I simply forgot to remove this entry although all Realtek quirks have
been dropped.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The Lenovo Ideapad S205 has an internal mic where the right channel
is phase inverted.

BugLink: https://bugs.launchpad.net/bugs/884652Signed-off-by: NDavid Henningsson <david.henningsson@canonical.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The codec ALC272X is a special codec for some Dell machines, and its
detection got broken in the recent kernel because SSID check (required
by ALC272X check) was moved to the later point.  Now we need to move
this codec check to the right place, too.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This addresses an issue encountered when a pcm is opened while
transitioning to low power state (codec->power_on == 1 &&
codec->power_transition == -1).  Add snd_pcm_power_up_d3wait to
hda_codec.  This function is used to power up from azx_open as opposed
to snd_hda_power_up used from codec_exec_verb. When powering up from
azx_open, wait for pending power downs to complete, avoiding the power
up continuing in parallel with the power down on the work queue.

The specific issue seen was with the CS4210 codec, it powers off the ADC
and DAC nid in its suspend handler.  If it is re-opened before the
~100ms power down process completes, the ADC and DAC nid are initialized
while powered down and audio is lost until another suspend/resume cycle.
Signed-off-by: NDylan Reid <dgreid@chromium.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

During the split to the auto-parser helper functions, the actual call
of init verbs was lost.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=43366Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Pin 0x1b was connected to the front panel connector, which according to
the HDA standard should contain a mic and a headphone. In this case,
the headphone was listed as "line out" by BIOS.

Cc: stable@kernel.org
BugLink: https://bugs.launchpad.net/bugs/993162Signed-off-by: NDavid Henningsson <david.henningsson@canonical.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The PCI ID entries of Creative SoundCore3D HD-audio controllers should
be before the wildcard for vendor = Creative.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When VGA_SWITCHEROO support is enabled hda_intel initialises the HDMI
audio device on the current VGA device.  When it's not enabled it only
initialises the HDMI device on the default VGA adaptor, this means
secondary cards get no audio support which is very unhelpful for
multi-seat!

With this patch, when SUPPORT_VGA_SWITCHEROO is disabled hda_intel
initialises all HDMI audio devices, not just the default VGA.

[minor optimizations by tiwai]
Signed-off-by: NSteven Newbury <steve@snewbury.org.uk>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When VGA-switcheroo is built in but unused on systems with multiple
graphics cards, the initializations of non-default graphics cards are
skipped and never enabled (because the switcheroo is activated only
when the controller supports).  The current behavior is for avoiding
the system lockup by accessing the disabled GPU, but due to the recent
change in VGA-switcheroo, it determines the state simply by checking
with the default VGA device.  This is the culprit.

Now with the new vga_switcheroo_get_client_state(), we can know the
initial state of the bound GPU, thus can determine the initial audio
client state more correctly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

On PCI RME MADI cards, the PLL register does not contain the proper
value, so the calculated system_sample_rate is wrong. In this case, we
simply return the cached rate from struct hdspm.
Signed-off-by: NAdrian Knoth <adi@drcomp.erfurt.thur.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Also fix some settings applied only for ALC269VB.
Signed-off-by: NKailang Yang <kailang@realtek.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Like the previous fixes for cache hash accesses, a protection over
accesses to the widget connection list array must be provided.
Together with this action, remove snd_hda_get_conn_list() which can be
always race, and replace it with either snd_hda_get_num_conns() or
snd_hda_get_connections() calls.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

There is an spin_unlock() missing on this error path.
Signed-off-by: NDan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

For avoiding unnecessary codec read/write verbs at each jack detection.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Turn off the power-map for unused ports and check the jack-detection
capability in the first place.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The hints regarding the mute-LED must be evaluated during the codec
parsing.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch just sets the codec probe_mask=0x101 value for the WinFast VP200 H
PCoIP card based on Teradici hardware matching the PCI subsystem vendor/device
IDs 3a21:040d. The user reported no codec detection issues without this
explicit codec configuration.
Signed-off-by: NJaroslav Kysela <perex@perex.cz>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

BIOS on some HP laptops don't set the speaker-pins as fixed but expose
as jacks, and this confuses the driver as if these pins are
jack-detectable.  As a result, the machine doesn't get sounds from
speakers because the driver prepares the power-map update via jack
unsol events which never come up in reality.  The bug was introduced
in some time in 3.2 for enabling the power-mapping feature.

This patch fixes the problem by replacing the check of the persistent
power-map bits with a proper is_jack_detectable() call.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=43240

Cc: <stable@vger.kernel.org> [v3.2+]
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add the support for VGA-switcheroo in the HD-audio controller side.
When the graphics controller is disabled, the HD-audio driver also delays
the initialization until it's activated by VGA-switcheroo.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=43155Signed-off-by: NTakashi Iwai <tiwai@suse.de>

It's a preliminary work for the vga-switcher support.
Export the function to do pseudo-lock for the sound card to be used
in other places.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When a discrete-GPU is disabled by the VGA switcheroo, the
corresponding HD-audio controller for HDMI output is also disabled.
Such a dead controller still appears in the PCI device list, but you
can't access properly any longer (even calling pci_read_config_*()
triggers Oops!) which leads the stall of the whole communication of
the driver.

This patch adds a check of graphics controller at the probe time to
see whether it's disabled by vga-switcheroo.  If disabled, skip the
whole initialization of this controller.

Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=43155Signed-off-by: NTakashi Iwai <tiwai@suse.de>

It turned out that the FLOAT format on CS4206 results in simple
noises, which implies that this is no right format as is.
Since CS4206 is the only codec supporting the float, let's disable it
until we find the correct format.
Reported-and-tested-by: NAdrian Knoth <adi@drcomp.erfurt.thur.de>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Never trust datasheet...
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The amp and caps hashes aren't protected properly for concurrent
accesses.  Protect them via a new mutex now.

But it can't be so simple as originally thought: since the update of a
hash table entry itself might trigger the power-up sequence which
again accesses the hash table, we can't cover the whole function
simply via mutex.  Thus the update part has to be split from the mutex
and revalidated.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add the missing mutex protection or move into the protected part for
SPDIF access codes for codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

These are almost compatible with the older Conexant codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The controller is compatible with HD-audio 1.0a with some specific
restrictions.
- The BDLE entries can't be over 4k boundary
- No position-buffer and no MSI
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Check the power_transition up/down state instead of boolean bit, so
that the power-up sequence can cancel the pending power-down work
properly.  Also, by moving cancel_delayed_work_sync() before the
actual power-up sequence, make sure that the delayed power-down is
completed.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Since the recent commit, the resume procedure is always performed at
the resume time.  This makes the pre_resume hack for VREF mute LED on
some HP laptops superfluous.  As this is the only user of pre_resume
(and there is no user of post_suspend) ops, let's kill them again.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When an IRQ for some reason gets lost, we wait up to a second using
udelay, which is CPU intensive. This patch improves the situation by
waiting about 30 ms in the CPU intensive mode, then stepping down to
using msleep(2) instead. In essence, we trade some granularity in
exchange for less CPU consumption when the waiting time is a bit longer.

As a result, PulseAudio should no longer be killed by the kernel
for taking up to much RT-prio CPU time. At least not for *this* reason.
Signed-off-by: NDavid Henningsson <david.henningsson@canonical.com>
Tested-by: NArun Raghavan <arun.raghavan@collabora.co.uk>
Cc: <stable@kernel.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Just code shuffles.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Move the fixup helper functions in patch_realtek.c to hda_auto_parser.c
so that they can be used in other codec drivers like patch_conexant.c.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

To avoid some races.  Still not perfect, but now a bit safer.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Some power-saving states have been left unchanged in
snd_hda_codec_reset(), and this is a potential danger because the
function may be called in various situations including the continuous
operation after that call.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This is a fix for the problem in commit 785f857d, the pop noise
issue on some machines with ALC269.  The problem was the uninitialized
state after the resume due to the delayed resume of the codec chips.
In that commit, we tried to fix by forcibly putting the codec to D3 at
suspend.  But, this still also leaves the uninitialized state after
resume, and it _might_ be still problematic with some BIOS.  Since the
commit turned out to regress another issues, we reverted it in the
end.

Now, in this fix, try to fix by turning on the codec immediately at
the resume path.  We need to take care of the power-saving in this
case.  When the device is woken up at the power-saved state, it should
go power-saving again after the resume.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The work struct must be initialized before the possible call in the
destructor.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Just a clean up by calling the same helper function.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This reverts commit 785f857d.

The commit causes a problem with the wrong D3 state after suspend
because the call of hda_set_power_state() involves with the power-up
sequence, which changes the power_count, and this confuses the resume
sequence that checks the power_count as well.

Originally, this go-to-D3 sequence should be a simple task without the
power-up sequence.  But, it'd need some proper sanity checks in the
case of power-saved state, so it's not too easy to write now in the
3.4-rc cycle.

In short, the safest option now is to revert this affecting commit.

Of course, we need to clean up and robustify the power-saving code
better for 3.5 kernel.
Reported-by: NKonstantin Khlebnikov <khlebnikov@openvz.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The call for alc_auto_parse_customize_define() must be done after the
fixup pre-probe initialization.  Otherwise SKU_IGNORE fixup won't work
properly (e.g. HP RP5800 with ALC662 codec).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>