Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 06 3月, 2008 1 次提交
  3. 04 3月, 2008 3 次提交
  5. 01 3月, 2008 1 次提交
  7. 29 1月, 2008 6 次提交
  9. 26 1月, 2008 1 次提交
    • R
      IPoIB: improve IPv4/IPv6 to IB mcast mapping functions · a9e527e3
      由 Rolf Manderscheid 提交于 
      An IPoIB subnet on an IB fabric that spans multiple IB subnets can't
use link-local scope in multicast GIDs.  The existing routines that
map IP/IPv6 multicast addresses into IB link-level addresses hard-code
the scope to link-local, and they also leave the partition key field
uninitialised.  This patch adds a parameter (the link-level broadcast
address) to the mapping routines, allowing them to initialise both the
scope and the P_Key appropriately, and fixes up the call sites.

The next step will be to add a way to configure the scope for an IPoIB
interface.
Signed-off-by: NRolf Manderscheid <rvm@obsidianresearch.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>
      a9e527e3
  11. 21 12月, 2007 1 次提交
  13. 13 11月, 2007 1 次提交
  15. 30 10月, 2007 1 次提交
  17. 19 10月, 2007 1 次提交
  19. 11 10月, 2007 5 次提交
    • P
      [IPv6]: Export userland ND options through netlink (RDNSS support) · 31910575
      由 Pierre Ynard 提交于 
      As discussed before, this patch provides userland with a way to access
relevant options in Router Advertisements, after they are processed
and validated by the kernel. Extra options are processed in a generic
way; this patch only exports RDNSS options described in RFC5006, but
support to control which options are exported could be easily added.

A new rtnetlink message type is defined, to transport Neighbor
Discovery options, along with optional context information. At the
moment only the address of the router sending an RDNSS option is
included, but additional attributes may be later defined, if needed by
new use cases.
Signed-off-by: NPierre Ynard <linkfanel@yahoo.fr>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      31910575
    • S
      [NET]: sparse warning fixes · cfcabdcc
      由 Stephen Hemminger 提交于 
      Fix a bunch of sparse warnings. Mostly about 0 used as
NULL pointer, and shadowed variable declarations.
One notable case was that hash size should have been unsigned.
Signed-off-by: NStephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      cfcabdcc
    • S
      [NET]: Move hardware header operations out of netdevice. · 3b04ddde
      由 Stephen Hemminger 提交于 
      Since hardware header operations are part of the protocol class
not the device instance, make them into a separate object and
save memory.
Signed-off-by: NStephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      3b04ddde
    • D
      [IPV6]: Add ICMPMsgStats MIB (RFC 4293) [rev 2] · 14878f75
      由 David L Stevens 提交于 
      Background: RFC 4293 deprecates existing individual, named ICMP
type counters to be replaced with the ICMPMsgStatsTable. This table
includes entries for both IPv4 and IPv6, and requires counting of all
ICMP types, whether or not the machine implements the type.

These patches "remove" (but not really) the existing counters, and
replace them with the ICMPMsgStats tables for v4 and v6.
It includes the named counters in the /proc places they were, but gets the
values for them from the new tables. It also counts packets generated
from raw socket output (e.g., OutEchoes, MLD queries, RA's from
radvd, etc).

Changes:
1) create icmpmsg_statistics mib
2) create icmpv6msg_statistics mib
3) modify existing counters to use these
4) modify /proc/net/snmp to add "IcmpMsg" with all ICMP types
        listed by number for easy SNMP parsing
5) modify /proc/net/snmp printing for "Icmp" to get the named data
        from new counters.
[new to 2nd revision]
6) support per-interface ICMP stats
7) use common macro for per-device stat macros
Signed-off-by: NDavid L Stevens <dlstevens@us.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      14878f75
    • E
      [NET]: Make device event notification network namespace safe · e9dc8653
      由 Eric W. Biederman 提交于 
      Every user of the network device notifiers is either a protocol
stack or a pseudo device.  If a protocol stack that does not have
support for multiple network namespaces receives an event for a
device that is not in the initial network namespace it quite possibly
can get confused and do the wrong thing.

To avoid problems until all of the protocol stacks are converted
this patch modifies all netdev event handlers to ignore events on
devices that are not in the initial network namespace.

As the rest of the code is made network namespace aware these
checks can be removed.
Signed-off-by: NEric W. Biederman <ebiederm@xmission.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      e9dc8653
  21. 08 10月, 2007 1 次提交
    • B
      [IPv6]: Fix ICMPv6 redirect handling with target multicast address · bf0b48df
      由 Brian Haley 提交于 
      When the ICMPv6 Target address is multicast, Linux processes the 
redirect instead of dropping it.  The problem is in this code in 
ndisc_redirect_rcv():

         if (ipv6_addr_equal(dest, target)) {
                 on_link = 1;
         } else if (!(ipv6_addr_type(target) & IPV6_ADDR_LINKLOCAL)) {
                 ND_PRINTK2(KERN_WARNING
                            "ICMPv6 Redirect: target address is not 
link-local.\n");
                 return;
         }

This second check will succeed if the Target address is, for example, 
FF02::1 because it has link-local scope.  Instead, it should be checking 
if it's a unicast link-local address, as stated in RFC 2461/4861 Section 
8.1:

       - The ICMP Target Address is either a link-local address (when
         redirected to a router) or the same as the ICMP Destination
         Address (when redirected to the on-link destination).

I know this doesn't explicitly say unicast link-local address, but it's 
implied.

This bug is preventing Linux kernels from achieving IPv6 Logo Phase II 
certification because of a recent error that was found in the TAHI test 
suite - Neighbor Disovery suite test 206 (v6LC.2.3.6_G) had the 
multicast address in the Destination field instead of Target field, so 
we were passing the test.  This won't be the case anymore.

The patch below fixes this problem, and also fixes ndisc_send_redirect() 
to not send an invalid redirect with a multicast address in the Target 
field.  I re-ran the TAHI Neighbor Discovery section to make sure Linux 
passes all 245 tests now.
Signed-off-by: NBrian Haley <brian.haley@hp.com>
Acked-by: NDavid L Stevens <dlstevens@us.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      bf0b48df
  23. 11 9月, 2007 1 次提交
  25. 23 6月, 2007 1 次提交
  27. 26 4月, 2007 11 次提交
  29. 11 2月, 2007 1 次提交
  31. 31 1月, 2007 1 次提交
    • L
      [IPV6]: fix BUG of ndisc_send_redirect() · 29556526
      由 Li Yewang 提交于 
        When I tested IPv6 redirect function about kernel 2.6.19.1, and found
that the kernel can send redirect packets whose target address is global
address, and the target is not the actual endpoint of communication.

  But the criteria conform to RFC2461, the target address defines as
following:

  Target Address An IP address that is a better first hop to use for
                 he ICMP Destination Address.  When the target is
                 the actual endpoint of communication, i.e., the
                 destination is a neighbor, the Target Address field
                 MUST contain the same value as the ICMP Destination
                 Address field.  Otherwise the target is a better
                 first-hop router and the Target Address MUST be the
                 router's link-local address so that hosts can
                 uniquely identify routers.

According to this definition, when a router redirect to a host, the
target address either the better first-hop router's link-local address
or the same as the ICMP destination address field. But the function of
ndisc_send_redirect() in net/ipv6/ndisc.c, does not check the target
address correctly.

There is another definition about receive Redirect message in RFC2461:

8.1.  Validation of Redirect Messages

   A host MUST silently discard any received Redirect message that does
   not satisfy all of the following validity checks:
   ......
   - The ICMP Target Address is either a link-local address (when
     redirected to a router) or the same as the ICMP Destination
     Address (when redirected to the on-link destination).
   ......

And the receive redirect function of ndisc_redirect_rcv() implemented
this definition, checks the target address correctly.
    if (ipv6_addr_equal(dest, target)) {
        on_link = 1;
    } else if (!(ipv6_addr_type(target) & IPV6_ADDR_LINKLOCAL)) {
        ND_PRINTK2(KERN_WARNING
               "ICMPv6 Redirect: target address is not link-local.\n");
        return;
    }

So, I think the send redirect function must check the target address
also.
Signed-off-by: NLi Yewang <lyw@nanjing-fnst.com>
Acked-by: NYOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      29556526
  33. 11 12月, 2006 1 次提交
  35. 03 12月, 2006 2 次提交