Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 21 3月, 2011 5 次提交
    • M
      powerpc/ptrace: Remove BUG_ON when full register set not available · a71f5d5d
      由 Mike Wolf 提交于 
      In some cases during a threaded core dump not all the threads will have
a full register set. This happens when the signal causing the core dump
races with a thread exiting.  The race happens when the exiting thread
has entered the kernel for the last time before the signal arrives, but
doesn't get far enough through the exit code to avoid being included
in the core dump.

So we get a thread included in the core dump which is never going to go
out to userspace again and only has a partial register set recorded

Normally we would catch each thread as it is about to go into userspace
and capture the full register set then.

However, this exiting thread is never going to go out to userspace
again, so we have no way to capture its full register set.  It doesn't
really matter, though, as this is a thread which is effectively
already dead.

So instead of hitting a BUG() in this case (a really bad choice of
action in the first place), we use a poison value for the register
values.

[BenH]: Some cosmetic/stylistic changes and fix build on ppc32
Signed-off-by: NMike Wolf <mjw@linux.vnet.ibm.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      a71f5d5d
    • M
      powerpc: Factoring mpic cpu id fetching into a function · d6a2639b
      由 Meador Inge 提交于 
      The following code snippet:

	unsigned int cpu = 0;
	if (mpic->flags & MPIC_PRIMARY)
		cpu = hard_smp_processor_id();

is seen in several places in the 'mpic.c' code.  This changeset factors
that pattern out into a helper function called 'mpic_processor_id'.
Signed-off-by: NMeador Inge <meador_inge@mentor.com>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      d6a2639b
    • M
      powerpc: Make MPIC honor the "pic-no-reset" device tree property · dfec2202
      由 Meador Inge 提交于 
      This property, defined in the Open PIC binding, tells the kernel not to use
the reset bit in the global configuration register.  Additionally, its
presence mandates that only sources which are actually used (i.e. appear in
the device tree) should have their VECPRI bits initialized.

Although, "pic-no-reset" can be used for the same use cases that
"protected-sources" is covering, the "protected-sources" implementation was
left completely intact.  This is a more pragmatic approach as there are
already several existing systems which use protected sources.  If
"pic-no-reset" *and* "protected-sources" are both used, however, then
"pic-no-reset" takes precedence in terms of the init behavior and the
sanity checks done by protected sources will still take place.
Signed-off-by: NMeador Inge <meador_inge@mentor.com>
Cc: Hollis Blanchard <hollis_blanchard@mentor.com>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      dfec2202
    • M
      powerpc: Document the Open PIC device tree binding · a99eff39
      由 Meador Inge 提交于 
      This binding documents several properties that have been in use for quite
some time, and adds one new property 'pic-no-reset', which controls the
runtime initialization behavior of the PIC.  More specifically, the presence
of 'pic-no-reset' mandates that the PIC shall not be reset during runtime
initialization and that any initialization related to interrupt sources
shall be limited to sources explicitly referenced in the device tree.  This
functionality is useful in AMP systems where multiple OSes are sharing the
PIC and the reinitialization of the PIC can interfere with OSes that are
already up and running.

The interrupt specifier definition is based off of Stuart Yoder's FSL MPIC
binding.
Signed-off-by: NMeador Inge <meador_inge@mentor.com>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Stuart Yoder <stuart.yoder@freescale.com>
Cc: Hollis Blanchard <hollis_blanchard@mentor.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      a99eff39
    • B
      powerpc/pci: Fix crash in PCI code on ppc64 when matching device nodes · 90407c99
      由 Benjamin Herrenschmidt 提交于 
      Commit b5d937de has a bug which causes
basically a NULL dereference in the PCI code during boot on ppc64
machines.

fetch_dev_dn() is called when dev->dev.of_node is NULL, so using that
as the starting point for the search makes no sense. It should instead
start from the device node of the PHB.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      90407c99
  3. 20 3月, 2011 1 次提交
    • L
      Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input · a952baa0
      由 Linus Torvalds 提交于 
      * 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input: (64 commits)
  Input: tsc2005 - remove 'disable' sysfs attribute
  Input: tsc2005 - add open/close
  Input: tsc2005 - handle read errors from SPI layer
  Input: tsc2005 - do not rearm timer in hardirq handler
  Input: tsc2005 - don't use work for 'pen up' handling
  Input: tsc2005 - do not use 0 in place of NULL
  Input: tsc2005 - use true/false for boolean variables
  Input: tsc2005 - hide selftest attribute if we can't reset
  Input: tsc2005 - rework driver initialization code
  Input: tsc2005 - set up bus type in input device
  Input: tsc2005 - set up parent device
  Input: tsc2005 - clear driver data after unbinding
  Input: tsc2005 - add module description
  Input: tsc2005 - remove driver banner message
  Input: tsc2005 - remove incorrect module alias
  Input: tsc2005 - convert to using dev_pm_ops
  Input: tsc2005 - use spi_get/set_drvdata()
  Input: introduce tsc2005 driver
  Input: xen-kbdfront - move to drivers/input/misc
  Input: xen-kbdfront - add grant reference for shared page
  ...
      a952baa0
  5. 19 3月, 2011 34 次提交