This patch adds code to parse and setup the crash kernel resource in the
first kernel. PPC64 ignores the @x part, we always run at 32 MB.
Signed-off-by: NHaren Myneni <haren@us.ibm.com>
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Regardless of where the kernel's linked we always get interrupts at low
addresses. This patch creates a trampoline in the first 3 pages of memory,
where interrupts land, and patches those addresses to jump into the real
kernel code at PHYSICAL_START.

We also need to reserve the trampoline code and a bit more in prom.c
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

These are needed by the TPM driver, apparently.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This also make klimit have the same type on 32-bit as on 64-bit,
namely unsigned long, and defines and initializes it in one place.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Signed-off-by: NStephen Rothwell <sfr@canb.auug.org.au>

This patch merges platform codes.  systemcfg->platform is no longer used,
systemcfg use in general is deprecated as much as possible (and renamed
_systemcfg before it gets completely moved elsewhere in a future patch),
_machine is now used on ppc64 along as ppc32.  Platform codes aren't gone
yet but we are getting a step closer. A bunch of asm code in head[_64].S
is also turned into C code.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This adds code to work around some problems with old versions of
Open Firmware, such as on the early powermacs (7500 etc.) and the
"Longtrail" CHRP machine.  On these machines we have to claim
the physical and virtual address ranges explicitly when claiming
memory and then set up a V->P mapping.

The Longtrail has more problems: setprop doesn't work, and we have
to set an "allow-reclaim" variable to 0 in order to get claim on
physical memory ranges to fail if the memory is already claimed.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This patch adds the ability to the SMU driver to recover missing
calibration partitions from the SMU chip itself. It also adds some
dynamic mecanism to /proc/device-tree so that new properties are visible
to userland.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Adds a new CONFIG_PPC_64K_PAGES which, when enabled, changes the kernel
base page size to 64K.  The resulting kernel still boots on any
hardware.  On current machines with 4K pages support only, the kernel
will maintain 16 "subpages" for each 64K page transparently.

Note that while real 64K capable HW has been tested, the current patch
will not enable it yet as such hardware is not released yet, and I'm
still verifying with the firmware architects the proper to get the
information from the newer hypervisors.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

There's some debugging in prom.c that wraps nastly on 80 character
terminals, reformat it to fit.
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>

We had a static memory_limit in prom.c, and then another one defined
in setup_64.c and used in numa.c, which resulted in the kernel crashing
when mem=xxx was given on the command line.  This puts the declaration
in system.h and the definition in mem.c.  This also moves the
definition of tce_alloc_start/end out of setup_64.c.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Untested, but "should" work...  at least this way it compiles.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

The interrupt-tree parsing code wasn't offsetting interrupt numbers
by 16 on 32-bit platforms with an i8259 interrupt controller, and
it was confused about the encoding of interrupt sense and level
(which is different for i8259 and openpic interrupt controllers,
just to make things interesting).
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This splits arch/ppc64/kernel/rtas.c into arch/powerpc/kernel/rtas.c,
which contains generic RTAS functions useful on any CHRP platform,
and arch/powerpc/platforms/pseries/rtas-fw.[ch], which contain
some pSeries-specific firmware flashing bits.  The parts of rtas.c
that are to do with pSeries-specific error logging are protected
by a new CONFIG_RTAS_ERROR_LOGGING symbol.  The inclusion of rtas.o
is controlled by the CONFIG_PPC_RTAS symbol, and the relevant
platforms select that.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

On !CONFIG_PPC_MULTIPLATFORM _machine is defined as 0.  This is ok, but
we can't assign a value to _machine then.

We may not have CONFIG_PCI available, so only build in support for
find_parent_pci_resource(), request_OF_resource(), release_OF_resource()
if PCI is enabled.  This is probably not the long term fix but works out
for now.

Make reg_property64 contain 64-bit elements on a 32-bit machine.

Mark the deprecated prom.c functions as __deprecated.
Signed-off-by: NKumar K. Gala <kumar.gala@freescale.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Old powermacs have a number of differences from current machines:
- there is no interrupt tree in the device tree, just interrupt
  or AAPL,interrupt properties
- the chosen node in the device tree is called /chosen@0
- the OF claim method doesn't map the memory, so we have to do
  an explicit map call as well
- there is no /chosen/cpu property on SMP machines
- the NVRAM isn't structured as a set of partitions.

This adapts the merged powermac support code to cope with these
issues.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

We weren't computing the size of the hash table correctly on iSeries
because the relevant code in prom.c was #ifdef CONFIG_PPC_PSERIES.
This moves the code to hash_utils_64.c, makes it unconditional, and
cleans it up a bit.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This is a bunch of mostly small fixes that are needed to get
ARCH=powerpc to compile for 64-bit.  This adds setup_64.c from
arch/ppc64/kernel/setup.c and locks.c from arch/ppc64/lib/locks.c.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This brings in the ppc64 version of prom_init.c, prom.c and btext.c
and makes them work for ppc32.  This also brings in the new calling
convention, where the first entry to the kernel (with r5 != 0) goes
to the prom_init code, which then restarts from the beginning (with
r5 == 0) after it has done its stuff.

For now this also brings in the ppc32 version of setup.c.  It also
merges lmb.h.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This patch pulls the PCI-related junk out of struct device_node and
puts it in a separate structure, struct pci_dn.  The device_node now
just has a void * pointer in it, which points to a struct pci_dn for
nodes that represent PCI devices.  It could potentially be used in
future for device-specific data for other sorts of devices, such as
virtual I/O devices.
Signed-off-by: NPaul Mackerras <paulus@samba.org>

Changing CONFIG_LOCALVERSION rebuilds too much, for no apparent reason.

Use system_utsname for progress and debug header.
Signed-off-by: NOlaf Hering <olh@suse.de>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

unflatten_device_tree() doesn't check if lmb_alloc() succeeds or not, it
should. All it can do is panic, but at least there's an error message
(assuming you have some sort of console at that point).
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>

 arch/ppc64/kernel/prom.c |    9 +++++++--
 1 files changed, 7 insertions(+), 2 deletions(-)
Signed-off-by: NPaul Mackerras <paulus@samba.org>

When unflatten_dt_node() fails to find an OF_DT_END_NODE tag it prints
"Weird tag at start of node", this should be "Weird tag at end of node".
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>

 arch/ppc64/kernel/prom.c |    2 +-
 1 files changed, 1 insertion(+), 1 deletion(-)
Signed-off-by: NPaul Mackerras <paulus@samba.org>

This patch updates the format of the flattened device-tree passed
between the boot trampoline and the kernel to support a more compact
representation, for use by embedded systems mostly.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

The code that sets the altivec capability of the CPU based on firmware
informations can enable altivec when the kernel has CONFIG_ALTIVEC
disabled.  This results in "interesting" crashes.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Paul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Allow the SMT bit to be set/reset at boot, like the ALTIVEC bit.  This
means we will enable SMT on unknown cpus that support it.
Signed-off-by: NAnton Blanchard <anton@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The code in unflatten_device_tree knows that get_property is written to
only return with lenp equal to 1 when also returning a valid pointer.
The gcc 3.3.3 compiler is not able to prove this to itself, so it warns
about a possible uninitialized pointer dereference:

 .../arch/ppc64/kernel/prom.c: In function `unflatten_device_tree':
 .../arch/ppc64/kernel/prom.c:828:
 warning: `p' might be used uninitialized in this function

Unless it is desired to rework the interaction between the two
functions, this will keep the existing behavior but quiet the compiler.
Signed-off-by: NAmos Waterland <apw@us.ibm.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

When I tried Ben's patches to the powermac sound driver on my G5, I found
that it was taking enormous numbers of sound DMA transmit interrupts.  This
turned out to be because it was incorrectly configured as level-sensitive
instead of edge-sensitive, which in turn was because the code that parses
the interrupt tree that Open Firmware gives us was incorrectly assigning
another device the same irq number as the sound DMA transmit interrupt
(i.e.  1).

This patch fixes the problem, in a somewhat quick and dirty way for now,
but one which will work for all the machines we currently run on.
Ultimately Ben and I want to do something more general and robust, but this
should go in for 2.6.12.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The code that parses the OF device tree contains an old bogus hack which
was killed a long time ago on ppc32, but survived in ppc64.  It was
supposed to help with a problem on the f50 which is ...  a 32 bits machine
:) Additionally, that hack is causing problems, so let's just get rid of
it.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch adds detection of the Altivec capability of the CPU via the
firmware in addition to the cpu table.  This allows newer CPUs that aren't
in the table to still have working altivec support in the kernel.

It also fixes a problem where if a CPU isn't recognized as having altivec
features, and takes an altivec unavailable exception due to userland
issuing altivec instructions, the kernel would happily enable it and
context switch the registers ...  but not all of them (it would basically
forget vrsave).  With this patch, the kernel will refuse to enable altivec
when the feature isn't detected for the CPU (SIGILL).
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!