Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 16 9月, 2015 2 次提交
  3. 30 8月, 2015 1 次提交
  5. 29 8月, 2015 1 次提交
  7. 21 8月, 2015 1 次提交
  9. 18 8月, 2015 1 次提交
  11. 14 8月, 2015 2 次提交
  13. 04 8月, 2015 1 次提交
  15. 27 7月, 2015 1 次提交
  17. 25 7月, 2015 1 次提交
    • J
      ipv4: consider TOS in fib_select_default · 2392debc
      由 Julian Anastasov 提交于 
      fib_select_default considers alternative routes only when
res->fi is for the first alias in res->fa_head. In the
common case this can happen only when the initial lookup
matches the first alias with highest TOS value. This
prevents the alternative routes to require specific TOS.

This patch solves the problem as follows:

- routes that require specific TOS should be returned by
fib_select_default only when TOS matches, as already done
in fib_table_lookup. This rule implies that depending on the
TOS we can have many different lists of alternative gateways
and we have to keep the last used gateway (fa_default) in first
alias for the TOS instead of using single tb_default value.

- as the aliases are ordered by many keys (TOS desc,
fib_priority asc), we restrict the possible results to
routes with matching TOS and lowest metric (fib_priority)
and routes that match any TOS, again with lowest metric.

For example, packet with TOS 8 can not use gw3 (not lowest
metric), gw4 (different TOS) and gw6 (not lowest metric),
all other gateways can be used:

tos 8 via gw1 metric 2 <--- res->fa_head and res->fi
tos 8 via gw2 metric 2
tos 8 via gw3 metric 3
tos 4 via gw4
tos 0 via gw5
tos 0 via gw6 metric 1
Reported-by: NHagen Paul Pfeifer <hagen@jauu.net>
Signed-off-by: NJulian Anastasov <ja@ssi.bg>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      2392debc
  19. 22 7月, 2015 5 次提交
  21. 10 7月, 2015 1 次提交
  23. 24 6月, 2015 1 次提交
    • A
      net: ipv4 sysctl option to ignore routes when nexthop link is down · 0eeb075f
      由 Andy Gospodarek 提交于 
      This feature is only enabled with the new per-interface or ipv4 global
sysctls called 'ignore_routes_with_linkdown'.

net.ipv4.conf.all.ignore_routes_with_linkdown = 0
net.ipv4.conf.default.ignore_routes_with_linkdown = 0
net.ipv4.conf.lo.ignore_routes_with_linkdown = 0
...

When the above sysctls are set, will report to userspace that a route is
dead and will no longer resolve to this nexthop when performing a fib
lookup.  This will signal to userspace that the route will not be
selected.  The signalling of a RTNH_F_DEAD is only passed to userspace
if the sysctl is enabled and link is down.  This was done as without it
the netlink listeners would have no idea whether or not a nexthop would
be selected.   The kernel only sets RTNH_F_DEAD internally if the
interface has IFF_UP cleared.

With the new sysctl set, the following behavior can be observed
(interface p8p1 is link-down):

default via 10.0.5.2 dev p9p1
10.0.5.0/24 dev p9p1  proto kernel  scope link  src 10.0.5.15
70.0.0.0/24 dev p7p1  proto kernel  scope link  src 70.0.0.1
80.0.0.0/24 dev p8p1  proto kernel  scope link  src 80.0.0.1 dead linkdown
90.0.0.0/24 via 80.0.0.2 dev p8p1  metric 1 dead linkdown
90.0.0.0/24 via 70.0.0.2 dev p7p1  metric 2
90.0.0.1 via 70.0.0.2 dev p7p1  src 70.0.0.1
    cache
local 80.0.0.1 dev lo  src 80.0.0.1
    cache <local>
80.0.0.2 via 10.0.5.2 dev p9p1  src 10.0.5.15
    cache

While the route does remain in the table (so it can be modified if
needed rather than being wiped away as it would be if IFF_UP was
cleared), the proper next-hop is chosen automatically when the link is
down.  Now interface p8p1 is linked-up:

default via 10.0.5.2 dev p9p1
10.0.5.0/24 dev p9p1  proto kernel  scope link  src 10.0.5.15
70.0.0.0/24 dev p7p1  proto kernel  scope link  src 70.0.0.1
80.0.0.0/24 dev p8p1  proto kernel  scope link  src 80.0.0.1
90.0.0.0/24 via 80.0.0.2 dev p8p1  metric 1
90.0.0.0/24 via 70.0.0.2 dev p7p1  metric 2
192.168.56.0/24 dev p2p1  proto kernel  scope link  src 192.168.56.2
90.0.0.1 via 80.0.0.2 dev p8p1  src 80.0.0.1
    cache
local 80.0.0.1 dev lo  src 80.0.0.1
    cache <local>
80.0.0.2 dev p8p1  src 80.0.0.1
    cache

and the output changes to what one would expect.

If the sysctl is not set, the following output would be expected when
p8p1 is down:

default via 10.0.5.2 dev p9p1
10.0.5.0/24 dev p9p1  proto kernel  scope link  src 10.0.5.15
70.0.0.0/24 dev p7p1  proto kernel  scope link  src 70.0.0.1
80.0.0.0/24 dev p8p1  proto kernel  scope link  src 80.0.0.1 linkdown
90.0.0.0/24 via 80.0.0.2 dev p8p1  metric 1 linkdown
90.0.0.0/24 via 70.0.0.2 dev p7p1  metric 2

Since the dead flag does not appear, there should be no expectation that
the kernel would skip using this route due to link being down.

v2: Split kernel changes into 2 patches, this actually makes a
behavioral change if the sysctl is set.  Also took suggestion from Alex
to simplify code by only checking sysctl during fib lookup and
suggestion from Scott to add a per-interface sysctl.

v3: Code clean-ups to make it more readable and efficient as well as a
reverse path check fix.

v4: Drop binary sysctl

v5: Whitespace fixups from Dave

v6: Style changes from Dave and checkpatch suggestions

v7: One more checkpatch fixup
Signed-off-by: NAndy Gospodarek <gospo@cumulusnetworks.com>
Signed-off-by: NDinesh Dutt <ddutt@cumulusnetworks.com>
Acked-by: NScott Feldman <sfeldma@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      0eeb075f
  25. 23 5月, 2015 1 次提交
  27. 04 5月, 2015 1 次提交
    • A
      net: ipv4: route: Fix sending IGMP messages with link address · 6a211654
      由 Andrew Lunn 提交于 
      In setups with a global scope address on an interface, and a lesser
scope address on an interface sending IGMP reports, the reports can be
sent using the other interfaces global scope address rather than the
local interface address. RFC 2236 suggests:

     Ignore the Report if you cannot identify the source address of
     the packet as belonging to a subnet assigned to the interface on
     which the packet was received.

since such reports could be forged.

Look at the protocol when deciding if a RT_SCOPE_LINK address should
be used for the packet.
Signed-off-by: NAndrew Lunn <andrew@lunn.ch>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      6a211654
  29. 02 5月, 2015 1 次提交
  31. 30 4月, 2015 1 次提交
  33. 04 4月, 2015 2 次提交
  35. 01 4月, 2015 2 次提交
  37. 26 3月, 2015 1 次提交
  39. 10 3月, 2015 1 次提交
  41. 30 1月, 2015 1 次提交
  43. 27 1月, 2015 1 次提交
  45. 19 1月, 2015 1 次提交
  47. 18 1月, 2015 1 次提交
    • J
      netlink: make nlmsg_end() and genlmsg_end() void · 053c095a
      由 Johannes Berg 提交于 
      Contrary to common expectations for an "int" return, these functions
return only a positive value -- if used correctly they cannot even
return 0 because the message header will necessarily be in the skb.

This makes the very common pattern of

  if (genlmsg_end(...) < 0) { ... }

be a whole bunch of dead code. Many places also simply do

  return nlmsg_end(...);

and the caller is expected to deal with it.

This also commonly (at least for me) causes errors, because it is very
common to write

  if (my_function(...))
    /* error condition */

and if my_function() does "return nlmsg_end()" this is of course wrong.

Additionally, there's not a single place in the kernel that actually
needs the message length returned, and if anyone needs it later then
it'll be very easy to just use skb->len there.

Remove this, and make the functions void. This removes a bunch of dead
code as described above. The patch adds lines because I did

-	return nlmsg_end(...);
+	nlmsg_end(...);
+	return 0;

I could have preserved all the function's return values by returning
skb->len, but instead I've audited all the places calling the affected
functions and found that none cared. A few places actually compared
the return value with <= 0 in dump functionality, but that could just
be changed to < 0 with no change in behaviour, so I opted for the more
efficient version.

One instance of the error I've made numerous times now is also present
in net/phonet/pn_netlink.c in the route_dumpit() function - it didn't
check for <0 or <=0 and thus broke out of the loop every single time.
I've preserved this since it will (I think) have caused the messages to
userspace to be formatted differently with just a single message for
every SKB returned to userspace. It's possible that this isn't needed
for the tools that actually use this, but I don't even know what they
are so couldn't test that changing this behaviour would be acceptable.
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      053c095a
  49. 16 1月, 2015 1 次提交
    • E
      ipv4: per cpu uncached list · 5055c371
      由 Eric Dumazet 提交于 
      RAW sockets with hdrinc suffer from contention on rt_uncached_lock
spinlock.

One solution is to use percpu lists, since most routes are destroyed
by the cpu that created them.

It is unclear why we even have to put these routes in uncached_list,
as all outgoing packets should be freed when a device is dismantled.
Signed-off-by: NEric Dumazet <edumazet@google.com>
Fixes: caacf05e ("ipv4: Properly purge netdev references on uncached routes.")
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      5055c371
  51. 31 10月, 2014 1 次提交
  53. 29 9月, 2014 1 次提交
  55. 16 9月, 2014 1 次提交
  57. 06 9月, 2014 2 次提交
  59. 27 8月, 2014 1 次提交
  61. 09 8月, 2014 1 次提交