There is a race in the kernel cpuset code, between the code
to handle notify_on_release, and the code to remove a cpuset.
The notify_on_release code can end up trying to access a
cpuset that has been removed.  In the most common case, this
causes a NULL pointer dereference from the routine cpuset_path.
However all manner of bad things are possible, in theory at least.

The existing code decrements the cpuset use count, and if the
count goes to zero, processes the notify_on_release request,
if appropriate.  However, once the count goes to zero, unless we
are holding the global cpuset_sem semaphore, there is nothing to
stop another task from immediately removing the cpuset entirely,
and recycling its memory.

The obvious fix would be to always hold the cpuset_sem
semaphore while decrementing the use count and dealing with
notify_on_release.  However we don't want to force a global
semaphore into the mainline task exit path, as that might create
a scaling problem.

The actual fix is almost as easy - since this is only an issue
for cpusets using notify_on_release, which the top level big
cpusets don't normally need to use, only take the cpuset_sem
for cpusets using notify_on_release.

This code has been run for hours without a hiccup, while running
a cpuset create/destroy stress test that could crash the existing
kernel in seconds.  This patch applies to the current -linus
git kernel.
Signed-off-by: NPaul Jackson <pj@sgi.com>
Acked-by: NSimon Derr <simon.derr@bull.net>
Acked-by: NDinakar Guniguntala <dino@in.ibm.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The original pwc author raised some questions about the reverse
engineering of the decompressor algorithms used in the pwc driver.
Having done some detailed investigation it appears those concerns that
clean room policy was not followed are reasonable.  I've also had a
friendly discussion with Philips to ask their view on this.

This removes the problem items of code which reduces the pwc
functionality in the kernel a little but leaves all the framework for
setup that will be needed for decompressors in user space (where they
eventually belong).  This change set is designed to be the minimal risk
change set given that 2.6.12 is hopefully close to hand, with a view to
merging the much updated pwc code in 2.6.13 series kernels.

Someone else can then redo the decompressors properly (clean room) in
user space.

Note that while its easy to say that it should have been caught earlier,
but the violation was really only obvious to someone who had access to
both the proprietary source and the 'GPL' source.

The change to require the DMA length to be only word-aligned was not
safe.

We fixed this bug before, but it didn't take.  It may have been the case
that the problem was first noticed to occur in a CONFIG_REGPARM compile.
But it's not regparm functions that need not to make tail calls, it's
asmlinkage functions called with a user pt_regs frame on the stack
supplying their arguments.  prevent_tail_call probably doesn't do anything
at all in regparm functions (your argument registers are going to be
clobbered, period).  It was a braino to conditionalize that definition in
the first place.
Signed-off-by: NRoland McGrath <roland@redhat.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

A new driver bnx2 for Broadcom bcm5706 is available.

The patch also includes new 1000BASE-X advertisement bit definitions in
mii.h

Thanks to David Miller and Jeff Garzik for reviewing and their valuable
feedback.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

"_s" suffix is certainly of hungarian origin.
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

[XFRM] Call dst_check() with appropriate cookie

This fixes infinite loop issue with IPv6 tunnel mode.
Signed-off-by: NKazunori Miyazawa <kazunori@miyazawa.org>
Signed-off-by: NHideaki YOSHIFUJI <yoshfuji@linux-ipv6.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Correcting the list traversal makes the problem go away.
Signed-off-by: NJay Vosburgh <fubar@us.ibm.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Here is a fixed up version of the reorder feature of netem.
It is the same as the earlier patch plus with the bugfix from Julio merged in.
Has expected backwards compatibility behaviour.

Go ahead and merge this one, the TCP strangeness I was seeing was due
to the reordering bug, and previous version of TSO patch.
Signed-off-by: NStephen Hemminger <shemminger@osdl.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Netem works better if there if packets are just queued in the inner discipline
rather than having a separate delayed queue. Change to use the dequeue/requeue
to peek like TBF does.

By doing this potential qlen problems with the old method are avoided. The problems
happened when the netem_run that moved packets from the inner discipline to the nested
discipline failed (because inner queue was full). This happened in dequeue, so the
effective qlen of the netem would be decreased (because of the drop), but there was
no way to keep the outer qdisc (caller of netem dequeue) in sync.

The problem window is still there since this patch doesn't address the issue of
requeue failing in netem_dequeue, but that shouldn't happen since the sequence dequeue/requeue
should always work.  Long term correct fix is to implement qdisc->peek in all the qdisc's
to allow for this (needed by several other qdisc's as well).
Signed-off-by: NStephen Hemminger <shemminger@osdl.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Handle duplication of packets in netem by re-inserting at top of qdisc tree.
This avoid problems with qlen accounting with nested qdisc. This recursion
requires no additional locking but will potentially increase stack depth.
Signed-off-by: NStephen Hemminger <shemminger@osdl.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

	rsync://rsync.kernel.org/pub/scm/linux/kernel/git/jgarzik/netdev-2.6

	rsync://rsync.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev

From: Marcello Maggioni <hayarms@gmail.com>

Problem: Some drives (NEC 3500, TDK 1616N, Mad-dog MD-16XDVD9, RICOH
MP5163DA, Memorex DVD9 drive and IO-DATA's too for sure), if a
CD/DVD is inserted into the tray when the system is booted and if
before the OS bootup the BIOS checked for the presence of a bootable
CD/DVD into the drive, during the IDE probe phase the drive may
result busy and remain so for the next 25/30 seconds . This cause the
drive to be skipped during the booting phase and not begin usable
until the next reboot (if the reboot goes well and the drive doesn't
timeout again).

Solution: Rising the timeout time from 10 seconds to 35 seconds
(during these 35 seconds every drive should wake up for sure
according to the tests I've done).
Signed-off-by: NBartlomiej Zolnierkiewicz <bzolnier@elka.pw.edu.pl>

From: Stuart Hayes <Stuart_Hayes@dell.com>

The system can panic with a null pointer dereference using ide-scsi if
PIO is being done on scatter gather pages that are in high memory,
because page_address() returns 0.  We are actually seeing this using a
tape drive.  This patch will kmap_atomic() the pages before performing
PIO.
Signed-off-by: NBartlomiej Zolnierkiewicz <bzolnier@elka.pw.edu.pl>

* add ide_bus_match() and export ide_bus_type
* split ide_remove_driver_from_hwgroup() out of ide_unregister()
* move device cleanup from ide_unregister() to drive_release_dev()
* convert ide_driver_t->name to driver->name
* convert ide_driver_t->{attach,cleanup} to driver->{probe,remove}
* remove ide_driver_t->busy as ide_bus_type->subsys.rwsem
  protects against concurrent ->{probe,remove} calls
* make ide_{un}register_driver() void as it cannot fail now
* use driver_{un}register() directly, remove ide_{un}register_driver()
* use device_register() instead of ata_attach(), remove ata_attach()
* add proc_print_driver() and ide_drivers_show(), remove ide_drivers_op
* fix ide_replace_subdriver() and move it to ide-proc.c
* remove ide_driver_t->drives, ide_drives and drives_lock
* remove ide_driver_t->drivers, drivers and drivers_lock
* remove ide_drive_t->driver and DRIVER() macro
Signed-off-by: NBartlomiej Zolnierkiewicz <bzolnier@elka.pw.edu.pl>

When testing ATAPI PIO data transfer on the ppc64 platform,  __atapi_pio_bytes() got zero when
sg_dma_len() is used. I checked the <asm-ppc64/scatterlish.h>, the struct scatterlist is defined as:

struct scatterlist {
	struct page *page;
	unsigned int offset;
	unsigned int length;

	/* For TCE support */
	u32 dma_address;
	u32 dma_length;
};

#define sg_dma_address(sg)	((sg)->dma_address)
#define sg_dma_len(sg)		((sg)->dma_length)

So, if the scatterlist is not DMA mapped, sg_dma_len() will return zero on ppc64.
The same problem should occur on the x86-64 platform.
On the i386 platform, sg_dma_len() returns sg->length, that's why the problem does not occur on an i386.

Changes:
- Use sg->length if the scatterlist is not DMA mapped (yet).
Signed-off-by: NAlbert Lee <albertcc@tw.ibm.com>

Automatic merge of rsync://rsync.kernel.org/pub/scm/linux/kernel/git/torvalds/linux-2.6.git branch HEAD

	rsync://rsync.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev

This patch shows the correct locations of the heat sensors present in iBook
and PowerBooks G4, instead of displaying them as being on CPU and GPU
(which is not always the case).
Signed-off-by: NColin Leroy <colin@colino.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

This patch limits therm_adt746x to currently existing fan controllers in
Apple laptops.  It may avoid problems with future hardware.
Signed-off-by: NColin Leroy <colin@colino.net>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Make MTU field in SA PathRecord and MCMemberRecord a u8 rather than an enum
to avoid complications with endianness.
Signed-off-by: NRoland Dreier <roland@topspin.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Free all unclaimed MAD receive buffers when userspace closes our file so we
don't leak memory.
Signed-off-by: NRoland Dreier <roland@topspin.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Check if a client passes a NULL callback into an SA query, and if so, never
call back.  This fixes an oops if someone unloads ib_ipoib and ib_sa in
rapid succession.  ib_ipoib does an MCMember delete with a NULL callback
and 0 timeout on unload, which is usually fine since the delete completes
successfully.  However, if ib_sa is unloaded immediately afterwards, the
delete will be canceled and ib_sa will try to call the (now already
unloaded) ib_ipoib module back with the cancel completion, which triggers
the oops.
Signed-off-by: NRoland Dreier <roland@topspin.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Fixes some !CONFIG_BUG warnings:
include/asm/mmu_context.h: I funktion `switch_mm':
include/asm/mmu_context.h:57: varning: implicit declaration of function `out_of_line_bug'
Signed-off-by: NAlexander Nyberg <alexn@telia.com>
Cc: Andi Kleen <ak@muc.de>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

It looks like the recent IPMI patches had some -mm-onlyisms.
Signed-off-by: NNeil Horman <nhorman@redhat.com>
Cc: Corey Minyard <minyard@acm.org>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>