Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 28 4月, 2008 1 次提交
  3. 15 2月, 2008 2 次提交
  5. 10 2月, 2008 1 次提交
    • T
      ext4: Add new "development flag" to the ext4 filesystem · 469108ff
      由 Theodore Tso 提交于 
      This flag is simply a generic "this is a crash/burn test filesystem"
marker.  If it is set, then filesystem code which is "in development"
will be allowed to mount the filesystem.  Filesystem code which is not
considered ready for prime-time will check for this flag, and if it is
not set, it will refuse to touch the filesystem.

As we start rolling ext4 out to distro's like Fedora, et. al, this makes
it less likely that a user might accidentally start using ext4 on a
production filesystem; a bad thing, since that will essentially make it
be unfsckable until e2fsprogs catches up.
Signed-off-by: NTheodore Tso <tytso@MIT.EDU>
Signed-off-by: NMingming Cao <cmm@us.ibm.com>
      469108ff
  7. 08 2月, 2008 1 次提交
  9. 07 2月, 2008 1 次提交
  11. 29 1月, 2008 20 次提交
  13. 18 12月, 2007 1 次提交
  15. 22 10月, 2007 2 次提交
  17. 18 10月, 2007 8 次提交
    • A
      ext4: Convert s_r_blocks_count and s_free_blocks_count · 308ba3ec
      由 Aneesh Kumar K.V 提交于 
      Convert s_r_blocks_count and s_free_blocks_count to
s_r_blocks_count_lo and s_free_blocks_count_lo

This helps in finding BUGs due to direct partial access of
these split 64 bit values

Also fix direct partial access in ext4 code
Signed-off-by: NAneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
Signed-off-by: N"Theodore Ts'o" <tytso@mit.edu>
      308ba3ec
    • A
      ext4: Convert s_blocks_count to s_blocks_count_lo · 6bc9feff
      由 Aneesh Kumar K.V 提交于 
      Convert s_blocks_count to s_blocks_count_lo
This helps in finding BUGs due to direct partial access of
these split 64 bit values

Also fix direct partial access in ext4 code
Signed-off-by: NAneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
      6bc9feff
    • A
      ext4: Convert bg_inode_bitmap and bg_inode_table · 5272f837
      由 Aneesh Kumar K.V 提交于 
      Convert bg_inode_bitmap and bg_inode_table to bg_inode_bitmap_lo
and bg_inode_table_lo.  This helps in finding BUGs due to
direct partial access of these split 64 bit values

Also fix one direct partial access
Signed-off-by: NAneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
      5272f837
    • A
      ext4: Convert bg_block_bitmap to bg_block_bitmap_lo · 3a14589c
      由 Aneesh Kumar K.V 提交于 
      Convert bg_block_bitmap to bg_block_bitmap_lo
This helps in catching some BUGS due to direct
partial access of these split fields.
Signed-off-by: NAneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
      3a14589c
    • J
      ext4: FLEX_BG Kernel support v2. · ce421581
      由 Jose R. Santos 提交于 
      This feature relaxes check restrictions on where each block groups meta
data is located within the storage media.  This allows for the allocation
of bitmaps or inode tables outside the block group boundaries in cases
where bad blocks forces us to look for new blocks which the owning block
group can not satisfy.  This will also allow for new meta-data allocation
schemes to improve performance and scalability.
Signed-off-by: NJose R. Santos <jrs@us.ibm.com>
Cc: <linux-ext4@vger.kernel.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
      ce421581
    • A
      Ext4: Uninitialized Block Groups · 717d50e4
      由 Andreas Dilger 提交于 
      In pass1 of e2fsck, every inode table in the fileystem is scanned and checked,
regardless of whether it is in use.  This is this the most time consuming part
of the filesystem check.  The unintialized block group feature can greatly
reduce e2fsck time by eliminating checking of uninitialized inodes.

With this feature, there is a a high water mark of used inodes for each block
group.  Block and inode bitmaps can be uninitialized on disk via a flag in the
group descriptor to avoid reading or scanning them at e2fsck time.  A checksum
of each group descriptor is used to ensure that corruption in the group
descriptor's bit flags does not cause incorrect operation.

The feature is enabled through a mkfs option

	mke2fs /dev/ -O uninit_groups

A patch adding support for uninitialized block groups to e2fsprogs tools has
been posted to the linux-ext4 mailing list.

The patches have been stress tested with fsstress and fsx.  In performance
tests testing e2fsck time, we have seen that e2fsck time on ext3 grows
linearly with the total number of inodes in the filesytem.  In ext4 with the
uninitialized block groups feature, the e2fsck time is constant, based
solely on the number of used inodes rather than the total inode count.
Since typical ext4 filesystems only use 1-10% of their inodes, this feature can
greatly reduce e2fsck time for users.  With performance improvement of 2-20
times, depending on how full the filesystem is.

The attached graph shows the major improvements in e2fsck times in filesystems
with a large total inode count, but few inodes in use.

In each group descriptor if we have

EXT4_BG_INODE_UNINIT set in bg_flags:
        Inode table is not initialized/used in this group. So we can skip
        the consistency check during fsck.
EXT4_BG_BLOCK_UNINIT set in bg_flags:
        No block in the group is used. So we can skip the block bitmap
        verification for this group.

We also add two new fields to group descriptor as a part of
uninitialized group patch.

        __le16  bg_itable_unused;       /* Unused inodes count */
        __le16  bg_checksum;            /* crc16(sb_uuid+group+desc) */

bg_itable_unused:

If we have EXT4_BG_INODE_UNINIT not set in bg_flags
then bg_itable_unused will give the offset within
the inode table till the inodes are used. This can be
used by fsck to skip list of inodes that are marked unused.

bg_checksum:
Now that we depend on bg_flags and bg_itable_unused to determine
the block and inode usage, we need to make sure group descriptor
is not corrupt. We add checksum to group descriptor to
detect corruption. If the descriptor is found to be corrupt, we
mark all the blocks and inodes in the group used.
Signed-off-by: NAvantika Mathur <mathur@us.ibm.com>
Signed-off-by: NAndreas Dilger <adilger@clusterfs.com>
Signed-off-by: NMingming Cao <cmm@us.ibm.com>
Signed-off-by: NAneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
      717d50e4
    • C
      ext4: Remove (partial, never completed) fragment support · f077d0d7
      由 Coly Li 提交于 
      Fragment support in ext2/3/4 was never implemented, and it probably will
never be implemented.   So remove it from ext4.
Signed-off-by: NColy Li <coyli@suse.de>
Acked-by: NAndreas Dilger <adilger@clusterfs.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: N"Theodore Ts'o" <tytso@mit.edu>
      f077d0d7
    • M
      jbd2: JBD_XXX to JBD2_XXX naming cleanup · cd02ff0b
      由 Mingming Cao 提交于 
      change JBD_XXX macros to JBD2_XXX in JBD2/Ext4
Signed-off-by: NMingming Cao <cmm@us.ibm.com>
Signed-off-by: N"Theodore Ts'o" <tytso@mit.edu>
      cd02ff0b
  19. 17 10月, 2007 3 次提交