- 27 11月, 2009 5 次提交
-
-
由 Ben Hutchings 提交于
From: Steve Hodgson <shodgson@solarflare.com> Only the XMAC on Falcon needs help from the driver to poll and reset the MAC-PHY link (XAUI); GMII is a simple parallel bus and on later NICs firmware takes care of the XAUI link. Also, an XMAC interrupt currently schedules a work item which simply clears a flag (efx_nic::mac_up) to be checked by the regular monitor (or the next link reconfiguration, if that is sooner). Rename the flag to xmac_poll_required, changing its sense. Remove the needless indirection and just set the flag immediately. Call falcon_xmac_poll() directly where required. Add a new generic operation mac_op::check_fault to check the link outside of regular monitoring, as required during self-tests. (Note that this leaves us with an unused work item, but we will immediately have another use for it.) Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
From: Steve Hodgson <shodgson@solarflare.com> Currently we initiate MAC stats DMA and busy-wait for completion when stats are requested. We can improve on this with a periodic timer to initiate and poll for stats, and opportunistically poll when stats are requested. Since efx_nic::stats_disable_count and efx_stats_{disable,enable}() are Falcon-specific, rename them and move them accordingly. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Put all static information in struct falcon_board_type and replace it with a pointer in struct falcon_board. Simplify probing aocordingly. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 25 11月, 2009 4 次提交
-
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
This is preparation for moving Falcon-specific state required by other Falcon-specific code. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Rename struct efx_board to struct falcon_board. Introduce and use inline function to look up board info from struct efx_nic, in preparation for moving it. Move board init and fini calls into NIC probe and remove functions. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 24 10月, 2009 2 次提交
-
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 22 3月, 2009 1 次提交
-
-
由 Ben Hutchings 提交于
Calculate a score for each 1000 IRQs: - TX completions are worth 1 point - RX completions are worth 4 if merged using LRO or 2 otherwise Reduce moderation if the score is less than 10000, down to a minimum of 5 us. Increase moderation if the score is more than 20000, up to the specified maximum. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 13 12月, 2008 1 次提交
-
-
由 Ben Hutchings 提交于
The SFC4000 has a separate MAC for use at sub-10G speeds. Introduce an efx_mac_operations structure with implementations for the two MACs. Switch between the MACs as necessary. PHY settings are independent of the MAC, so add get_settings() and set_settings() to efx_phy_operations. Also add macs field to indicate which MACs the PHY is connected to. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 25 9月, 2008 1 次提交
-
-
由 Ben Hutchings 提交于
Increase the potential retry count for RX flushes from 5 to 100. Stop polling the RX_DESC_PTR_TBL to infer that a flush might have happened. Instead absolutely rely on the flush events, unless bug 7803 applies (Falcon rev A only). To keep things quick, request flushes for every TX and RX queue up front, and match up the events to requests. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
- 03 9月, 2008 4 次提交
-
-
由 Ben Hutchings 提交于
Include PMA/PMD in loopback self-tests as intended. Add NVRAM checksum validation and include it in self-tests. Add register self-tests. Run PHY self-tests where available. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
由 Ben Hutchings 提交于
Some functions return an error code which is always 0. Change their return types to void and simplify their callers accordingly. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
由 Ben Hutchings 提交于
Make efx_process_channel() and falcon_process_eventq() return the number of packets received rather than updating the quota, consistent with new NAPI. Since channels and RX queues are mapped one-to-one, remove return value from falcon_handle_rx_event() and add a warning for events with the wrong RX queue number. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
由 Ben Hutchings 提交于
Replace (cond ? 1 : 0) with cond or !!cond as appropriate, and (cond ? 0 : 1) with !cond. Remove some redundant boolean temporaries. Rename one field that looks like a flag but isn't. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
- 22 5月, 2008 1 次提交
-
-
由 Ben Hutchings 提交于
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-
- 29 4月, 2008 1 次提交
-
-
由 Ben Hutchings 提交于
The driver supports the 10Xpress PHY and XFP modules on our reference designs SFE4001 and SFE4002 and the SMC models SMC10GPCIe-XFP and SMC10GPCIe-10BT. Signed-off-by: NBen Hutchings <bhutchings@solarflare.com> Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
-