- 27 3月, 2012 1 次提交
-
-
由 Stanislaw Gruszka 提交于
This il->vif is dereferenced in different part of iwlegacy code, so do not nullify it. This should fix random crashes observed in companion with microcode errors i.e. crash in il3945_config_ap(). Additionally this should address also WARNING: at drivers/net/wireless/iwlegacy/common.c:4656 il_mac_remove_interface at least one of the possible reasons of that warning. Cc: stable@vger.kernel.org Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 13 3月, 2012 1 次提交
-
-
由 Stanislaw Gruszka 提交于
On il3945_down procedure we free tx queue data and nullify il->txq pointer. After that we drop mutex and then cancel delayed works. There is possibility, that after drooping mutex and before the cancel, some delayed work will start and crash while trying to send commands to the device. For example, here is reported crash in il3945_bg_reg_txpower_periodic(): https://bugzilla.kernel.org/show_bug.cgi?id=42766#c10 Patch fix problem by adding il->txq check on works that send commands, hence utilize tx queue. Reported-by: NClemens Eisserer <linuxhippy@gmail.com> Cc: stable@vger.kernel.org Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 23 2月, 2012 9 次提交
-
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
If rfkill is on il_grab_nic_access() fail and we can not write to the various registers during stop procedure. Write to those registers unconditionally instead. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Using ident is not always good. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
The same data can be gathered using monitor mode. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
That change will save us some CPU cycles at run time. Having port-based I/O seems to be not possible for PCIe devices. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 07 2月, 2012 14 次提交
-
-
由 Stanislaw Gruszka 提交于
It's just wrapper to sk_buff pointers ... Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 05 1月, 2012 2 次提交
-
-
由 Stanislaw Gruszka 提交于
Patch fix firmware error on "iw dev wlan0 scan passive" for hardware scanning (with disable_hw_scan=0 module parameter). iwl3945 0000:03:00.0: Microcode SW error detected. Restarting 0x82000008. iwl3945 0000:03:00.0: Loaded firmware version: 15.32.2.9 iwl3945 0000:03:00.0: Start IWL Error Log Dump: iwl3945 0000:03:00.0: Status: 0x0002A2E4, count: 1 iwl3945 0000:03:00.0: Desc Time asrtPC blink2 ilink1 nmiPC Line iwl3945 0000:03:00.0: SYSASSERT (0x5) 0041263900 0x13756 0x0031C 0x00000 764 iwl3945 0000:03:00.0: Error Reply type 0x000002FC cmd C_SCAN (0x80) seq 0x443E ser 0x00340000 iwl3945 0000:03:00.0: Command C_SCAN failed: FW Error iwl3945 0000:03:00.0: Can't stop Rx DMA. We have disable ability to change passive scanning to active on particular channel when traffic is detected on that channel. Otherwise firmware will report error, when we try to do passive scan on radar channels. Reported-and-debugged-by: NPedro Francisco <pedrogfrancisco@gmail.com> Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 15 11月, 2011 13 次提交
-
-
由 Stanislaw Gruszka 提交于
Fix most checkpatch.pl ERRORs and some WARNINGs. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Process iwlegacy source files using: indent -npro -l500 -nhnl indent -npro -kr -i8 -ts8 -sob -l80 -nbbo -ss -ncs -cp1 -il0 -psl Plus manual compilation fixes. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
On the way remove also not needed iwl-fh.h include. Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-
由 Stanislaw Gruszka 提交于
Signed-off-by: NStanislaw Gruszka <sgruszka@redhat.com>
-