redundant; all callers get it duplicated in mask & MAY_NOT_BLOCK and none of
them removes that bit.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

its value depends only on inode and does not change; we might as
well store it in ->i_op->check_acl and be done with that.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

... unfortunately, cifs bug got copied.  Fix is essentially the same.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

We were iterating across stripe boundaries properly, but not moving the
write buffer pointer forward.  This caused us to rewrite the same data
after the break.  Fix by adjusting the data pointer forward, and
recalculating the io and buffer alignment after the break.
Signed-off-by: NSage Weil <sage@newdream.net>

 dd if=/dev/urandom of=/mnt/fs_depot/dd10 bs=500 seek=8388 count=1
 dd if=/mnt/fs_depot/dd10 of=/root/dd10out bs=500 skip=8388 count=1
Reported-by: NHenry C Chang <henry.cy.chang@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

If we request a lock and then abort (e.g., ^C), we need to send a matching
unlock request to the MDS to unwind our lock attempt to avoid indefinitely
blocking other clients.
Reported-by: NBrian Chrisman <brchrisman@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

Getting ENOENT is equivalent to reading 0 bytes.  Make that correction
before setting up the hit_stripe and was_short flags.

Fixes the following case:
 dd if=/dev/zero of=/mnt/fs_depot/dd3 bs=1 seek=1048576 count=0
 dd if=/mnt/fs_depot/dd3 of=/root/ddout1 skip=8 bs=500 count=2 iflag=direct
Reported-by: NHenry C Chang <henry.cy.chang@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

If we get a short read from the OSD because the object is small, we need to
zero the remainder of the buffer.  For O_DIRECT reads, the attempted range
is not trimmed to i_size by the VFS, so we were actually looping
indefinitely.

Fix by trimming by i_size, and the unconditionally zeroing the trailing
range.
Reported-by: NJeff Wu <cpwu@tnsoft.com.cn>
Signed-off-by: NSage Weil <sage@newdream.net>

We should use ihold whenever we already have a stable inode ref, even
when we aren't holding i_lock.  This avoids adding new and unnecessary
locking dependencies.
Signed-off-by: NSage Weil <sage@newdream.net>

Ceph does not need these, and they screw up our use of the dcache as a
consistent cache.
Signed-off-by: NSage Weil <sage@newdream.net>
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

Only a few file systems need this.  Start by pushing it down into each
rename method (except gfs2 and xfs) so that it can be dealt with on a
per-fs basis.
Acked-by: NChristoph Hellwig <hch@lst.de>
Signed-off-by: NSage Weil <sage@newdream.net>
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

Only a few file systems need this.  Start by pushing it down into each
fs rmdir method (except gfs2 and xfs) so it can be dealt with on a per-fs
basis.

This does not change behavior for any in-tree file systems.
Acked-by: NChristoph Hellwig <hch@lst.de>
Signed-off-by: NSage Weil <sage@newdream.net>
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>

In e9964c10 we change cap flushing to do a delicate dance because some
inodes on the cap_dirty list could be in a migrating state (got EXPORT but
not IMPORT) in which we couldn't actually flush and move from
dirty->flushing, breaking the while (!empty) { process first } loop
structure.  It worked for a single sync thread, but was not reentrant and
triggered infinite loops when multiple syncers came along.

Instead, move inodes with dirty to a separate cap_dirty_migrating list
when in the limbo export-but-no-import state, allowing us to go back to
the simple loop structure (which was reentrant).  This is cleaner and more
robust.

Audited the cap_dirty users and this looks fine:
list_empty(&ci->i_dirty_item) is still a reliable indicator of whether we
have dirty caps (which list we're on is irrelevant) and list_del_init()
calls still do the right thing.
Signed-off-by: NSage Weil <sage@newdream.net>

If we get the inode from the MDS, we have a reference in req; don't do a
fresh lookup.
Signed-off-by: NSage Weil <sage@newdream.net>

If we are unable to locate an inode by ino, ask the MDS using the new
LOOKUPINO command.
Signed-off-by: NSage Weil <sage@newdream.net>

Since we pass the nofail arg, we should never get an error; BUG if we do.
(And fix the function to not return an error if __map_request fails.)
Signed-off-by: NSage Weil <sage@newdream.net>

rc is only ever 0 or negative in this method.
Signed-off-by: NSage Weil <sage@newdream.net>

Both off and fi->offset are unsigned, so the difference is always >= 0.
Compare them directly instead of the sign of the difference.
Signed-off-by: NSage Weil <sage@newdream.net>

If we grab new_cap, retake the lock, and find we already have a cap now
for the given mds, release new_cap.
Signed-off-by: NSage Weil <sage@newdream.net>

We allocate a buffer for rstats if the dirstat option is enabled.  Use
snprintf.
Signed-off-by: NSage Weil <sage@newdream.net>

Signed-off-by: NSage Weil <sage@newdream.net>

We put ourselves on an inode list for the parent directory of metadata
operations so that an fsync on the directory will wait for metadata updates
to commit to disk.  We weren't holding a reference to that directory,
however, and under certain workloads (fsstress in this case) the directory
can go away.
Signed-off-by: NSage Weil <sage@newdream.net>

We increments i_wrbuffer_ref when taking the Fb cap. This breaks
the dirty page accounting and causes looping in
__ceph_do_pending_vmtruncate, and ceph client hangs.

This bug can be reproduced occasionally by running blogbench.

Add a new field i_wb_ref to inode and dedicate it to Fb reference
counting.
Signed-off-by: NHenry C Chang <henry.cy.chang@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

Signed-off-by: NHenry C Chang <henry.cy.chang@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

The mds session, s, could be freed during ceph_put_mds_session.
Move dout before ceph_put_mds_session.
Signed-off-by: NHenry C Chang <henry.cy.chang@gmail.com>
Signed-off-by: NSage Weil <sage@newdream.net>

The __mark_dirty_inode helper now takes i_lock as of 250df6ed.  Fix the
one ceph callers that held i_lock (__ceph_mark_dirty_caps) to return the
flags value so that the callers can do it outside of i_lock.
Signed-off-by: NSage Weil <sage@newdream.net>

We should unlock the page and return -ENOMEM if ceph_osdc_new_request
failed.
Signed-off-by: NHenry C Chang <henry_c_chang@tcloudcomputing.com>
Signed-off-by: NSage Weil <sage@newdream.net>

See 0444d76a.
Signed-off-by: NSage Weil <sage@newdream.net>

Fixes generated by 'codespell' and manually reviewed.
Signed-off-by: NLucas De Marchi <lucas.demarchi@profusion.mobi>

This makes the base64 logic be contained in mount option parsing,
and prepares us for replacing the homebew key management with the
kernel key retention service.
Signed-off-by: NTommi Virtanen <tommi.virtanen@dreamhost.com>
Signed-off-by: NSage Weil <sage@newdream.net>

Fix the incorrect use of igrab() inside the i_lock in NFS and Ceph‥

If we are already holding the i_lock, we have a reference to the
inode so we can safely use ihold() to gain an extra reference. This
avoids hangs due to lock recursion on the i_lock now that the
inode_lock is gone and igrab() uses the i_lock itself.
Signed-off-by: NDave Chinner <dchinner@redhat.com>
Cc: Al Viro <viro@zeniv.linux.org.uk>
Cc: linux-fsdevel@vger.kernel.org
Cc: Ryan Mallon <ryan@bluewatersys.com>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

The release method for mds connections uses a backpointer to the
mds_client, so we need to flush the workqueue of any pending work (and
ceph_connection references) prior to freeing the mds_client.  This fixes
an oops easily triggered under UML by

 while true ; do mount ... ; umount ... ; done

Also fix an outdated comment: the flush in ceph_destroy_client only flushes
OSD connections out.  This bug is basically an artifact of the ceph ->
ceph+libceph conversion.
Signed-off-by: NSage Weil <sage@newdream.net>

Just for consistency's sake.  Fix obsolete comment too.
Signed-off-by: NSage Weil <sage@newdream.net>

In sync_write_wait(), we assume that the newest request is at the
tail of unsafe write list. We should maintain the semantics here.
Signed-off-by: NHenry C Chang <henry_c_chang@tcloudcomputing.com>
Signed-off-by: NSage Weil <sage@newdream.net>

This fixes the list corruption warning like this:

------------[ cut here ]------------
WARNING: at lib/list_debug.c:30 __list_add+0x68/0x81()
Hardware name: X8DTU
list_add corruption. prev->next should be next (ffff880618931250), but was (null). (prev=ffff880c188b9130).
Modules linked in: nfsd lockd nfs_acl auth_rpcgss exportfs ceph libceph libcrc32c sunrpc ipv6 fuse igb i2c_i801 ioatdma i2c_core iTCO_wdt iTCO_vendor_support joydev dca serio_raw usb_storage [last unloaded: scsi_wait_scan]
Pid: 10977, comm: smbd Tainted: G        W  2.6.32.23-170.Elaster.xendom0.fc12.x86_64 #1
Call Trace:
[<ffffffff8105753c>] warn_slowpath_common+0x7c/0x94
[<ffffffff810575ab>] warn_slowpath_fmt+0x41/0x43
[<ffffffff812351a3>] __list_add+0x68/0x81
[<ffffffffa014799d>] ceph_aio_write+0x614/0x8a2 [ceph]
[<ffffffff8111d2a0>] do_sync_write+0xe8/0x125
[<ffffffff81075a1f>] ? autoremove_wake_function+0x0/0x39
[<ffffffff811f21ec>] ? selinux_file_permission+0x5c/0xb3
[<ffffffff811e8521>] ? security_file_permission+0x16/0x18
[<ffffffff8111d864>] vfs_write+0xae/0x10b
[<ffffffff8111d91b>] sys_pwrite64+0x5a/0x76
[<ffffffff81012d32>] system_call_fastpath+0x16/0x1b
---[ end trace 08573eb9f07ff6f4 ]---
Signed-off-by: NHenry C Chang <henry_c_chang@tcloudcomputing.com>
Signed-off-by: NSage Weil <sage@newdream.net>

Signed-off-by: NSage Weil <sage@newdream.net>

The ino32 mount option forces the ceph fs to report 32 bit
ino values.  This is useful for 64 bit kernels with 32 bit userspace.
Signed-off-by: NYehuda Sadeh <yehuda@hq.newdream.net>

Whoops!
Signed-off-by: NSage Weil <sage@newdream.net>

d_move puts the renamed dentry at the end of d_subdirs, screwing with our
cached dentry directory offsets.  We were just clearing I_COMPLETE to avoid
any possibility of trouble.  However, assigning the renamed dentry an
offset at the end of the directory (to match it's new d_subdirs position)
is sufficient to maintain correct behavior and hold onto I_COMPLETE.

This is especially important for workloads like rsync, which renames files
into place.  Before, we would lose I_COMPLETE and do MDS lookups for each
file.  With this patch we only talk to the MDS on create and rename.
Signed-off-by: NSage Weil <sage@newdream.net>

can't blindly check nd->flags in ->d_revalidate()
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>