This patch reworks the s390 clock comparator wakeup to hrtimer. The clock
comparator is a per-cpu value that is compared against the TOD clock. If
ckc <= TOD an external interrupt 1004 is triggered. Since the clock comparator
and the TOD clock have a much higher resolution than jiffies we should use
hrtimers to trigger the wakeup. This speeds up guest nanosleep for small
values.

Since hrtimers callbacks run in hard-irq context, I added a tasklet to do
the actual work with enabled interrupts.
Signed-off-by: NChristian Borntraeger <borntraeger@de.ibm.com>
Signed-off-by: NCarsten Otte <cotte@de.ibm.com>
Signed-off-by: NChristian Ehrhardt <ehrhardt@de.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

This patch fixes an incorrectness in the kvm backend for s390.
In case virtual cpus are being created before the corresponding
memory slot is being registered, we need to update the sie
control blocks for the virtual cpus.

*updates in v3*
In consideration of the s390 memslot constraints locking was changed
to trylock. These locks should never be held, as vcpu's can't run without
the single memslot we just assign when running this code. To ensure this
never deadlocks in case other code changes the code uses trylocks and bail
out if it can't get all locks.

Additionally most of the discussed special conditions for s390 like
only one memslot and no user_alloc are now checked for validity in
kvm_arch_set_memory_region.
Reported-by: NMijo Safradin <mijo@linux.vnet.ibm.com>
Signed-off-by: NCarsten Otte <cotte@de.ibm.com>
Signed-off-by: NChristian Ehrhardt <ehrhardt@de.ibm.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Signed-off-by: NRobert P. J. Day <rpjday@crashcourse.ca>
Cc: Avi Kivity <avi@redhat.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Verify the cr3 address stored in vcpu->arch.cr3 points to an existant
memslot. If not, inject a triple fault.
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

kvm_handle_hva relies on mmu_lock protection to safely access
the memslot structures.
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

kvm_handle_hva, called by MMU notifiers, manipulates mmu data only with
the protection of mmu_lock.

Update kvm_mmu_change_mmu_pages callers to take mmu_lock, thus protecting
against kvm_handle_hva.
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

We currently unblock shadow interrupt state when we skip an instruction,
but failing to do so when we actually emulate one. This blocks interrupts
in key instruction blocks, in particular sti; hlt; sequences

If the instruction emulated is an sti, we have to block shadow interrupts.
The same goes for mov ss. pop ss also needs it, but we don't currently
emulate it.

Without this patch, I cannot boot gpxe option roms at vmx machines.
This is described at https://bugzilla.redhat.com/show_bug.cgi?id=494469Signed-off-by: NGlauber Costa <glommer@redhat.com>
CC: H. Peter Anvin <hpa@zytor.com>
CC: Gleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

This patch replaces drop_interrupt_shadow with the more
general set_interrupt_shadow, that can either drop or raise
it, depending on its parameter.  It also adds ->get_interrupt_shadow()
for future use.
Signed-off-by: NGlauber Costa <glommer@redhat.com>
CC: H. Peter Anvin <hpa@zytor.com>
CC: Gleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

kvm_assigned_dev_ack_irq is vulnerable to a race condition with the
interrupt handler function. It does:

        if (dev->host_irq_disabled) {
                enable_irq(dev->host_irq);
                dev->host_irq_disabled = false;
        }

If an interrupt triggers before the host->dev_irq_disabled assignment,
it will disable the interrupt and set dev->host_irq_disabled to true.

On return to kvm_assigned_dev_ack_irq, dev->host_irq_disabled is set to
false, and the next kvm_assigned_dev_ack_irq call will fail to reenable
it.

Other than that, having the interrupt handler and work handlers run in
parallel sounds like asking for trouble (could not spot any obvious
problem, but better not have to, its fragile).

CC: sheng.yang@intel.com
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

KVM uses a function call IPI to cause the exit of a guest running on a
physical cpu. For virtual interrupt notification there is no need to
wait on IPI receival, or to execute any function.

This is exactly what the reschedule IPI does, without the overhead
of function IPI. So use it instead of smp_call_function_single in
kvm_vcpu_kick.

Also change the "guest_mode" variable to a bit in vcpu->requests, and
use that to collapse multiple IPI's that would be issued between the
first one and zeroing of guest mode.

This allows kvm_vcpu_kick to called with interrupts disabled.
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Signed-off-by: NAvi Kivity <avi@redhat.com>

Add cpu feature bit support for the MOVBE and POPCNT instructions.
Signed-off-by: NAvi Kivity <avi@redhat.com>

Signed-off-by: NAvi Kivity <avi@redhat.com>

MTRR, PAT, MCE, and MCA are all supported (to some extent) but not reported.
Vista requires these features, so if userspace relies on kernel cpuid
reporting, it loses support for Vista.
Signed-off-by: NAvi Kivity <avi@redhat.com>

The stats entry request_nmi is no longer used as the related user space
interface was dropped. So clean it up.
Signed-off-by: NJan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

If a task switch caused by an event remove it from the event queue.
VMX already does that.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

On AMD CPUs sometimes the DB bit in the stack segment
descriptor is left as 1, although the whole segment has
been made unusable. Clear it here to pass an Intel VMX
entry check when cross vendor migrating.
Signed-off-by: NAndre Przywara <andre.przywara@amd.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Apparently nobody turned this on in a while...
setting apic_debug to something compilable, generates
some errors. This patch fixes it.
Signed-off-by: NGlauber Costa <glommer@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Remove extra tab.
Signed-off-by: NChris Wright <chrisw@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Intel TXT(Trusted Execution Technology) required VMX off for all cpu to work
when system shutdown.

CC: Joseph Cihula <joseph.cihula@intel.com>
Signed-off-by: NSheng Yang <sheng@linux.intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Memory aliases with different memory type is a problem for guest. For the guest
without assigned device, the memory type of guest memory would always been the
same as host(WB); but for the assigned device, some part of memory may be used
as DMA and then set to uncacheable memory type(UC/WC), which would be a conflict of
host memory type then be a potential issue.

Snooping control can guarantee the cache correctness of memory go through the
DMA engine of VT-d.

[avi: fix build on ia64]
Signed-off-by: NSheng Yang <sheng@linux.intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Shadow_mt_mask is out of date, now it have only been used as a flag to indicate
if TDP enabled. Get rid of it and use tdp_enabled instead.

Also put memory type logical in kvm_x86_ops->get_mt_mask().
Signed-off-by: NSheng Yang <sheng@linux.intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

This moves the get_cpu() call down to be called after we wake up the
waiters. Therefore the waitqueue locks can safely be rt mutex.
Signed-off-by: NJan Blunck <jblunck@suse.de>
Signed-off-by: NSven-Thorsten Dietrich <sven@thebigcorporation.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

It just returns pending IRQ vector from the queue for VMX/SVM.
Get IRQ directly from the queue before migration and put it back
after.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Re-put pending IRQ vector into interrupt_bitmap before migration.
Otherwise it will be lost if migration happens in the wrong time.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

They are recalculated before each use anyway.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Saves many exits to userspace in a case of IRQ chip in userspace.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Even if IRQ chip is in userspace.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

No longer used.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

It is the same as inject_pending_irq() for VMX/SVM now.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

It always return false for VMX/SVM now.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Start to use interrupt/exception queues like VMX does.
This also fix the bug that if exit was caused by a guest
internal exception access to IDT the exception was not
reinjected.

Use EVENTINJ to inject interrupts.  Use VINT only for detecting when IRQ
windows is open again.  EVENTINJ ensures
the interrupt is injected immediately and not delayed.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

kvm_arch_interrupt_allowed() also checks IF so drop the check.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Use the same callback to inject irq/nmi events no matter what irqchip is
in use. Only from VMX for now.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

At the vector level, kernel and userspace irqchip are fairly similar.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Fix build breakage of hpa lookup in audit_mappings_page. Moreover, make
this function robust against shadow_notrap_nonpresent_pte entries.
Signed-off-by: NJan Kiszka <jan.kiszka@siemens.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Restore local irq enabled state before calling kvm_arch_vcpu_init(),
which calls kmalloc(GFP_KERNEL).
Signed-off-by: NJes Sorensen <jes@sgi.com>
Acked-by: NXiantao Zhang <xiantao.zhang@intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

Preserve interrupt status around call to kvm_insert_vmm_mappin()
in kvm_vcpu_pre_transition().
Signed-off-by: NJes Sorensen <jes@sgi.com>
Acked-by: NXiantao Zhang <xiantao.zhang@intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>