1. 17 4月, 2008 1 次提交
    • R
      mlx4_core: Fix confusion between mlx4_event and mlx4_dev_event enums · 37608eea
      Roland Dreier 提交于
      The struct mlx4_interface.event() method was supposed to get an enum
      mlx4_dev_event, but the driver code was actually passing in the
      hardware enum mlx4_event values.  Fix up the callers of
      mlx4_dispatch_event() so that they pass in the right type of value,
      and fix up the event method in mlx4_ib so that it can handle the enum
      mlx4_dev_event values.
      
      This eliminates the need for the subtype parameter to the event
      method, so remove it.
      
      This also fixes the sparse warning
      
          drivers/net/mlx4/intf.c:127:48: warning: mixing different enum types
          drivers/net/mlx4/intf.c:127:48:     int enum mlx4_event  versus
          drivers/net/mlx4/intf.c:127:48:     int enum mlx4_dev_event
      Signed-off-by: NRoland Dreier <rolandd@cisco.com>
      37608eea
  2. 05 2月, 2008 2 次提交
  3. 10 10月, 2007 2 次提交
  4. 13 7月, 2007 2 次提交
  5. 10 7月, 2007 1 次提交
  6. 22 6月, 2007 1 次提交
  7. 18 6月, 2007 1 次提交
    • R
      IB/mlx4: Handle FW command interface rev 3 · 5ae2a7a8
      Roland Dreier 提交于
      Upcoming firmware introduces command interface revision 3, which
      changes the way port capabilities are queried and set.  Update the
      driver to handle both the new and old command interfaces by adding a
      new MLX4_FLAG_OLD_PORT_CMDS that it is set after querying the firmware
      interface revision and then using the correct interface based on the
      setting of the flag.
      Signed-off-by: NRoland Dreier <rolandd@cisco.com>
      5ae2a7a8
  8. 15 5月, 2007 1 次提交
  9. 09 5月, 2007 1 次提交
    • R
      IB/mlx4: Add a driver Mellanox ConnectX InfiniBand adapters · 225c7b1f
      Roland Dreier 提交于
      Add an InfiniBand driver for Mellanox ConnectX adapters.  Because
      these adapters can also be used as ethernet NICs and Fibre Channel 
      HBAs, the driver is split into two modules: 
       
        mlx4_core: Handles low-level things like device initialization and 
          processing firmware commands.  Also controls resource allocation 
          so that the InfiniBand, ethernet and FC functions can share a 
          device without stepping on each other. 
       
        mlx4_ib: Handles InfiniBand-specific things; plugs into the 
          InfiniBand midlayer. 
      Signed-off-by: NRoland Dreier <rolandd@cisco.com>
      225c7b1f