- 22 5月, 2012 1 次提交
-
-
由 Adam Jackson 提交于
(airlied: v2: fix missing struct - fixes compile) Signed-off-by: NAdam Jackson <ajax@redhat.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-
- 22 3月, 2012 1 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 13 3月, 2012 6 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
GF119 will use this too. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Off-chip encoders (which we don't support yet anyway), and newer chipsets (such as NVD9...), will need their own code for this. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
More code to do the same thing, but will make it easier to handle various changes that could possibly happen the the VBIOS tables. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Xi Wang 提交于
The comparison (lpre == DP_TRAIN_PRE_EMPHASIS_9_5) is always false: lpre is initialized as (lane & 0x0c) >> 2, which is at most 3, while DP_TRAIN_PRE_EMPHASIS_9_5 is defined as (3 << 3). Signed-off-by: NXi Wang <xi.wang@gmail.com> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 21 12月, 2011 4 次提交
-
-
由 Ben Skeggs 提交于
- moves out of nouveau_bios.c and demagics the logical state definitions - simplifies chipset-specific driver interface - makes most of gpio irq handling common, will use for nv4x hpd later - api extended to allow both direct gpio access, and access using the logical function states - api extended to allow for future use of gpio extender chips - pre-nv50 was handled very badly, the main issue being that all GPIOs were being treated as output-only. - fixes nvd0 so gpio changes actually stick, magic reg needs bashing Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Another case where we parsed vbios data to some structs, then again use that info once to construct another set of data. Skip the intermediate step. This is also slightly improved in that we can now use DCB 3.x connector table info, which will allow NV4x to gain hotplug support, and to make quirks for SPWG LVDS panels unnecessary. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Was using nv_mask, which is bad. Reading the reg senses the current line states, which aren't necessarily the states we're trying to drive the lines to. Fixed to store SCL driver state just as we already do for SDA. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 20 9月, 2011 13 次提交
-
-
由 Ben Skeggs 提交于
Written from observations of my NVD9's vbios, completely untested due to my NVD9 lacking actual DisplayPort connectors.. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Will need to be able to distinguish 2.0/2.1 from 3.0 soon. Also, move the vbios parsing to nouveau_dp where it belongs. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Naturally... Because Macs can't just be the same as everything else now can they? Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Not hardcoded as originally thought. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Not used currently, but it will be used in preference to pre-determined lane/bandwidth numbers at a later point. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 25 2月, 2011 1 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 03 12月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
Allows callers to install their own handlers for when a GPIO line changes state (such as for hotplug detect). This also fixes a bug where we weren't acknowledging the GPIO IRQ until after the bottom half had run, causing a severe IRQ storm in some cases. Reviewed-by: NFrancisco Jerez <currojerez@riseup.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 05 10月, 2010 2 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Reported-by: NAdam Jackson <ajax@redhat.com> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 24 9月, 2010 1 次提交
-
-
由 Francisco Jerez 提交于
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 06 8月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
This makes it easier to see how this is working, and lets us transfer the EDID in blocks of 16 bytes. The primary reason for this change is because debug logs are rather hard to read with the hundreds of single-byte auxch transactions that occur. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 26 7月, 2010 2 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 13 7月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 09 4月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
There's one known case where we never stop recieving DEFER, and loop here forever. Lets not do that.. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 09 2月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
Writes don't return a count, and adding the check broke native DP. Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 25 1月, 2010 1 次提交
-
-
由 Ben Skeggs 提交于
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 16 12月, 2009 1 次提交
-
-
由 Maarten Maathuis 提交于
- Use driver level (0x2) for NV_DEBUG instead of all levels - Create a NV_DEBUG_KMS for KMS level (0x4) and use them in modesetting code - Remove a few odd NV_TRACE calls and replace some of them with NV_DEBUG_KMS or NV_INFO Signed-off-by: NMaarten Maathuis <madman2003@gmail.com> Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
-
- 11 12月, 2009 1 次提交
-
-
由 Ben Skeggs 提交于
This adds a drm/kms staging non-API stable driver for GPUs from NVIDIA. This driver is a KMS-based driver and requires a compatible nouveau userspace libdrm and nouveau X.org driver. This driver requires firmware files not available in this kernel tree, interested parties can find them via the nouveau project git archive. This driver is reverse engineered, and is in no way supported by nVidia. Support for nearly the complete range of nvidia hw from nv04->g80 (nv50) is available, and the kms driver should support driving nearly all output types (displayport is under development still) along with supporting suspend/resume. This work is all from the upstream nouveau project found at nouveau.freedesktop.org. The original authors list from nouveau git tree is: Anssi Hannula <anssi.hannula@iki.fi> Ben Skeggs <bskeggs@redhat.com> Francisco Jerez <currojerez@riseup.net> Maarten Maathuis <madman2003@gmail.com> Marcin Kościelnicki <koriakin@0x04.net> Matthew Garrett <mjg@redhat.com> Matt Parnell <mparnell@gmail.com> Patrice Mandin <patmandin@gmail.com> Pekka Paalanen <pq@iki.fi> Xavier Chantry <shiningxc@gmail.com> along with project founder Stephane Marchesin <marchesin@icps.u-strasbg.fr> Signed-off-by: NBen Skeggs <bskeggs@redhat.com> Signed-off-by: NDave Airlie <airlied@redhat.com>
-