Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The PXA3xx does not support the use of interrupts during reset and access
to the GPIO status requires similar handling to that for PXA27x.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the support of Terrasonq TS88.
Signed-off-by: NPeter Lienig <lienig@rheinmetall-de.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

free_irq() calls synchronize_irq() for you, so there is no need for
drivers to manually do the same thing (again).  Thus, calls where
sync-irq immediately precedes free-irq can be simplified.

However, during this audit several bugs were noticed, where free-irq is
preceded by a "irq >= 0" check... but the sync-irq call is not covered
by the same check.

So, where sync-irq could not be eliminated completely, the missing check
was added.
Signed-off-by: NJeff Garzik <jgarzik@redhat.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Correct some arguments in calls to snd_ice1712_gpio_write_bits() from
ap192_set_rate_val().
Signed-off-by: NKarsten Wiese <fzu@wemgehoertderstaat.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Some calls to snd_ice1712_gpio_write() go wrong, if
snd_ice1712_gpio_write_bits() ran before and changed the gpio mask register.
Read the actual gpio value and combine it with the to be set bits in the cpu
instead.
Signed-off-by: NKarsten Wiese <fzu@wemgehoertderstaat.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Let "chip reset" become first. Increasement of the "chip reset" related timeout
leads to correctly read eeprom's contents here.
Signed-off-by: NKarsten Wiese <fzu@wemgehoertderstaat.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Since unsigned active_offs < 0 is even true when DMAbuf_get_buffer_pointer()
returns negative
Signed-off-by: NRoel Kluin <12o3l@tiscali.nl>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

cs4270_hw_params does several times:

ret = snd_soc_write()
if (ret < 0)
	...

This only works when ret is signed.
Signed-off-by: NRoel Kluin <12o3l@tiscali.nl>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix the race at reconnection of the device.
The disconnected usb_chip[] must be cleared before the next probe
call properly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

A little clean up of snd_card_free*().
Removed snd_card_free_prepare() since it's actually almost identical
with snd_card_disconnect().
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Move the call of device_unregister() for the card instance in
snd_card_disconnect() to avoid the race of sysfs card entry, which
can be typically found on usb-audio reconnection.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Coding style corrections for burgundy.c.
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add mixer controls and correct headphone detection bits for PowerMac
G3 B&W and iMac G3 Tray-loading, both having Burgundy chipset.
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Coding style corrections for awacs.c and awacs.h.
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add mixer controls and correct headphone detection bits for PowerMacs
7300/7500 (AWACS) and G3 Beige (Screamer), and iMac G3 Slot-loading
(Screamer).
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Coding style corrections for pmac.c.
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Enable port change interrupt while initialising AWACS, Screamer, and
Burgundy chipsets.
Signed-off-by: NRisto Suominen <Risto.Suominen@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

bps is unsigned, a negative snd_pcm_format_width() return value is not noticed
Signed-off-by: NRoel Kluin <12o3l@tiscali.nl>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The last ALC889A hack may break on some devices with certain model presets
since patch_alc*() have different model tables.  So, now it's handled in
the original patch_alc882() but fly to patch_alc883() in model=auto
appropriately.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

ALC889A is recognized ALC885/ALC882 but it's actually closer to
ALC888/ALC883.

Cc: Kasper Sandberg <lkml@metanurb.dk>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Several 92hd7xxx and STAC9228 laptops have multiple headphone jacks,
the second headphone jack should be used for the 5.1 surround sound.
Add support for 'Headphone as Line Out' switch, which allows it be used
in 5.1 surround sound.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add a pointer for DAC volume TLV data to the model structure so that the
model driver do not need to manually assign it in their control filter.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Initialize the playback volume controls as being muted and having
minimal volume.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add fields for the DAC volume limits to the module structure so that
model drivers do not need to install their own control info handlers.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The empty hifier_mixer_init() function is useless; remove it.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the support of AD1989A and AD1989B codecs.
These codecs can have multiple SPDIF devices, but currently we handle
only one SPDIF.  If any real devices with two SPDIF interfaces (likely
one for SPDIF and one for HDMI), we'll fix this rightly.

Otherwise, these codecs are pretty similar with AD1988.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

snd_minor_info_oss_* is an function returning int _or_ comment,
depending on config parameters. That is truly evil, fix it.
Signed-off-by: NPavel Machek <pavel@suse.cz>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix the GPIO 1 mixer control to enable I/O through the front panel
connector of the Xonar DX.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch for snd_usb_caiaq makes sample rates higher dann 48KHz work
with devices which have more than 2 stereo input/output pairs.
Signed-off-by: NDaniel Mack <daniel@caiaq.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch corrects the input channel order of hardware supported by
snd_usb_caiaq.
Signed-off-by: NDaniel Mack <daniel@caiaq.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch fixes potential lockups in snd_usb_caiaq by refining the
locking mechanims and by using usb_kill_urb() in favor to
usb_unlink_urb().
Signed-off-by: NDaniel Mack <daniel@caiaq.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Signed-off-by: NJarkko Nikula <jarkko.nikula@nokia.com>
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Leave the power bit for the touch screen alone when suspending the WM9713
so that the touch screen driver can handle it. This allows the touch
screen to be used as a wakeup source when the system is suspended.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

sound: kernel log levels are 0-7

Kernel log levels are 0-7, not 0-9.
Signed-off-by: NNick Andrew <nick@nick-andrew.net>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This adds support for Quanta IL1 mini-notebook to alsa, defining a new model
for it. It comes with an ALC267 codec chip. Some notes about this model:

* In headphone automute, I use AC_VERB_SET_PIN_WIDGET_CONTROL instead of common
  amp mute, to avoid conflict with mixer switch (mixer and automute use the
  same nid).
* The only connected capture sources in the hardware are the internal mic and
  external mic jack. So instead of using an input source selector like on other
  ALC268 models, the mic automute automatically switch between captures.
Signed-off-by: NHerton Ronaldo Krzesinski <herton@mandriva.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Since 43cc71ee, the platform modalias is
prefixed with "platform:".  Add MODULE_ALIAS() to the hotpluggable sound
platform drivers, to re-enable auto loading.

[dbrownell@users.sourceforge.net: more drivers, registration fixes]
Signed-off-by: NKay Sievers <kay.sievers@vrfy.org>
Signed-off-by: NDavid Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Power management support for EAPD enabled laptops, when headphones
are sensed it pulls the EAPD GPIO line low to power it down.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Several laptops have have the SPDIF out defined as 'Digital other out'
when it should be 'SPDIF out' in the default config.
Signed-off-by: NMatthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>