- 09 10月, 2013 1 次提交
-
-
由 Alan Ott 提交于
This avoids a race condition where complete(tx_complete) could be called before tx_complete is initialized. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 12 7月, 2013 1 次提交
-
-
由 Wolfram Sang 提交于
Since commit ab78029e (drivers/pinctrl: grab default handles from device core), we can rely on device core for setting the default pins. Compile tested only. Acked-by: Linus Walleij <linus.walleij@linaro.org> (personally at LCE13) Signed-off-by: NWolfram Sang <wsa@the-dreams.de> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 10 4月, 2013 1 次提交
-
-
由 Wei Yongjun 提交于
module_spi_driver() makes the code simpler by eliminating boilerplate code. Signed-off-by: NWei Yongjun <yongjun_wei@trendmicro.com.cn> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 09 4月, 2013 1 次提交
-
-
由 Alan Ott 提交于
On the MRF24J40, link-layer acknowledgment request and retry must be turned on explicitly for each packet. Turn this on in the hardware based on the FC_ACK_REQ bit being set in the packet. Also, now that failure to receive an ACK will cause the hardware to report failure of transmission, change the log level for this failure to debug level. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 08 4月, 2013 1 次提交
-
-
由 Jingoo Han 提交于
Use the wrapper functions for getting and setting the driver data using spi_device instead of using dev_{get|set}_drvdata with &spi->dev, so we can directly pass a struct spi_device. Signed-off-by: NJingoo Han <jg1.han@samsung.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 19 3月, 2013 4 次提交
-
-
由 Alan Ott 提交于
Load the 64-bit Extended (IEEE) address into the hardware in the proper byte order. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Alan Ott 提交于
Upon consulting the datasheet further, it does indicates a maximum speed for SCK at 10MHz. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Alan Ott 提交于
Issue a warning if a transmit complete interrupt doesn't happen in time. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Alan Ott 提交于
Activate pinctrl settings when used with a DT system. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 04 12月, 2012 1 次提交
-
-
由 Bill Pemberton 提交于
CONFIG_HOTPLUG is going away as an option. As result the __dev* markings will be going away. Remove use of __devinit, __devexit_p, __devinitdata, __devinitconst, and __devexit. Signed-off-by: NBill Pemberton <wfp5p@virginia.edu> Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>
-
- 03 10月, 2012 1 次提交
-
-
由 Linus Torvalds 提交于
The network merge brought in a few users of functions that got deprecated by the workqueue cleanups: the 'system_nrt_wq' is now the same as the regular system_wq, since all workqueues are now non- reentrant. Similarly, remove one use of flush_work_sync() - the regular flush_work() has become synchronous, and the "_sync()" version is thus deprecated as being superfluous. Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
-
- 05 9月, 2012 1 次提交
-
-
由 Alan Ott 提交于
Driver for the Microchip MRF24J40 802.15.4 WPAN module. Signed-off-by: NAlan Ott <alan@signal11.us> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-