1. 17 7月, 2008 3 次提交
  2. 12 6月, 2008 1 次提交
  3. 29 4月, 2008 1 次提交
  4. 06 3月, 2008 1 次提交
  5. 06 2月, 2008 1 次提交
  6. 29 1月, 2008 13 次提交
  7. 05 12月, 2007 2 次提交
  8. 21 11月, 2007 1 次提交
    • P
      [IPVS]: Fix compiler warning about unused register_ip_vs_protocol · d535a916
      Pavel Emelyanov 提交于
      This is silly, but I have turned the CONFIG_IP_VS to m,
      to check the compilation of one (recently sent) fix
      and set all the CONFIG_IP_VS_PROTO_XXX options to n to
      speed up the compilation.
      
      In this configuration the compiler warns me about
      
        CC [M]  net/ipv4/ipvs/ip_vs_proto.o
      net/ipv4/ipvs/ip_vs_proto.c:49: warning: 'register_ip_vs_protocol' defined but not used
      
      Indeed. With no protocols selected there are no
      calls to this function - all are compiled out with
      ifdefs.
      
      Maybe the best fix would be to surround this call with
      ifdef-s or tune the Kconfig dependences, but I think that
      marking this register function as __used is enough. No?
      Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
      Acked-by: NSimon Horman <horms@verge.net.au>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      d535a916
  9. 20 11月, 2007 4 次提交
  10. 13 11月, 2007 1 次提交
  11. 07 11月, 2007 2 次提交
    • R
      [IPVS]: Synchronize closing of Connections · efac5276
      Rumen G. Bogdanovski 提交于
      This patch makes the master daemon to sync the connection when it is about
      to close.  This makes the connections on the backup to close or timeout
      according their state.  Before the sync was performed only if the
      connection is in ESTABLISHED state which always made the connections to
      timeout in the hard coded 3 minutes. However the Andy Gospodarek's patch
      ([IPVS]: use proper timeout instead of fixed value) effectively did nothing
      more than increasing this to 15 minutes (Established state timeout).  So
      this patch makes use of proper timeout since it syncs the connections on
      status changes to FIN_WAIT (2min timeout) and CLOSE (10sec timeout).
      However if the backup misses CLOSE hopefully it did not miss FIN_WAIT.
      Otherwise we will just have to wait for the ESTABLISHED state timeout. As
      it is without this patch.  This way the number of the hanging connections
      on the backup is kept to minimum. And very few of them will be left to
      timeout with a long timeout.
      
      This is important if we want to make use of the fix for the real server
      overcommit on master/backup fail-over.
      Signed-off-by: NRumen G. Bogdanovski <rumen@voicecho.com>
      Signed-off-by: NSimon Horman <horms@verge.net.au>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      efac5276
    • R
      [IPVS]: Bind connections on stanby if the destination exists · 1e356f9c
      Rumen G. Bogdanovski 提交于
      This patch fixes the problem with node overload on director fail-over.
      Given the scenario: 2 nodes each accepting 3 connections at a time and 2
      directors, director failover occurs when the nodes are fully loaded (6
      connections to the cluster) in this case the new director will assign
      another 6 connections to the cluster, If the same real servers exist
      there.
      
      The problem turned to be in not binding the inherited connections to
      the real servers (destinations) on the backup director. Therefore:
      "ipvsadm -l" reports 0 connections:
      root@test2:~# ipvsadm -l
      IP Virtual Server version 1.2.1 (size=4096)
      Prot LocalAddress:Port Scheduler Flags
        -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
      TCP  test2.local:5999 wlc
        -> node473.local:5999           Route   1000   0          0
        -> node484.local:5999           Route   1000   0          0
      
      while "ipvs -lnc" is right
      root@test2:~# ipvsadm -lnc
      IPVS connection entries
      pro expire state       source             virtual            destination
      TCP 14:56  ESTABLISHED 192.168.0.10:39164 192.168.0.222:5999
      192.168.0.51:5999
      TCP 14:59  ESTABLISHED 192.168.0.10:39165 192.168.0.222:5999
      192.168.0.52:5999
      
      So the patch I am sending fixes the problem by binding the received
      connections to the appropriate service on the backup director, if it
      exists, else the connection will be handled the old way. So if the
      master and the backup directors are synchronized in terms of real
      services there will be no problem with server over-committing since
      new connections will not be created on the nonexistent real services
      on the backup. However if the service is created later on the backup,
      the binding will be performed when the next connection update is
      received. With this patch the inherited connections will show as
      inactive on the backup:
      
      root@test2:~# ipvsadm -l
      IP Virtual Server version 1.2.1 (size=4096)
      Prot LocalAddress:Port Scheduler Flags
        -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
      TCP  test2.local:5999 wlc
        -> node473.local:5999           Route   1000   0          1
        -> node484.local:5999           Route   1000   0          1
      
      rumen@test2:~$ cat /proc/net/ip_vs
      IP Virtual Server version 1.2.1 (size=4096)
      Prot LocalAddress:Port Scheduler Flags
        -> RemoteAddress:Port Forward Weight ActiveConn InActConn
      TCP  C0A800DE:176F wlc
        -> C0A80033:176F      Route   1000   0          1
        -> C0A80032:176F      Route   1000   0          1
      
      Regards,
      Rumen Bogdanovski
      Acked-by: NJulian Anastasov <ja@ssi.bg>
      Signed-off-by: NRumen G. Bogdanovski <rumen@voicecho.com>
      Signed-off-by: NSimon Horman <horms@verge.net.au>
      1e356f9c
  12. 31 10月, 2007 1 次提交
  13. 30 10月, 2007 1 次提交
  14. 24 10月, 2007 1 次提交
  15. 20 10月, 2007 2 次提交
  16. 16 10月, 2007 3 次提交
  17. 11 10月, 2007 2 次提交