It allows to configure codec's RESET pin gpio
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds DMIC ASRC detect function to dominate whether the DMIC ASRC
enable or not.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The ASRC source of i2s are also configurable. We add the selection
in the existing rt5677_sel_asrc_clk_src API.
Signed-off-by: NBard Liao <bardliao@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

This patch defines an API to select the clock source for specified filters.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch keeps the ldo2 power while the DSP function of "Voice Wake Up" used
in the suspend mode.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

There is only one clock source in the rt5676, so the chip type is added to
distinguish the setting of the clock source in the VAD function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch corrects the routing paths of that after IF1/2 DACx Mux
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The rt5677 codec has gained code that requires SPI to work correctly,
but there is no provision in Kconfig to prevent the driver from
being used when SPI is disabled or a loadable module, resulting
in this build error:

sound/built-in.o: In function `rt5677_spi_write':
:(.text+0xa7ba0): undefined reference to `spi_sync'
sound/built-in.o: In function `rt5677_spi_driver_init':
:(.init.text+0x253c): undefined reference to `spi_register_driver'

ERROR: "spi_sync" [sound/soc/codecs/snd-soc-rt5677-spi.ko] undefined!
ERROR: "spi_register_driver" [sound/soc/codecs/snd-soc-rt5677-spi.ko] undefined!

This makes the SPI portion of the driver depend on the SPI subsystem,
and disables the function that uses SPI for firmware download if SPI
is disabled. The latter may not be the correct solution, but I could
not come up with a better one.
Signed-off-by: NArnd Bergmann <arnd@arndb.de>
Fixes: af48f1d0 ("ASoC: rt5677: Support DSP function for VAD application")
Signed-off-by: NMark Brown <broonie@kernel.org>

The codec field of the snd_soc_widget struct is eventually going to be
removed, use snd_soc_dapm_to_codec(w->dapm) instead.
Signed-off-by: NLars-Peter Clausen <lars@metafoo.de>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add the slot_width "25" support in the TDM mode for the Intel platform.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch uses the regmap functions instead of the snd_soc functions in some
cases.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch modified the behavior that updates the PLL parameter. It set the
update bit before the PLL power up.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds the MICBIAS VDD setting in the platform data. It can be set to
1V8 or 3V3 in the MICBIAS VDD.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Remove the duplicated PLL1 connections of the adc stereo filters,
and remove the PLL1 connections of the DACs because the PLL1 should be
connected to dac filters.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add the ASRC support
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add the filter powers of the dac mono3 and mono4, and remove the connection
of dac stereo1 filter that connect to DAC1 MIX.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

snd_kcontrol_chip should return snd_soc_component instead of
snd_soc_codec
Signed-off-by: NFang, Yang A <yang.a.fang@intel.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The volume blocks have an step of 0.375dB, but TLV uses 0.01dB for
units.  Only use the resolution supported, ignoring the LSB of the
volume register.  This results in half the steps and 0.75dB per step,
but reports accurate levels through TLV.  Update the masks to reflect
that these are registers have the LSB ignored.
Signed-off-by: NDylan Reid <dgreid@chromium.org>
Signed-off-by: NMark Brown <broonie@kernel.org>

After the patch "ASoC: rt5677: Use specific r/w function for DSP mode", the
regmap_range "rt5677_ranges" was not registered in rt5677_regmap_physical, and
it caused that the regmap_range "rt5677_ranges" cannot be accessed by the
specific r/w function. The patch fixes this issue.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Set the slow charge of the vref in the end of the power sequences
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Follow the gpio naming rule to rename the irq function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Align the reg_default table with tab character
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Modify the default value of the MX-8E[4] to 1 for ASRC function. It could
prevent the pop noise with ASRC function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

It is the slot selection in DAC side of IF1 and IF2.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

In DSP mode, the register r/w should use the specific function to access
that is invoked by address mapping of the DSP.

The MX-65[1] is for switching DSP or codec mode.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Minor coding style and typo fix
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

It is for channel to slot mapping, and it is not only for 8 channels mapping,
but also in 2, 4 and 6 channels mapping. If we want to use the 2 channels in
the stereo2 adc path, we need to set the item "2/1/3/4" or "2/3/1/4".

It also adds for stereo channel swap. It can map the sterero channels "L/R"
to "R/L", "L/L" or R/R.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

sound/soc/codecs/rt5677.c:4017:5: sparse: symbol 'rt5677_irq_init' was not declared. Should it be static?
sound/soc/codecs/rt5677.c:4044:6: sparse: symbol 'rt5677_irq_exit' was not declared. Should it be static?
Signed-off-by: NFengguang Wu <fengguang.wu@intel.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

This allows to enable Mic Jack detection feature
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Modified-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The ALC5677 has a programmable DSP, and there is a SPI that is dadicated for DSP
firmware loading. Therefore, the patch includes a SPI driver for writing the DSP
firmware. The VAD(Voice Activaty Detection) has be implemented and use the DSP to
recognize the key phase.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

gpio_config is array of 6 elements that allows to set GPIO as
floating, pullup, pulldown.

Sponsored: Google ChromeOS
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Some boards have this pin statically tied and do not require any configuration,
some other boards allow to enable chip using GPIO.

Add an option that tells which GPIO is used to power the audio codec.
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add sidetone function
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds the TDM function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

gpiochip_remove() will return void eventually.
Thus this patch removes return value checking for gpiochip_remove().
Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds the GPIO function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

There are two pins can be used for rt5677's DMIC2 clock. This patch
add the select options for it.
Signed-off-by: NBard Liao <bardliao@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>