Some of fb drivers uses atomic_t in bad manner, since there are still some
race-prone gaps.  Use mutexes to protect open/close code sections with
ref_count testing and finally use simple uint.
Signed-off-by: NJiri Slaby <jirislaby@gmail.com>
Acked-by: NDenis Oliver Kropp <dok@directfb.org>
Cc: James Simmons <jsimmons@infradead.org>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Some time before 2.6.15, a third DDC channel was added to i810fb.  On
systems where these ddc pins are not connected, the probe takes about 10
seconds.

Add a boot/module option for i810fb to explicitly probe for the 3rd ddc bus
if needed.
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

- The functions for reading the 1st and 2nd bus are essentially the same,
  except for the register.  Consolidate them all.

- According to Nicolas Boichat, there is an undocumented 3rd i2c bus for
  attaching daughter cards.  Add support for this.
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Add ddc/i2c support for i810fb.  This will allow the driver to get display
information, especially for monitors with fickle timings.  The i2c support
depends on CONFIG_FB_I810_GTF.

Changed __init* to __devinit*
Signed-off-by: NAntonino Daplas <adaplas@pol.net>
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch removes drivers that have hardware cursors from calling the
software cursor code.  Also if the driver sets a no hardware cursor flag
then the driver reports a error it someone attempts to use the cursor.
Signed-off-by: NJames Simmons <jsimmons@infradead.org>
Cc: "Antonino A. Daplas" <adaplas@pol.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!