No longer used.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Delete all of the code working with sp_banks[] and replace
with clean acquisition and sorting of physical memory
parameters from the firmware.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Need to make sure the address is below high_memory before
passing it to kern_addr_valid().
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Thus, we can mark sp_banks[] static in arch/sparc64/mm/init.c
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Also, move prom_probe_memory() into arch/sparc64/mm/init.c
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Instead of doing byte-at-a-time user accesses to figure
out where the fault occurred, read the saved fault_address
from the current thread structure.

For the sake of defensive programming, if the fault_address
does not fall into the user buffer range, simply assume the
whole area faulted.  This will cause the fixup for
copy_from_user() to clear the entire kernel side buffer.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

We were not calling kernel_mna_trap_fault() correctly.
Instead of being fancy, just return 0 vs. -EFAULT from
the assembler stubs, and handle that return value as
appropriate.

Create an "__retl_efault" stub for assembler exception
table entries and use it where possible.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The funny "range" exception table entries we had were only
used by the compat layer socketcall assembly, and it wasn't
even needed there.

For free we now get proper exception table sorting and fast
binary searching.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The in-memory value was being swapped, not the value we
loaded into the register.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Also, the us3_cpufreq driver can work on Ultra-IV and IV+.
They use the SAFARI bus register to control the clock divider
just like Ultra-III and III+ do.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

We ignored umask when creating new queues via mq_open (when creating
with open() on mqueue fs it is ok of course).  According to the
specification this a bug.  This trivial patch fixes this.
Signed-off-by: NKrzysztof Benedyczak <golbi@mat.uni.torun.pl>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Fix interrupt test handler by adding check for IRQ assertion in
PCI_STATE register in addition to the status block updated bit.

Add test for valid ethernet address in tg3_set_mac_addr().

Add tg3_bus_string() to setup the PCI bus speed/width string for all
PCI/PCIX/PCI Express devices. This is used to print the bus type
during init_one().
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Fix 5780 PHY related problems:

1. MAC_RX_MODE reset must be done before setting up the MAC_MODE
   register on 5705_PLUS chips or the chip will stop receiving after
   a while. The MAC_RX_MODE reset is needed to prevent intermittently
   losing the first receive packet on serdes chips.

2. Skip MAC loopback test on 5780 because of hardware errata. Normal
   traffic including PHY loopback is not affected by the errata.

3. PHY loopback fails intermittently on 5708S and this is fixed by
   putting the PHY in loopback mode first before programming the MAC
   mode register. A MAC_RX_MODE reset is also added.

4. Return -EINVAL in tg3_nway_reset() if device is in TBI mode. Allow
   nway_reset if 5780S is in parallel detect mode.

5. Add missing PHY IDs in KNOWN_PHY_ID() macro.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

If we double-add a neighbour entry timer, which should be
impossible but has been reported, dump the current state of
the entry so that we can debug this.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

	arm maketools needs include/asm-arm in place in the build tree.
On normal builds it's always there, of course, but on O= it's created
(by generic code) too late - when we get to asm-offset.h.

	We used to get away with that by accident - creation of
include/asm-arm/arch symlink creates include/asm-arm and it happened
to go before maketools.  However, we did not have such dependency,
so that luck didn't last - now maketools is picked first and we are screwed.

	Both the symlink and maketools are prerequisites of the same
target (archprepare).  This fix is obvious - make the latter explicitly
depend on the former and be done with that.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

We do _not_ need "sparse" in sparse arguments ;-)

What we do need is __BIG_ENDIAN__; right now unconditional, when m32r
starts using CPU_LITTLE_ENDIAN, we'll need to adjust.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

	Most of these guys are simply not needed (pulled by other stuff
via asm-i386/hardirq.h).  One that is not entirely useless is hilarious -
arch/i386/oprofile/nmi_timer_int.c includes linux/irq.h... as a way to
get linux/errno.h
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

In order to do it correctly on UltraSPARC-III+ and later we'd
need to add some complicated code to set the TAG access extension
register before loading the TLB.

Since this optimization gives questionable gains, it's best to
just remove it for now instead of adding the fix for Ultra-III+
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

It tries to batch up the tag loads and comparisons, and
then the stores.  And this is just complicated instead
of efficient.

Also, make the symbol of the Cheetah version more grepable.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

When you've enabled conntrack and NAT as a module (standard case in all
distributions), and you've also enabled the new conntrack netlink
interface, loading ip_conntrack_netlink.ko will auto-load iptable_nat.ko.
This causes a huge performance penalty, since for every packet you iterate
the nat code, even if you don't want it.

This patch splits iptable_nat.ko into the NAT core (ip_nat.ko) and the
iptables frontend (iptable_nat.ko).  Threfore, ip_conntrack_netlink.ko will
only pull ip_nat.ko, but not the frontend.  ip_nat.ko will "only" allocate
some resources, but not affect runtime performance.

This separation is also a nice step in anticipation of new packet filters
(nf-hipac, ipset, pkttables) being able to use the NAT core.
Signed-off-by: NHarald Welte <laforge@netfilter.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

These broke existing apps, and the checks are superfluous
as the values being verified aren't even used.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

> Steps to reproduce:
> 1. Boot Linux, do NOT setup any IPv6 routes
> 2. ip route get 2001::1 (or any unroutable address)

Well caught.  We never set rt6i_idev on ip6_null_entry.
This patch should make the problem go away.
Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
Acked-by: NYOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

If input message rate from userspace is too high, do not drop them,
but try to deliver using work queue allocation.

Failing there is some kind of congestion control.

It also removes warn_on on this condition, which scares people.
Signed-off-by: NEvgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

It's on the stack and declared as "unsigned char[]", but pointers
and similar can be in here thus we need to give it an explicit
alignment attribute.
Signed-off-by: NAlex Williamson <alex.williamson@hp.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Patch from Vincent Sanders

A recent patch which made IXP4xx mach_desc's depend on config options
had the effect of not building the kernel for several machines it
possibly could be, this patch updates the default config to ensure all
possible machines are built for by default.
Signed-off-by: NVincent Sanders <vince@arm.linux.org.uk>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

Patch from David Vrabel
Signed-off-by: NDavid Vrabel <dvrabel@arcom.com>
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>

      different types in it but #define the two constants instead.
Signed-off-by: NAnton Altaparmakov <aia21@cantab.net>

SA_IRQNOMASK is unused, remove it.
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>