer takes any
irq-safe locks, which may or may not improve the overall system
performance.

This patch also adds a bit of documentation of the internal data
structures.
Signed-off-by: NHaavard Skinnemoen <haavard.skinnemoen@atmel.com>
      965ebf33
    • H
      atmel-mci: Platform code for supporting multiple mmc slots · 6b918657
      由 Haavard Skinnemoen 提交于 
      Add the necessary platform infrastructure to support multiple mmc/sdcard
slots all at once through a single controller. Currently, the driver
will use the first valid slot it finds and stick with that, but later
patches will add support for switching between several slots on the fly.

Extend the platform data structure with per-slot information: MMC/SDcard
bus width and card detect/write protect pins. This will affect the pin
muxing as well as the capabilities announced to the mmc core.

Note that board code is now required to supply a mci_platform_data
struct to at32_add_device_mci().
Signed-off-by: NHaavard Skinnemoen <haavard.skinnemoen@atmel.com>
      6b918657
    • A
      avr32: Replace static clock list with dynamic linked list · 300bb762
      由 Alex Raimondi 提交于 
      This replaces the at32_clock_list array with a linked list.
Clocks can now be registered (added) to the list.
Signed-off-by: NAlex Raimondi <raimondi@miromico.ch>
Signed-off-by: NHaavard Skinnemoen <haavard.skinnemoen@atmel.com>
      300bb762
  7. 22 9月, 2008 8 次提交
  9. 20 9月, 2008 5 次提交
  11. 01 9月, 2008 2 次提交
  13. 08 8月, 2008 7 次提交
  15. 05 8月, 2008 3 次提交
  17. 27 7月, 2008 2 次提交
  19. 26 7月, 2008 2 次提交
    • M
      gpiolib: allow user-selection · 7444a72e
      由 Michael Buesch 提交于 
      This patch adds functionality to the gpio-lib subsystem to make it
possible to enable the gpio-lib code even if the architecture code didn't
request to get it built in.

The archtitecture code does still need to implement the gpiolib accessor
functions in its asm/gpio.h file.  This patch adds the implementations for
x86 and PPC.

With these changes it is possible to run generic GPIO expansion cards on
every architecture that implements the trivial wrapper functions.  Support
for more architectures can easily be added.
Signed-off-by: NMichael Buesch <mb@bu3sch.de>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Stephen Rothwell <sfr@canb.auug.org.au>
Cc: David Brownell <david-b@pacbell.net>
Cc: Russell King <rmk@arm.linux.org.uk>
Cc: Haavard Skinnemoen <hskinnemoen@atmel.com>
Cc: Jesper Nilsson <jesper.nilsson@axis.com>
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: Paul Mackerras <paulus@samba.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Jean Delvare <khali@linux-fr.org>
Cc: Samuel Ortiz <sameo@openedhand.com>
Cc: Kumar Gala <galak@gate.crashing.org>
Cc: Sam Ravnborg <sam@ravnborg.org>
Cc: Adrian Bunk <bunk@stusta.de>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      7444a72e
    • D
      gpio: sysfs interface · d8f388d8
      由 David Brownell 提交于 
      This adds a simple sysfs interface for GPIOs.

    /sys/class/gpio
    	/export ... asks the kernel to export a GPIO to userspace
    	/unexport ... to return a GPIO to the kernel
        /gpioN ... for each exported GPIO #N
	    /value ... always readable, writes fail for input GPIOs
	    /direction ... r/w as: in, out (default low); write high, low
	/gpiochipN ... for each gpiochip; #N is its first GPIO
	    /base ... (r/o) same as N
	    /label ... (r/o) descriptive, not necessarily unique
	    /ngpio ... (r/o) number of GPIOs; numbered N .. N+(ngpio - 1)

GPIOs claimed by kernel code may be exported by its owner using a new
gpio_export() call, which should be most useful for driver debugging.
Such exports may optionally be done without a "direction" attribute.

Userspace may ask to take over a GPIO by writing to a sysfs control file,
helping to cope with incomplete board support or other "one-off"
requirements that don't merit full kernel support:

  echo 23 > /sys/class/gpio/export
	... will gpio_request(23, "sysfs") and gpio_export(23);
	use /sys/class/gpio/gpio-23/direction to (re)configure it,
	when that GPIO can be used as both input and output.
  echo 23 > /sys/class/gpio/unexport
	... will gpio_free(23), when it was exported as above

The extra D-space footprint is a few hundred bytes, except for the sysfs
resources associated with each exported GPIO.  The additional I-space
footprint is about two thirds of the current size of gpiolib (!).  Since
no /dev node creation is involved, no "udev" support is needed.

Related changes:

  * This adds a device pointer to "struct gpio_chip".  When GPIO
    providers initialize that, sysfs gpio class devices become children of
    that device instead of being "virtual" devices.

  * The (few) gpio_chip providers which have such a device node have
    been updated.

  * Some gpio_chip drivers also needed to update their module "owner"
    field ...  for which missing kerneldoc was added.

  * Some gpio_chips don't support input GPIOs.  Those GPIOs are now
    flagged appropriately when the chip is registered.

Based on previous patches, and discussion both on and off LKML.

A Documentation/ABI/testing/sysfs-gpio update is ready to submit once this
merges to mainline.

[akpm@linux-foundation.org: a few maintenance build fixes]
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Cc: Guennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Cc: Greg KH <greg@kroah.com>
Cc: Kay Sievers <kay.sievers@vrfy.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      d8f388d8
  21. 25 7月, 2008 4 次提交