Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 13 10月, 2008 1 次提交
    • M
      powerpc/xics: EOI unmapped irqs after disabling them · 8767e9ba
      由 Milton Miller 提交于 
      When reciving an irq vector that does not have a linux mapping, the kernel
prints a message and calls RTAS to disable the irq source.   Previously
the kernel did not EOI the interrupt, causing the source to think it is
still being processed by software.  While this does add an additional
layer of protection against interrupt storms had RTAS failed to disable
the source, it also prevents the interrupt from working when a driver
later enables it.  (We could alternatively send an EOI on startup, but
that strategy would likely fail on an emulated xics.)

All interrupts should be disabled when the kernel starts, but this can
be observed if a driver does not shutdown an interrupt in its reboot
hook before starting a new kernel with kexec.

Michael reports this can be reproduced trivially by banging the keyboard
while kexec'ing on a P5 LPAR: even though the hvc_console driver request's
the console irq later in boot, the console is non-functional because
we're receiving no console interrupts.

Reported-By: Michael Ellerman
Signed-off-by: NMilton Miller <miltonm@bga.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      8767e9ba
  3. 10 10月, 2008 11 次提交
    • B
      Merge commit 'jk/jk-merge' · bb3d55e2
      由 Benjamin Herrenschmidt 提交于
      bb3d55e2
    • J
      powerpc: Reserve in bootmem lmb reserved regions that cross NUMA nodes · 8f64e1f2
      由 Jon Tollefson 提交于 
      If there are multiple reserved memory blocks via lmb_reserve() that are
contiguous addresses and on different NUMA nodes we are losing track of which
address ranges to reserve in bootmem on which node.  I discovered this
when I recently got to try 16GB huge pages on a system with more then 2 nodes.

When scanning the device tree in early boot we call lmb_reserve() with
the addresses of the 16G pages that we find so that the memory doesn't
get used for something else.  For example the addresses for the pages
could be 4000000000, 4400000000, 4800000000, 4C00000000, etc - 8 pages,
one on each of eight nodes.  In the lmb after all the pages have been
reserved it will look something like the following:

lmb_dump_all:
    memory.cnt            = 0x2
    memory.size           = 0x3e80000000
    memory.region[0x0].base       = 0x0
                      .size     = 0x1e80000000
    memory.region[0x1].base       = 0x4000000000
                      .size     = 0x2000000000
    reserved.cnt          = 0x5
    reserved.size         = 0x3e80000000
    reserved.region[0x0].base       = 0x0
                      .size     = 0x7b5000
    reserved.region[0x1].base       = 0x2a00000
                      .size     = 0x78c000
    reserved.region[0x2].base       = 0x328c000
                      .size     = 0x43000
    reserved.region[0x3].base       = 0xf4e8000
                      .size     = 0xb18000
    reserved.region[0x4].base       = 0x4000000000
                      .size     = 0x2000000000

The reserved.region[0x4] contains the 16G pages.  In
arch/powerpc/mm/num.c: do_init_bootmem() we loop through each of the
node numbers looking for the reserved regions that belong to the
particular node.  It is not able to identify region 0x4 as being a part
of each of the 8 nodes.  It is assuming that a reserved region is only
on a single node.

This patch takes out the reserved region loop from inside
the loop that goes over each node.  It looks up the active region containing
the start of the reserved region.  If it extends past that active region then
it adjusts the size and gets the next active region containing it.
Signed-off-by: NJon Tollefson <kniht@linux.vnet.ibm.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      8f64e1f2
    • P
      powerpc: Sync RPA note in zImage with kernel's RPA note · 91a00302
      由 Paul Mackerras 提交于 
      Commit 9b09c6d9 ("powerpc: Change the
default link address for pSeries zImage kernels") changed the
real-base value in the CHRP note added by the addnote program from
12MB to 32MB to give more space for Open Firmware to load the zImage.
(The real-base value says where we want OF to position itself in
memory.)  However, this change was ineffective on most pSeries
machines, because the RPA note added by addnote has the "ignore me"
flag set to 1.  This was intended to tell OF to ignore just the RPA
note, but has the side effect of also making OF ignore the CHRP note
(at least on most pSeries machines).

To solve this we have to set the "ignore me" flag to 0 in the RPA
note.  (We can't just omit the RPA note because that is equivalent to
having an RPA note with default values, and the default values are not
what we want.)  However, then we have to make sure the values in the
zImage's RPA note match up with the values that the kernel supplies
later in prom_init.c with either the ibm,client-architecture-support
call or the process-elf-header call in prom_send_capabilities().

So this sets the "ignore me" flag in the RPA note in addnote to 0, and
adjusts the RPA note values in addnote.c and in prom_init.c to be
consistent with each other and with the values in ibm_architecture_vec.

However, since the wrapper is independent of the kernel, this doesn't
ensure that the notes will stay consistent.  To ensure that, this adds
code to addnote.c so that it can extract the kernel's RPA note from
the kernel binary and put that in the zImage.  To that end, we put the
kernel's fake ELF header (which contains the kernel's RPA note) into
its own section, and arrange for wrapper to pull out that section with
objcopy and pass it to addnote, which then extracts the RPA note from
it and transfers it to the zImage.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      91a00302
    • G
      powerpc/of-bindings: Don't support linux,<modalias> "compatible" values · 58f467ce
      由 Grant Likely 提交于 
      Compatible property values in the form linux,<modalias> is not documented
anywhere and using it leaks Linux implementation details into the device
tree data (which is bad).  Remove support for compatible values of this
form.

If any platforms exist which depended on this code (and I don't know of
any), then they can be fixed up by adding legacy translations to the
lookup table in this file.
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      58f467ce
    • J
      powerpc: Fix error path in kernel_thread function · 41c2e949
      由 Josh Poimboeuf 提交于 
      The powerpc 32-bit and 64-bit kernel_thread functions don't properly
propagate errors being returned by the clone syscall.  (In the case of
error, the syscall exit code returns a positive errno in r3 and sets
the CR0[SO] bit.)

This patch fixes that by negating r3 if CR0[SO] is set after the syscall.
Signed-off-by: NJosh Poimboeuf <jpoimboe@us.ibm.com>
Signed-off-by: NJosh Boyer <jwboyer@linux.vnet.ibm.com>
Acked-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      41c2e949
    • R
      powerpc/cell/oprofile: Fix test on overlay_tbl_offset in vma_map · 99c84066
      由 Roel Kluin 提交于 
      Offset is unsigned and when an address isn't found in the vma map
vma_map_lookup() returns the vma physical address + 0x10000000.

vma_map_lookup used to return 0xffffffff on a failed lookup, but
a change was made to return the vma physical address + 0x10000000
There are two callers of vam_map_lookup: one of them correctly
deals with this new return value, but the other (below) did not.
Signed-off-by: NRoel Kluin <12o3l@tiscali.nl>
Acked-by: NMaynard Johnson <maynardj@us.ibm.com>
Signed-off-by: NArnd Bergmann <arnd@arndb.de>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      99c84066
    • A
      powerpc: Fix no interrupt handling in pata_of_platform · 4538d0ca
      由 Anton Vorontsov 提交于 
      When no interrupt is specified the pata_of_platform fills the irq_res
resource with -1, which is wrong to do for two reasons:

1. By definition, 'no irq' should be IRQ 0, not some negative integer;
2. pata_platform checks for irq_res.start > 0, but since irq_res.start
   is unsigned type, the check will be true for `-1'.
Reported-by: NSteven A. Falco <sfalco@harris.com>
Signed-off-by: NAnton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      4538d0ca
    • N
      powerpc: Oops in pseries_lmb_remove() · 9fd3f88c
      由 Nathan Fontenot 提交于 
      Testing hotplug memory remove has revealed that we can oops in
pseries_lmb_remove().  The incorrect shift causes a NULL pointer
dereference in the page_zone() inline routine.

I have only been able to reproduce the oops on kernels with large pages
enabled.

Tested on Power5 and Power6 with and without large pages enabled.
Signed-off-by: NNathan Fontenot <nfont@austin.ibm.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
      9fd3f88c
    • K
      powerpc/spufs: add a missing mutex_unlock · 6747c2ee
      由 Kou Ishizaki 提交于 
      A mutex_unlock(&gang->aff_mutex) in spufs_create_context() is missing
in case spufs_context_open() fails.  As a result, spu_create syscall
and spu_get_idle() may block.

This patch adds the mutex_unlock.
Signed-off-by: NKou Ishizaki <kou.ishizaki@toshiba.co.jp>
Signed-off-by: NJeremy Kerr <jk@ozlabs.org>
Acked-by: NAndre Detsch <adetsch@br.ibm.com>
      6747c2ee
    • J
      powerpc/spufs: use inc_nlink · ba0b996d
      由 Jeremy Kerr 提交于 
      Style change: use inc_nlink instead of incrementing i_nlink directly
Signed-off-by: NJeremy Kerr <jk@ozlabs.org>
      ba0b996d
    • J
      powerpc/spufs: set nlink count for spufs root correctly · e2ed6e4d
      由 Jeremy Kerr 提交于 
      Currently, an empty spufs root inode has nlink count of 1. However,
the directory has two links; / -> spu and /spu/ -> .

This change increments the link count of the root inode in spufs.
Signed-off-by: NJeremy Kerr <jk@ozlabs.org>
      e2ed6e4d
  5. 07 10月, 2008 11 次提交
  7. 03 10月, 2008 4 次提交
  9. 02 10月, 2008 3 次提交
  11. 01 10月, 2008 1 次提交
    • K
      powerpc/math-emu: Use kernel generic math-emu code · d2b194ed
      由 Kumar Gala 提交于 
      The math emulation code is centered around a set of generic macros that
provide the core of the emulation that are shared by the various
architectures and other projects (like glibc).  Each arch implements its
own sfp-machine.h to specific various arch specific details.

For historic reasons that are now lost the powerpc math-emu code had
its own version of the common headers.  This moves us to using the
kernel generic version and thus getting fixes when those are updated.

Also cleaned up exception/error reporting from the FP emulation functions.
Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
      d2b194ed
  13. 30 9月, 2008 3 次提交
  15. 29 9月, 2008 3 次提交
  17. 25 9月, 2008 3 次提交