Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

1. make 32bit have early_init_amd_mc and amd_detect_cmp
2. seperate init_amd_k5/k6/k7 ...

v2: fix compiling for !CONFIG_SMP
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

so we:

 1. could set some cap to ap
 2. restore some cap after memset in identify_cpu for boot cpu

esp for CONSTANT_TSC this matters, as:

before this patch:
 flags           : fpu vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov pat pse36 clflush mmx fxsr sse sse2 ht syscall nx mmxext fxsr_opt pdpe1gb rdtscp lm 3dnowext 3dnow rep_good nopl pni monitor cx16 lahf_lm cmp_legacy svm extapic cr8_legacy abm sse4a misalignsse 3dnowprefetch osvw ibs

after this patch:
 flags           : fpu vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov pat pse36 clflush mmx fxsr sse sse2 ht syscall nx mmxext fxsr_opt pdpe1gb rdtscp lm 3dnowext 3dnow constant_tsc rep_good nopl pni monitor cx16 lahf_lm cmp_legacy svm extapic cr8_legacy abm sse4a misalignsse 3dnowprefetch osvw ibs

so constant_tsc is back...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

1. add c_x86_vendor into cpu_dev
2. change cpu_devs to static
3. check c_x86_vendor before put that cpu_dev into array
4. remove alignment for 64bit
5. order the sequence in cpu_devs according to link sequence...
   so could put intel at first, then amd...
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

AMD only supports "syscall" from 32-bit compat usermode.
Intel and Centaur(?) only support "sysenter" from 32-bit compat usermode.

Set the X86 feature bits accordingly, and set up the vdso in
accordance with those bits.  On the offchance we run on in a 64-bit
environment which supports neither syscall nor sysenter from 32-bit
mode, then fall back to the int $0x80 vdso.
Signed-off-by: NJeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>

tighten the boundary checks around max_low_pfn_mapped - dont overmap
nor undermap into holes.

also print out tseg for AMD cpus, for diagnostic purposes.
(this is an SMM area, and we split up any big mappings around that area)
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Cc: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

when more than 4g memory is installed, don't map the big hole below 4g.
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Cc: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

1. move out calling of check_enable_amd_mmconf_dmi out of setup_64.c
   put it into init_amd(), so don't need to make extra dmi check for
   system with other cpus.
2. 15 --> 0xf
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

we may need to move some functions to common.c later
Signed-off-by: NYinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

"Form follows function". Code is now where it belongs to.
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

C1E on AMD machines is like C3 but without control from the OS. Up to
now we disabled the local apic timer for those machines as it stops
when the CPU goes into C1E. This excludes those machines from high
resolution timers / dynamic ticks, which hurts especially X2 based
laptops.

The current boot time C1E detection has another, more serious flaw
as well: some BIOSes do not enable C1E until the ACPI processor module
is loaded. This causes systems to stop working after that point.

To work nicely with C1E enabled machines we use a separate idle
function, which checks on idle entry whether C1E was enabled in the
Interrupt Pending Message MSR. This allows us to do timer broadcasting
for C1E and covers the late enablement of C1E as well.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Simplify code: no need to do a cpuid(1) again. The cpuinfo structure
has all necessary information already.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Rename the "MSR_K8_ENABLE_C1E" MSR to INT_PENDING_MSG, which is the
name in the data sheet as well. Move the C1E mask to the header file.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Also much less code now.
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

This patch implements PCI extended configuration space access for
AMD's Barcelona CPUs. It extends the method using CF8/CFC IO
addresses. An x86 capability bit has been introduced that is set for
CPUs supporting PCI extended config space accesses.
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>

Clean up an overlong line in arch/x86/kernel/cpu/amd_64.c.
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>

Create a separate amd_64.c file in the cpu/ dir for
the useful parts to live in.
Signed-off-by: NDave Jones <davej@redhat.com>
Signed-off-by: NH. Peter Anvin <hpa@zytor.com>