提交 · bb436b20fe0ea4231a233aae7f0f7de3a3f2f5c3 · openeuler / raspberrypi-kernel

22 11月, 2009 8 次提交

e1000e: disable K1 on PCH LOM when in PHY loopback mode · bb436b20

由 Bruce Allan 提交于 11月 20, 2009

When performing the ethtool PHY loopback test on PCH-based LOMs (82577 and
82578), disable K1 (a MAC-PHY interconnect low power mode) otherwise
packets might get corrupted.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

bb436b20

e1000e: improper return code signage · 98086a95

由 Bruce Allan 提交于 11月 20, 2009

The e1000_get_cable_length_82577() should return a negative value upon
error.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

98086a95

e1000e: link reporting problems · 7ea9655f

由 Bruce Allan 提交于 11月 20, 2009

Copper links with WoL or management enabled (any condition which prevents
the phy from being powered down when the interface is taken down) were
always reporting link-up when the interface had been taken down. This
is because when the interface is taken down (ifconfig ethx down),
interrupts are disabled. With no interrupts, there is no LSC interrupt,
which is normally required to set "get_link_status", which instructs the
driver to query the device for link state. The fix is to force
get_link_status to true if the interface is not up.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

7ea9655f

e1000e: don't clean Rx ring while resetting · a68ea775

由 Bruce Allan 提交于 11月 20, 2009

When using legacy interrupts, do not clean the Rx ring while resetting
otherwise traffic will not pass.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

a68ea775

e1000e: function pointers for ethtool set/get offloads · e7d906f7

由 Bruce Allan 提交于 11月 20, 2009

Provide missing function pointers for ethtool set/get offloads.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

e7d906f7

e1000e: clearing interrupt timers causes descriptors to get flushed · f4e2c6db

由 Bruce Allan 提交于 11月 20, 2009

Clearing the interrupt timers following an IMS clear has the unwanted
side-effect of flushing all descriptors immediately following a partial
write when interrupts are disabled.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

f4e2c6db

e1000e: add missing tests for 82583 in ethtool functions · f89271dd

由 Bruce Allan 提交于 11月 20, 2009

Add tests for 82583 in a couple ethtool functions that were missed from the
initial hardware enablement submission.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

f89271dd

e1000e: check WoL mode is among set of supported modes · 1fbfca32

由 Bruce Allan 提交于 11月 20, 2009

When setting WoL feature, check the supplied modes are all supported rather
than checking for no support.  This way, if any new modes are added the
driver does not default to not complaining about it if we don't really
support it.
Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

1fbfca32

21 11月, 2009 6 次提交

net: rename skb->iif to skb->skb_iif · 8964be4a

由 Eric Dumazet 提交于 11月 20, 2009

To help grep games, rename iif to skb_iif
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

8964be4a

be2net: Patch to flash redboot section while firmware update. · fa9a6fed

由 Sarveshwar Bandi 提交于 11月 20, 2009

Please apply patch to update redboot section while firmware update. Code
checks if section needs to be updated before actually doing it.
Signed-off-by: NSarveshwar Bandi <sarveshwarb@serverengines.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

fa9a6fed

netxen: remove PCI IDs of CNA device · eb6d0213

由 Amit Kumar Salecha 提交于 11月 19, 2009

Remove PCI vendor and device IDs for QLE8240 and QLE8242
CNA devices. CNA devices will have separate driver.
Signed-off-by: NAmit Kumar Salecha <amit.salecha@qlogic.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

eb6d0213

igb: Add full support for 82580 devices · 55cac248

由 Alexander Duyck 提交于 11月 19, 2009

This patch makes use of the 82580 PHY and MAC support added and adds a set
of supported device IDs for said hardware.
Signed-off-by: NAlexander Duyck <alexander.h.duyck@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

55cac248

igb: add support for 82580 MAC · bb2ac47b

由 Alexander Duyck 提交于 11月 19, 2009

This patch adds support for the 82580 MAC.
Signed-off-by: NAlexander Duyck <alexander.h.duyck@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

bb2ac47b

igb: add support for the 82580 phy · 2909c3f7

由 Alexander Duyck 提交于 11月 19, 2009

This patch adds support for the phy included in the 82580 silicon family.
Signed-off-by: NAlexander Duyck <alexander.h.duyck@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

2909c3f7

20 11月, 2009 2 次提交

drivers/net: tasklet_init - Remove unnecessary leading & from second arg · 164165da

由 Joe Perches 提交于 11月 19, 2009

Changed function pointer use from non-majority address-of style
to majority short form without & via: (was: 8 with &, 36 without)

grep -rPl "\btasklet_init\s*\([^,\)]+,\s*\&" drivers/net | while read file ; do \
	perl -i -e 'local $/; while (<>) { s@(\btasklet_init\s*\([^,\)]+,\s*)\&@\1@g ; print ; }' $file ;\
done

Compile tested allyesconfig x86
Signed-off-by: NJoe Perches <joe@perches.com>

 drivers/net/cnic.c |    4 ++--
 drivers/net/jme.c  |   10 +++++-----
 drivers/net/skge.c |    2 +-
 3 files changed, 8 insertions(+), 8 deletions(-)
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

164165da

drivers/isdn/gigaset: tasklet_init - Remove unnecessary leading & from second arg · 5452fee2

由 Joe Perches 提交于 11月 19, 2009

Changed function pointer use from non-majority address-of style
to majority short form without & via:

grep -rPl "\btasklet_init\s*\([^,\)]+,\s*\&" drivers/isdn | while read file ; do \
        perl -i -e 'local $/; while (<>) { s@(\btasklet_init\s*\([^,\)]+,\s*)\&@\1@g ; print ; }' $file ;\
done

Compile tested allyesconfig x86
Signed-off-by: NJoe Perches <joe@perches.com>

 drivers/isdn/gigaset/bas-gigaset.c |    4 ++--
 drivers/isdn/gigaset/common.c      |    2 +-
 drivers/isdn/gigaset/interface.c   |    2 +-
 drivers/isdn/gigaset/ser-gigaset.c |    2 +-
 drivers/isdn/gigaset/usb-gigaset.c |    2 +-
 5 files changed, 6 insertions(+), 6 deletions(-)
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

5452fee2

19 11月, 2009 19 次提交

iwmc3200top: revamp fw name handling · 0e481747

由 Tomas Winkler 提交于 11月 18, 2009

1. define macro for handling firmware api version
2. add MODULE_FIRMWARE
3. cleanup iwmct_fw_load style
Signed-off-by: NTomas Winkler <tomas.winkler@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

0e481747

drivers/net: request_irq - Remove unnecessary leading & from second arg · a0607fd3

由 Joe Perches 提交于 11月 18, 2009

Not as fancy as coccinelle.  Checkpatch errors ignored.
Compile tested allyesconfig x86, not all files compiled.

grep -rPl --include=*.[ch] "\brequest_irq\s*\([^,\)]+,\s*\&" drivers/net | while read file ; do \
	perl -i -e 'local $/; while (<>) { s@(\brequest_irq\s*\([^,\)]+,\s*)\&@\1@g ; print ; }' $file ;\
done
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

a0607fd3

agp/intel-agp: Set dma_mask for capable chipsets before agp_add_bridge() · ec402ba9

由 David Woodhouse 提交于 11月 18, 2009

We should set this before calling agp_add_bridge() so that it's done
before we map the scratch page too.

This should probably fix the regression reported as k.o. bug #14627.
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

ec402ba9

drivers/net/wireless/rtl818x: remove exceptional & on function name · ea31ba35