- 02 12月, 2008 1 次提交
-
-
由 Stelian Pop 提交于
The AT91CAP9 revC CPU has a few differences over the previous, revB CPU which was distributed in small quantities only (revA was an internal Atmel product only). This patch adds the detection routines to recognize the different AT91CAP9 revisions (based on the PMC subsystem version number), and uses them to: - activate a workaround for the external interrupts levels (on revB CPUs) - set the UDPHS_BYPASS bit (on revB CPUs) - set AT91_GPBR register address to the correct offset (0xfffffd50 on revB, 0xfffffd60 on revC) For debugging usage, the CPU revision can be found in /proc/cpuinfo on the 'Revision' line. This patch is extracted from Andrew Victor's -at91 patch (2.6.27-at91.patch) where it has been tested for the last 6 months. Signed-off-by: NStelian Pop <stelian@popies.net> Signed-off-by: NAndrew Victor <linux@maxim.org.za> Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 07 8月, 2008 1 次提交
-
-
由 Russell King 提交于
This just leaves include/asm-arm/plat-* to deal with. Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 02 6月, 2008 1 次提交
-
-
由 Stelian Pop 提交于
This is patch 2 of 2 adding support for the USB High Speed Device Port on the AT91CAP9 system on chip. The AT91CAP9 uses the same UDPHS IP as the AVR32 and the AT91SAM9RL. This patch declares the UDPHS ressources in the at91cap9 (cpu and adk board) files, wires up the atmel_usba_udc driver to them, and activates the driver in the defconfig. Signed-off-by: NStelian Pop <stelian@popies.net> Acked-by: NHaavard Skinnemoen <hskinnemoen@atmel.com> Acked-by: NAndrew Victor <linux@maxim.org.za> Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 20 3月, 2008 1 次提交
-
-
由 Andrew Victor 提交于
Define AT91_USART0, 1, 2 so the selection of the UART for early kernel messages works. (See commit fa3218d8). Replace AT91_SHDC with AT91_SHDWC to be consistent with other AT91 platforms. Signed-off-by: NAndrew Victor <linux@maxim.org.za> Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-
- 26 1月, 2008 1 次提交
-
-
由 Andrew Victor 提交于
Add support for Atmel's AT91CAP9 Customizable Microcontroller family. <http://www.atmel.com/products/AT91CAP/Default.asp> Signed-off-by: NStelian Pop <stelian@popies.net> Signed-off-by: NAndrew Victor <linux@maxim.org.za> Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
-