dss_select_clk_source() was rather confusing. Selecting the source with
enums is much clearer.

The clk source selection is also stored into memory, so that we know what
is the selected source, even when clocks are off. This is important during
setup, as we need to what clocks to turn on before the clocks are turned
on.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Fix compilation of the CONFIG_OMAP2_DSS_COLLECT_IRQ_STATS feature.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

It looks like on OMAP3 some DSS pins need VDDS_DSI to function properly.

This has not been confirmed from TI, but looking at figure 15-1 "Display
subsystem highlight" from the TRM, some data pins come near the DSI and SDI
blocks. This is not very hard evidence, but the fact remains that with the
power on, pixels are ok, and with the power off, pixels are not ok.

It may also be that VDDS_SDI is needed to power some pins, but as normally
both VDDS_SDI and VDDS_DSI come from the same power source, this hasn't
been shown.

It seems that a single driver can only get a regulator once. This patch
solves it by getting all the required regulators in one place, and from
which the submodules then get the regulators they need.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

If the scaling ratio is below 0.5 video output width can't be identical
to the display width. Reject such settings.
Signed-off-by: NVille Syrjälä <ville.syrjala@nokia.com>
Acked-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Loops checking for certain condition were rather inconsistent.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>
Reported-by: NJuha Leppanen <juha_motorsportcom@luukku.com>

Signed-off-by: NVaibhav Hiremath <hvaibhav@ti.com>
Acked-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

DSI driver didn't check if the panel driver actually implements
enable_te().
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Collect interrupt statistics, printable via debugfs:

debugfs/omapdss/dispc_irq
debugfs/omapdss/dsi_irq

The counters are reset when printed.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

- dsi_vc_send_short() needs to use dest_per for the peripheral id
- dsi_vc_send_null() was always using channel id 0
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

DSI (Display Serial Interface) driver implements MIPI DSI interface.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

SDI (Serial Display Interface) implements TI Flatlink 3G display
interface.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

RFBI (Remote FrameBuffer Interface) implements MIPI DBI interface.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

VENC (video encoder) driver implements OMAP's analog S-Video/Composite
TV-out.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>
Acked-by: NTony Lindgren <tony@atomide.com>

This implements MIPI DPI interface.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

This file implements DISPC (display controller) block of the OMAP DSS.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

Add more core files to DSS2.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>

The core files of DSS2. DSS2 commits are split a bit artificially to
make the individual commits smaller, and DSS2 doesn't compile properly
without the rest of the core commits. This shouldn't be a problem, as no
configuration uses DSS2 yet.
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@nokia.com>