Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 30 10月, 2012 1 次提交
  3. 12 9月, 2012 1 次提交
  5. 10 9月, 2012 1 次提交
    • J
      mac80211: add key flag for management keys · e548c49e
      由 Johannes Berg 提交于 
      Mark keys that might be used to receive management
frames so drivers can fall back on software crypto
for them if they don't support hardware offload.
As the new flag is only set correctly for RX keys
and the existing IEEE80211_KEY_FLAG_SW_MGMT flag
can only affect TX, also rename the latter to
IEEE80211_KEY_FLAG_SW_MGMT_TX.
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>
      e548c49e
  7. 22 8月, 2012 1 次提交
  9. 31 7月, 2012 1 次提交
  11. 18 7月, 2012 2 次提交
  13. 27 6月, 2012 2 次提交
  15. 21 6月, 2012 1 次提交
  17. 16 3月, 2012 1 次提交
  19. 28 2月, 2012 1 次提交
  21. 25 1月, 2012 1 次提交
  23. 20 12月, 2011 2 次提交
  25. 08 12月, 2011 1 次提交
    • N
      ath9k: use config.enable_ani to check if ani should be performed · 4279425c
      由 Nikolay Martynov 提交于 
        Currently in ath9k code there is an attempt which is meant to
disable ANI for ar9100 and ar9340. But it doesn't really achieve
this. All it does is disable ANI init and setup (i.e. calls to
ath9k_hw_ani_setup and ath9k_hw_ani_init). Since ath9k_hw_ani_setup is
not called ah->config.ani_poll_interval is never initialized (i.e. it
is always zero) and ath_ani_calibrate always executes ANI procedures
(over uninitialized ANI parameters).
  Moreover, ath_ani_calibrate is being called each 1ms because
common->ani.timer is set to zero interval because
ah->config.ani_poll_interval==0 (and thus smallest value of all
intervals). Normally it should not be called this often.
  This patch changes the code so config.enable_ani is used to check if
ANI should be performed.
  config.enable_ani is initialized to true by default. This patch sets
it to false for ar9100 and ar9340.
Signed-off-by: NNikolay Martynov <mar.kolya@gmail.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      4279425c
  27. 04 10月, 2011 1 次提交
    • E
      mac80211: pass vif param to conf_tx() callback · 8a3a3c85
      由 Eliad Peller 提交于 
      tx params should be configured per interface.
add ieee80211_vif param to the conf_tx callback,
and change all the drivers that use this callback.

The following spatch was used:
@rule1@
struct ieee80211_ops ops;
identifier conf_tx_op;
@@
	ops.conf_tx = conf_tx_op;

@rule2@
identifier rule1.conf_tx_op;
identifier hw, queue, params;
@@
	conf_tx_op (
-		struct ieee80211_hw *hw,
+		struct ieee80211_hw *hw, struct ieee80211_vif *vif,
		u16 queue,
		const struct ieee80211_tx_queue_params *params) {...}
Signed-off-by: NEliad Peller <eliad@wizery.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      8a3a3c85
  29. 28 9月, 2011 1 次提交
  31. 15 9月, 2011 1 次提交
  33. 30 8月, 2011 1 次提交
    • L
      ath9k: Fix a smatch warnings · 1ba45b9e
      由 Larry Finger 提交于 
      Smatch shows the following warnings:

  CHECK   drivers/net/wireless/ath/ath9k/htc_drv_main.c
drivers/net/wireless/ath/ath9k/htc_drv_main.c +1315 ath9k_htc_configure_filter(27) warn: inconsistent returns mutex:&priv->mutex: locked (1303) unlocked (1315)

  CHECK   drivers/net/wireless/ath/ath9k/ar9003_eeprom.c
drivers/net/wireless/ath/ath9k/ar9003_eeprom.c +3321 ar9300_eeprom_restore_internal(20) warn: returning -1 instead of -ENOMEM is sloppy
Signed-off-by: NLarry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      1ba45b9e
  35. 26 8月, 2011 1 次提交
  37. 08 7月, 2011 1 次提交
  39. 20 5月, 2011 6 次提交
  41. 30 4月, 2011 1 次提交
  43. 29 4月, 2011 1 次提交
  45. 26 4月, 2011 4 次提交
  47. 14 4月, 2011 6 次提交