Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 22 6月, 2011 1 次提交
    • A
      net: remove mm.h inclusion from netdevice.h · b7f080cf
      由 Alexey Dobriyan 提交于 
      Remove linux/mm.h inclusion from netdevice.h -- it's unused (I've checked manually).

To prevent mm.h inclusion via other channels also extract "enum dma_data_direction"
definition into separate header. This tiny piece is what gluing netdevice.h with mm.h
via "netdevice.h => dmaengine.h => dma-mapping.h => scatterlist.h => mm.h".
Removal of mm.h from scatterlist.h was tried and was found not feasible
on most archs, so the link was cutoff earlier.

Hope people are OK with tiny include file.

Note, that mm_types.h is still dragged in, but it is a separate story.
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      b7f080cf
  3. 15 6月, 2011 8 次提交
  5. 02 6月, 2011 1 次提交
  7. 19 5月, 2011 1 次提交
  9. 06 5月, 2011 3 次提交
  11. 13 4月, 2011 1 次提交
    • M
      net: bnx2x: convert to hw_features · 66371c44
      由 Michał Mirosław 提交于 
      Since ndo_fix_features callback is postponing features change when
bp->recovery_state != BNX2X_RECOVERY_DONE, netdev_update_features()
has to be called again when this condition changes. Previously,
ethtool_ops->set_flags callback returned -EBUSY in that case
(it's not possible in the new model).
Signed-off-by: NMichał Mirosław <mirq-linux@rere.qmqm.pl>

v5: - don't delay set_features, as it's rtnl_locked - same as recovery process
v4: - complete bp->rx_csum -> NETIF_F_RXCSUM conversion
    - add check for failed ndo_set_features in ndo_open callback
v3: - include NETIF_F_LRO in hw_features
    - don't call netdev_update_features() if bnx2x_nic_load() failed
v2: - comment in ndo_fix_features callback
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      66371c44
  13. 31 3月, 2011 1 次提交
  15. 07 3月, 2011 2 次提交
  17. 01 3月, 2011 3 次提交
  19. 18 2月, 2011 1 次提交
  21. 07 2月, 2011 2 次提交
  23. 01 2月, 2011 2 次提交
  25. 31 1月, 2011 1 次提交
  27. 28 1月, 2011 1 次提交
  29. 19 1月, 2011 1 次提交
  31. 10 1月, 2011 1 次提交
  33. 01 1月, 2011 1 次提交
  35. 17 12月, 2010 3 次提交
  37. 13 12月, 2010 1 次提交
  39. 10 12月, 2010 2 次提交
  41. 02 12月, 2010 1 次提交
    • D
      bnx2x: Add Nic partitioning mode (57712 devices) · 0793f83f
      由 Dmitry Kravkov 提交于 
      NIC partitioning is another flavor of multi function - having few
PCI functions share the same physical port. Unlike the currently
supported mode of multi-function which depends on the switch
configuration and uses outer-VLAN, the NPAR mode is switch independent
and uses the MAC addresses to distribute incoming packets to the different
functions. This patch adds the specific HW setting of the NPAR mode
and some distinctions between switch dependent (SD) and
switch independent (SI) multi-function (MF) modes where the configuration
is not the same.

Advance driver version to 1.60.00-6
Signed-off-by: NDmitry Kravkov <dmitry@broadcom.com>
Signed-off-by: NEilon Greenstein <eilong@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      0793f83f
  43. 25 11月, 2010 1 次提交
  45. 01 11月, 2010 1 次提交