CONFIG_PTE_64BIT & CONFIG_PHYS_64BIT are not currently consistently used in
the code base.  Fixed up the usage such that CONFIG_PTE_64BIT is used when we
have a 64-bit PTE regardless of physical address width.  CONFIG_PHYS_64BIT is
used if the physical address width is larger than 32-bits, regardless of PTE
size.

These changes required a few sub-arch specific ifdef's to be fixed and the
introduction of a physical address format string.
Signed-off-by: NKumar Gala <kumar.gala@freescale.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

My previous patch that added sleep support for uninorth-agp and some AGP
"off" stuff in radeonfb and aty128fb is breaking some configs.  More
specifically, it has problems with rage128 setups since the DRI code for
these in X doesn't properly re-enable AGP on wakeup or console switch
(unlike the radeon DRM).

This patch fixes the problem for pmac once for all by using a different
approach.  The AGP driver "registers" special suspend/resume callbacks with
some arch code that the fbdev's can later on call to suspend and resume
AGP, making sure it's resumed back in the same state it was when suspended.
 This is platform specific for now.  It would be too complicated to try to
do a generic implementation of this at this point due to all sort of weird
things going on with AGP on other architectures.  We'll re-work that whole
problem cleanly once we finally merge fbdev's and DRI.

In the meantime, please apply this patch which brings back some r128 based
laptops into working condition as far as system sleep is concerned.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch updates the PowerMac cpufreq driver.  It depends on the addition
of the suspend() method (my previous patch) and on the new flag I defined
to silence some warnings that are normal for us.

It fixes various issues related to cpufreq on pmac, including some crashes
on some models when sleeping the machine while in low speed, proper voltage
control on some newer machines, and adds voltage control on 750FX based G3
laptops.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

On ppc, we emulate instructions that cause alignment exceptions.  If we are
single-stepping an instruction and it causes an alignment exception, we
will currently do the next instruction as well before taking the
single-step exception.  This patch fixes that, so we take the single-step
exception after emulating the instruction.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

If we should happen to get an altivec assist exception while executing in
the kernel, we will currently try to handle it and fail, and end up oopsing
with (apparently) a segfault.  (An altivec assist exception occurs for
floating-point altivec instructions with denormalized inputs or outputs if
the altivec unit is in java mode.)

This patch checks explicitly if we are in user mode and prints a useful
message if not.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Currently the procedure in the ppc32 kernel that synchronizes the timebase
registers across an SMP powermac system does so by setting both timebases
to zero.  That is OK at boot but causes problems if done later.  So that we
can do hotplug CPU on these machines, this patch changes the code so it
reads the timebase from one CPU and transfers the value to the other CPU. 
(Hotplug CPU is needed for sleep (aka suspend to RAM) to work.)
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch adds interrupt acknowledge to the PPC4xx PIC enable_irq
implementation for level-sensitive IRQ sources.  This helps in cases when
enable/disable_irq is used in interrupt handlers for hardware, which
requires IRQ acknowledge to be issued from non-interrupt context (e.g. 
when actual ACK in device needs an I2C transaction).  For such strange
hardware, interrupt handler disables IRQ and defers actual ACK to some
other context.  When this happens, IRQ is enabled again.  For
level-sensitive sources we get spurious triggering right after IRQ is
enabled.  This patch fixes this.

Suggested by Tolunay Orkun <listmember@orkun.us>.
Signed-off-by: NEugene Surovegin <ebs@ebshome.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The code that went into arch/ppc/kernel/signal.c recently to handle process
freezing seems to contain a dubious assumption: that a process that calls
do_signal when PF_FREEZE is set will have entered the kernel because of a
system call.  This patch removes that assumption.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!