Both arch/powerpc/platforms/cell/iommu.c and arch/powerpc/platforms/ps3/mm.c
contain the same Cell IOMMU page table entry definitions. Extract them and move
them to <asm/iommu.h>, while adding a CBE_ prefix.
This also allows them to be used by drivers.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>

Create a real RTC driver for PS3, and unhook the deprecated
ppc_md.[gs]et_rtc_time.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Acked-by: NAlessandro Zummo <a.zummo@towertech.it>
Acked-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NKyle McMartin <kyle@mcmartin.ca>

Add repository routines for the PS3 Logical Performance Monitor.
Signed-off-by: NTakashi Yamamoto <TakashiA.Yamamoto@jp.sony.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

PS3: Kill unused routine ps3_repository_bump_device().
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

The PS3 hypervisor has a storage device notification mechanism to wait
until a storage device is ready.  Unfortunately the storage device
probing code used this mechanism in an incorrect way, needing a
polling loop and handling of devices that are not yet ready.

This change corrects this by:
  - First waiting for the reception of an asynchronous notification
    that a new storage device became ready,
  - Then looking up the storage device in the device repository.

On shutdown, the storage probe thread is stopped and the storage
notification device is closed using a reboot notifier.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

The storage probe feature of the PS3 hypervisor returns device IDs.  Add
the corresponding repository routine ps3_repository_find_device_by_id()
which can be used to retrieve the device info from the repository.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Change the PS3 bus_id and dev_id from type unsigned int to u64.  These
IDs are 64-bit in the repository, and the special storage notification
device has a device ID of ULONG_MAX.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Add the PS3 os-area startup params to the device tree.  This allows
a second stage kernel loaded with kexec to use these values.
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Updates for PS3 os-area rtc_diff set/get routines
o Add a new routine ps3_os_area_set_rtc_diff().
o Rename ps3_os_area_rtc_diff() to ps3_os_area_get_rtc_diff().
o Remove static variable rtc_shift with calls to ps3_os_area_get_rtc_diff().
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Updates for PS3 os-area startup params
o Remove some unused PS3 os-area startup params from struct saved_params.
o Rename ps3_os_area_init() to ps3_os_area_save_params().
o Zero mirrored header after saving params.
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Currently, the ps3 kernel fails to build without smp but with kexec, as
ps3_kexec_cpu_down needs ps3_smp_cleanup_cpu, which isn't defined on UP
kernels. This change adds an empty ps3_smp_cleanup_cpu for UP kernels.

Booted on ps3.
Signed-off-by: NJeremy Kerr <jk@ozlabs.org>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

On PS3, A storage device may show up in the repository before the hypervisor
has finished probing:
  - If its type is not yet known, it shows up as PS3_DEV_TYPE_STOR_DUMMY,
  - If its regions are being probed, it shows up as having zero regions.
If any of these happen, consider the device not yet present.  The storage
probe thread will retry later.

This fixes the timing-dependent problem where a kernel booted from FLASH ROM
sometimes cannot find the hard disk.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Acked-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Repository updates:
  - Extract ps3_repository_find_bus() from ps3_repository_find_device(), as the
    storage driver needs it.
  - Make ps3_repository_find_device() return -ENODEV if a device is not found,
    just like if a bus is not found.
  - Add ps3_repository_read_vuart_sysmgr_port() and
    ps3_repository_read_vuart_av_port() to get vuart port info.
  - Add device enumeration routines ps3_repository_find_device() and
    ps3_repository_find_devices().
  - Cleanup debug routines.
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Rework the PS3 system bus to unify device support.
 - DMA region sizes must be a power of two
 - storage bus DMA updates:
  - Small fixes for the PS3 DMA core:
      o fix alignment bug
      o kill superfluous test
      o indentation
      o spelling
      o export ps3_dma_region_{create,free}()
  - ps3_dma_region_init():
      o Add `addr' and `len' parameters, so you can create a DMA region that
        does not cover all memory (use `NULL' and `0' to cover all memory).
	This is needed because there are not sufficient IOMMU resources to have
	all DMA regions cover all memory.
      o Uninline
  - Added remove and shutdown routines to all drivers.
  - Added loadable module support to all drivers.
  - Added HV calls for iopte management (needed by sound driver).
Signed-off-by: NMOKUNO Masakazu <mokuno@sm.sony.co.jp>
Signed-off-by: NGeert Uytterhoeven <Geert.Uytterhoeven@sonycom.com>
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Fixup the core platform parts needed for kexec to work on the PS3.
 - Setup ps3_hpte_clear correctly.
 - Mask interrupts on irq removal.
 - Release all hypervisor resources.
 - Create new routine ps3_shutdown_IRQ()
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Move the PS3 system bus routines from drivers/ps3 to
arch/powerpc/platforms/ps3.
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Acked-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Acked-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Adds spu support for the PS3 platform.
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>

Adds the core platform support for the PS3 game console and other devices
using the PS3 hypervisor.
Signed-off-by: NGeoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>