Now that nothing is using this anymore, kill off the assignments across
the board.
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This kills of the now unused runtime PM stub in favour of the generic
one.
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This patch is V3 of the SuperH Mobile Runtime PM platform bus
implentation matching Rafael's Runtime PM v16.

The code gets invoked from the SuperH specific Runtime PM
platform bus functions that override the weak symbols for:
 - platform_pm_runtime_suspend()
 - platform_pm_runtime_resume()
 - platform_pm_runtime_idle()

This Runtime PM implementation performs two levels of power
management. At the time of platform bus runtime suspend the
clock to the device is stopped instantly. Later on if all
devices within the power domain has their clocks stopped
then the device driver ->runtime_suspend() callbacks are
used to save hardware register state for each device.

Device driver ->runtime_suspend() calls are scheduled from
cpuidle context using platform_pm_runtime_suspend_idle().
When all devices have been fully suspended the processor
is allowed to enter deep sleep from cpuidle.

The runtime resume operation turns on clocks and also
restores registers if needed. It is worth noting that the
devices start in a suspended state and the device driver
is responsible for calling runtime resume before accessing
the actual hardware.

In this particular platform bus implementation runtime
resume is not allowed from interrupt context. Runtime
suspend is however allowed from interrupt context as
long as the synchronous functions are avoided.

[ updated for v17 -- PFM. ]
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

These patches extend struct platform device data for a bunch of
SuperH Mobile processors and embedded boards. The patches simply
add hardware block ids to on-chip platform devices. Platform
devices off chip (such as external ethernet controllers or flash
chips) are left out which gives them a special case hardware block
id of zero.

Upcoming Runtime PM code will make use of the hardware block id
to group devices together. The hardware block id can also be used
to extend the SuperH Mobile clock framework implementation.

This series of patches depend on the following:
"Driver Core: Add platform device arch data V3".

This patch adds a hwblk_id member to struct pdev_archdata. This member
should be used to point out on-chip hardware block id.
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

Add a plat_early_device_setup() function to allow
processor-specific code to register Early Platform Data.
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This follows the sparc changes a439fe51.

Most of the moving about was done with Sam's directions at:

http://marc.info/?l=linux-sh&m=121724823706062&w=2

with subsequent hacking and fixups entirely my fault.
Signed-off-by: NSam Ravnborg <sam@ravnborg.org>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

This patch adds physically contiguous memory chunks to the UIO devices.
The same strategy can be used in the future for the CEU as well.
Signed-off-by: NMagnus Damm <damm@igel.co.jp>
Signed-off-by: NPaul Mundt <lethal@linux-sh.org>

Add arch specific dev_archdata to struct device

Adds an arch specific struct dev_arch to struct device. This enables
architecture to add specific fields to every device in the system, like
DMA operation pointers, NUMA node ID, firmware specific data, etc...
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Acked-by: NAndi Kleen <ak@suse.de>
Acked-By: NDavid Howells <dhowells@redhat.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>