Skip to content

R
raspberrypi-kernel

openeuler / raspberrypi-kernel

通知 13
Star 1
Fork 0
R
raspberrypi-kernel
切换分支/标签
  1. 28 4月, 2016 1 次提交
  3. 27 4月, 2016 1 次提交
  5. 26 4月, 2016 1 次提交
  7. 18 2月, 2016 1 次提交
  9. 04 2月, 2016 1 次提交
    • M
      i40evf: allow channel bonding of VFs · 209dc4da
      由 Mitch Williams 提交于 
      In some modes, bonding would not enslave VF interfaces. This is due to
bonding calling change_mtu and the immediately calling open. Because of
the asynchronous nature of the admin queue mechanism, the VF returns
-EBUSY to the open call, because it knows the previous operation hasn't
finished yet. This causes bonding to fail with a less-than-useful error
message.

To fix this, remove the check for pending operations at the beginning of
open. But this introduces a new bug where the driver will panic on a
quick close/open cycle. To fix that, we add a new driver state,
__I40EVF_DOWN_PENDING, that the driver enters when down is called. The
driver finally transitions to a fully DOWN state when it receives
confirmation from the PF driver that all the queues are disabled. This
allows open to complete even if there is a pending mtu change, and
bonding is finally happy.

Change-ID: I06f4c7e435d5bacbfceaa7c3f209e0ff04be21cc
Signed-off-by: NMitch Williams <mitch.a.williams@intel.com>
Tested-by: NAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
      209dc4da
  11. 03 12月, 2015 1 次提交
  13. 02 12月, 2015 5 次提交
  15. 20 10月, 2015 1 次提交
  17. 16 10月, 2015 2 次提交
    • M
      i40evf: relax and stagger init timing a bit · 3f7e5c33
      由 Mitch Williams 提交于 
      On some devices, in some systems, in some configurations, the VFs would
fail to initialize the first time you loaded the driver.

To correct this, increase the delay time for the init task slightly, and
wait longer before giving up.

If we enable VFs and load the VF driver in the same kernel as the PF
driver, we can totally overwhelm the PF driver with AQ requests because
all of the instances try to initialize at the same time.

To help alleviate this, stagger the initial scheduling of the init task
using the PCIe function as a multiplier. We mask off the function to
only three bits so no instance has to wait too long.

With these two changes, initializing 128 VFs on a single device goes
from four minutes to just a few seconds.

Change-ID: If3d8720c1c4e838ab36d8781d9ec295a62380936
Signed-off-by: NMitch Williams <mitch.a.williams@intel.com>
Tested-by: NAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
      3f7e5c33
    • A
      i40e/i40evf: Drop useless "IN_NETPOLL" flag · 8b650359
      由 Alexander Duyck 提交于 
      The code in i40e and i40evf is using an "IN_NETPOLL" flag that has never
added any value due to the fact that the Rx clean-up is handled in NAPI.
As such the flag was set, the queue was scheduled via NAPI, and then polled
from the netpoll controller and if any Rx packets were processed the were
processed in the wrong context.

In addition the flag itself just added an unneeded conditional to the
hot-path so it can safely be dropped and save us a few instructions.
Signed-off-by: NAlexander Duyck <aduyck@mirantis.com>
Tested-by: NAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
      8b650359
  19. 14 10月, 2015 1 次提交
  21. 09 10月, 2015 2 次提交
  23. 06 8月, 2015 3 次提交
  25. 23 7月, 2015 3 次提交
  27. 26 6月, 2015 1 次提交
  29. 15 4月, 2015 1 次提交
  31. 27 3月, 2015 1 次提交
    • M
      i40evf: delay releasing rings · e284fc88
      由 Mitch Williams 提交于 
      When the VF interface is closed, we cannot immediately free our rings
and RX buffers, because the hardware hasn't yet stopped accessing this
memory. This shows up as a panic or memory corruption when the device is
brought down while under heavy stress.

To fix this, delay releasing resources until we receive acknowledgment
from the PF driver that the rings have indeed been stopped. Because of
this delay, we also need to check to make sure that all of our admin
queue requests have been handled before allowing the device to be
opened.

Change-ID: I44edd35529ce2fa2a9512437a3a8e6f14ed8ed63
Signed-off-by: NMitch Williams <mitch.a.williams@intel.com>
Tested-by: NJim Young <james.m.young@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
      e284fc88
  33. 21 11月, 2014 1 次提交
    • M
      i40evf: make checkpatch happy · 75a64435
      由 Mitch Williams 提交于 
      This patch is the result of running checkpatch on the i40evf driver with
the --strict option. The vast majority of changes are adding/removing
blank lines, aligning function parameters, and correcting over-long
lines.

The only possible functional change is changing the flags member of the
adapter structure to be non-volatile. However, according to the kernel
documentation, this is not necessary and the volatile should be removed.

Change-ID: Ie8c6414800924f529bef831e8845292b970fe2ed
Signed-off-by: NMitch Williams <mitch.a.williams@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
      75a64435
  35. 11 11月, 2014 1 次提交
  37. 05 6月, 2014 2 次提交
  39. 21 5月, 2014 1 次提交
  41. 28 3月, 2014 1 次提交
  43. 22 2月, 2014 2 次提交
  45. 18 2月, 2014 1 次提交
  47. 14 2月, 2014 5 次提交