1. 06 11月, 2008 2 次提交
    • B
      powerpc/pci: Make pcibios_allocate_bus_resources more robust · b5ae5f91
      Benjamin Herrenschmidt 提交于
      To properly fix PCI hotplug, it's useful to be able to make the fixup
      passes on all devices whether they were just hot plugged or already
      there.
      
      However, pcibios_allocate_bus_resources() wouldn't cope well with
      being called twice for a given bus.  This makes it ignore resources
      that have already been allocated, along with adding a bit of debug
      output.
      Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      Signed-off-by: NPaul Mackerras <paulus@samba.org>
      b5ae5f91
    • B
      powerpc/pci: Split pcibios_fixup_bus() into bus setup and device setup · 8b8da358
      Benjamin Herrenschmidt 提交于
      Currently, our PCI code uses the pcibios_fixup_bus() callback, which
      is called by the generic code when probing PCI buses, for two
      different things.
      
      One is to set up things related to the bus itself, such as reading
      bridge resources for P2P bridges, fixing them up, or setting up the
      iommu's associated with bridges on some platforms.
      
      The other is some setup for each individual device under that bridge,
      mostly setting up DMA mappings and interrupts.
      
      The problem is that this approach doesn't work well with PCI hotplug
      when an existing bus is re-probed for new children.  We fix this
      problem by splitting pcibios_fixup_bus into two routines:
      
      	pcibios_setup_bus_self() is now called to setup the bus itself
      
      	pcibios_setup_bus_devices() is now called to setup devices
      
      pcibios_fixup_bus() is then modified to call these two after reading the
      bridge bases, and the OF based PCI probe is modified to avoid calling
      into the first one when rescanning an existing bridge.
      
      [paulus@samba.org - fixed eeh.h for 32-bit compile now that pci-common.c
      is including it unconditionally.]
      Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      Signed-off-by: NPaul Mackerras <paulus@samba.org>
      8b8da358
  2. 05 11月, 2008 4 次提交
  3. 31 10月, 2008 1 次提交
  4. 22 10月, 2008 1 次提交
  5. 21 10月, 2008 1 次提交
  6. 15 10月, 2008 1 次提交
    • B
      powerpc/pci: Improve detection of unassigned bridge resources · b5561511
      Benjamin Herrenschmidt 提交于
      When the powerpc PCI layer is not configured to re-assign everything,
      it currently fails to detect that a PCI to PCI bridge has been left
      unassigned by the firmware and tries to allocate resource for the
      default window values in the bridge (0...X) (with the notable exception
      of a hack we have in there that detects some Apple firmware unassigned
      bridge resources).
      
      This results in resource allocation failures, which are generally
      fixed up later on but it causes scary warnings in the logs and we
      have seen the fixup code fall over in some circumstances (a different
      issue to fix as well).
      
      This code improves that by providing a more complete & useful function
      to intuit that a bridge was left unassigned by the firmware, and thus
      force a full re-allocation by the PCI code without trying to allocate
      the existing useless resources first.
      
      The algorithm we use basically considers unassigned a window that
      starts at 0 (PCI address) if the corresponding address space enable
      bit is not set. In addition, for memory space, it considers such a
      resource unassigned also if the host bridge isn't configured to
      forward cycles to address 0 (ie, the resource basically overlaps
      main memory).
      
      This fixes a range of problems with things like Bare-Metal support
      on pSeries machines, or attempt to use partial firmware PCI setup.
      Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      b5561511
  7. 07 10月, 2008 1 次提交
  8. 25 9月, 2008 1 次提交
    • B
      powerpc: Merge 32 and 64-bit dma code · 4fc665b8
      Becky Bruce 提交于
      We essentially adopt the 64-bit dma code, with some changes to support
      32-bit systems, including HIGHMEM.  dma functions on 32-bit are now
      invoked via accessor functions which call the correct op for a device based
      on archdata dma_ops.  If there is no archdata dma_ops, this defaults
      to dma_direct_ops.
      
      In addition, the dma_map/unmap_page functions are added to dma_ops
      because we can't just fall back on map/unmap_single when HIGHMEM is
      enabled. In the case of dma_direct_*, we stop using map/unmap_single
      and just use the page version - this saves a lot of ugly
      ifdeffing.  We leave map/unmap_single in the dma_ops definition,
      though, because they are needed by the iommu code, which does not
      implement map/unmap_page.  Ideally, going forward, we will completely
      eliminate map/unmap_single and just have map/unmap_page, if it's
      workable for 64-bit.
      Signed-off-by: NBecky Bruce <becky.bruce@freescale.com>
      Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
      4fc665b8
  9. 11 8月, 2008 1 次提交
  10. 22 7月, 2008 1 次提交
  11. 21 4月, 2008 1 次提交
  12. 13 3月, 2008 1 次提交
  13. 24 1月, 2008 2 次提交
  14. 31 12月, 2007 1 次提交
  15. 20 12月, 2007 10 次提交
  16. 11 12月, 2007 5 次提交
  17. 03 12月, 2007 2 次提交
  18. 03 10月, 2007 1 次提交
  19. 26 7月, 2007 2 次提交
    • B
      [POWERPC] Add function to check if address is an IO port · 6dfbde20
      Benjamin Herrenschmidt 提交于
      This adds a function that tells you if a given kernel virtual address
      is hitting a PCI or ISA IO port permanent mapping or not. This is to
      be used in the next patch to fix iomap APIs to properly unmap things.
      Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      Signed-off-by: NPaul Mackerras <paulus@samba.org>
      6dfbde20
    • K
      [POWREPC] Fixup a number of modpost warnings on ppc32 · 282045b4
      Kumar Gala 提交于
      Fixed the following warnings:
      
      WARNING: vmlinux.o(.text+0x2934): Section mismatch: reference to .init.text:__alloc_bootmem (between 'irq_alloc_host' and 'irq_set_default_host')
      WARNING: vmlinux.o(.text+0xb2aa): Section mismatch: reference to .init.data:boot_command_line (between 'register_early_udbg_console' and 'udbg_printf')
      WARNING: vmlinux.o(.text+0xb2b2): Section mismatch: reference to .init.data:boot_command_line (between 'register_early_udbg_console' and 'udbg_printf')
      WARNING: vmlinux.o(.text+0xe354): Section mismatch: reference to .init.text:__alloc_bootmem (between 'pcibios_alloc_controller' and 'pci_domain_nr')
      WARNING: vmlinux.o(.text+0x12768): Section mismatch: reference to .init.text:update_bridge_resource (between 'quirk_fsl_pcie_transparent' and 'indirect_read_config')
      WARNING: vmlinux.o(.text+0x127a8): Section mismatch: reference to .init.text:update_bridge_resource (between 'quirk_fsl_pcie_transparent' and 'indirect_read_config')
      WARNING: vmlinux.o(.text+0x17566c): Section mismatch: reference to .init.text:pcibios_fixup_bus (between 'pci_scan_child_bus' and 'pci_scan_bus_parented')
      Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
      282045b4
  20. 22 7月, 2007 1 次提交