Remove the duplicated PLL1 connections of the adc stereo filters,
and remove the PLL1 connections of the DACs because the PLL1 should be
connected to dac filters.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add the ASRC support
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add the filter powers of the dac mono3 and mono4, and remove the connection
of dac stereo1 filter that connect to DAC1 MIX.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The volume blocks have an step of 0.375dB, but TLV uses 0.01dB for
units.  Only use the resolution supported, ignoring the LSB of the
volume register.  This results in half the steps and 0.75dB per step,
but reports accurate levels through TLV.  Update the masks to reflect
that these are registers have the LSB ignored.
Signed-off-by: NDylan Reid <dgreid@chromium.org>
Signed-off-by: NMark Brown <broonie@kernel.org>

After the patch "ASoC: rt5677: Use specific r/w function for DSP mode", the
regmap_range "rt5677_ranges" was not registered in rt5677_regmap_physical, and
it caused that the regmap_range "rt5677_ranges" cannot be accessed by the
specific r/w function. The patch fixes this issue.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Set the slow charge of the vref in the end of the power sequences
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Follow the gpio naming rule to rename the irq function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Align the reg_default table with tab character
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Modify the default value of the MX-8E[4] to 1 for ASRC function. It could
prevent the pop noise with ASRC function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

It is the slot selection in DAC side of IF1 and IF2.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

In DSP mode, the register r/w should use the specific function to access
that is invoked by address mapping of the DSP.

The MX-65[1] is for switching DSP or codec mode.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Minor coding style and typo fix
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

It is for channel to slot mapping, and it is not only for 8 channels mapping,
but also in 2, 4 and 6 channels mapping. If we want to use the 2 channels in
the stereo2 adc path, we need to set the item "2/1/3/4" or "2/3/1/4".

It also adds for stereo channel swap. It can map the sterero channels "L/R"
to "R/L", "L/L" or R/R.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

sound/soc/codecs/rt5677.c:4017:5: sparse: symbol 'rt5677_irq_init' was not declared. Should it be static?
sound/soc/codecs/rt5677.c:4044:6: sparse: symbol 'rt5677_irq_exit' was not declared. Should it be static?
Signed-off-by: NFengguang Wu <fengguang.wu@intel.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

This allows to enable Mic Jack detection feature
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Modified-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The ALC5677 has a programmable DSP, and there is a SPI that is dadicated for DSP
firmware loading. Therefore, the patch includes a SPI driver for writing the DSP
firmware. The VAD(Voice Activaty Detection) has be implemented and use the DSP to
recognize the key phase.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

gpio_config is array of 6 elements that allows to set GPIO as
floating, pullup, pulldown.

Sponsored: Google ChromeOS
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Some boards have this pin statically tied and do not require any configuration,
some other boards allow to enable chip using GPIO.

Add an option that tells which GPIO is used to power the audio codec.
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

Add sidetone function
Signed-off-by: NAnatol Pomozov <anatol.pomozov@gmail.com>
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds the TDM function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

gpiochip_remove() will return void eventually.
Thus this patch removes return value checking for gpiochip_remove().
Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

The patch adds the GPIO function.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@kernel.org>

There are two pins can be used for rt5677's DMIC2 clock. This patch
add the select options for it.
Signed-off-by: NBard Liao <bardliao@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

We name MICBIAS1 in dapm widget, but micbias1 in route table.
Signed-off-by: NBard Liao <bardliao@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The patch modifies the voltage level in the BIAS OFF stage
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The implementation of rt5677_pll_calc() has the same logic of rl6231_pll_calc().
The only difference is the lower boundary checking for freq_in.

This patch calls rl6231_pll_calc() instead of open-coded.
The k_bp of struct rt5677_pll_code is always false, thus also remove the
code to check pll_code.k_bp.
Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Tested-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The patch adds a PMD case to MICBIAS1 event.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The patch replaces the string "Gain" to "Volume".
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The patch replaces the string "source" to "Source".
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

The patch replaces the string "micbias1" to "MICBIAS1".
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Tested-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Tested-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

Signed-off-by: NAxel Lin <axel.lin@ingics.com>
Tested-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>

This patch adds the Realtek ALC5677 codec driver.
Signed-off-by: NOder Chiou <oder_chiou@realtek.com>
Signed-off-by: NMark Brown <broonie@linaro.org>