Some laptops cause annoying clicks or noises at shutdown/reboot since
the speaker pin is set still high.  Apply the same procedure used for
the suspend to avoid such clicks/noises for freeing the codec, too.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Function hp_bseries_system() is always used, outside of
CONFIG_ boundaries/controls, so move it.

sound/pci/hda/patch_sigmatel.c:5458: error: implicit declaration of function 'hp_bseries_system'
Signed-off-by: NRandy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch enables GPIO to control mute LED indicator on the HP systems
with the special string in BIOS and applies it with the correct polarity on
HP B-series systems.

It also restores configuration of the pin intended as the second Headphone
on HP B-series systems but configured as something else in the BIOS to
pass MS DTM.
Signed-off-by: NVitaliy Kulikov <Vitaliy.Kulikov@idt.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The volume-knob widget needs to be set with 0x7f instead of 0xff
for Dell laptops with STAC9228 codec, too, like the previous commit.

Reference: Novell bnc#545013
	http://bugzilla.novell.com/show_bug.cgi?id=545013Signed-off-by: NTakashi Iwai <tiwai@suse.de>

On FSC laptops, the sound gets muted gradually when the volume is chnaged.
This is due to the wrong volume-knob widget setup.  The delta bit (bit 7)
shouldn't be set for these devices.

This patch adds a new quirk to set the value 0x7f to the widget 0x24
instead of 0xff.

Reference: Novell bnc#546006
	http://bugzilla.novell.com/show_bug.cgi?id=546006Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When the auto-mic switching between an analog and a digital mic is
needed with IDT codecs, the current driver doesn't reset the connection
of the digital mux.

This patch fixes the behavior by checking both mux connections properly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The pin setup for Dell S14 quirk is rather wrong for the latest driver.
Fixed pin 0x0a, 0x0b, 0x0d and 0x0f.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Remove unnecessary (and buggy) init sequences left for IDT92HD83*
codecs in the previous fixes.  The DACs are now dynamically connected,
thus shouldn't be set statically in init verbs.  Also, the mono_nid
is detected dynamically, thus shouldn't be set staticaly, too.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add the quirk entry for HP dv6.  Also add a workaround for the headphone
detection by setting hp_detect=1 beforehand.  Without this, the driver
won't do auto-muting because BIOS doesn't give any HP pin but only a
line-out pin.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

It's possible that hp_detect is set even though no headphone pin is
detected.  The driver issues, however, an unsol event only to hp_pins[0],
which can be invalid.

This patch adds the check of the valid pin to send an unsol event
at initialization and resume callbacks.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

A smiliar fix for IDT 92HD71Bxx codecs like the previous commit for
other IDT/STAC codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

IDT92HD73xx and STAC927x codecs use GPIO0 bit as EAPD on many machines.
However, currently we don't set it unless the model is specified just
for safety reason.  But, most machines do need this bit, so this safety
handling is rather annoying.

This patch enables GPIO0 setup as default for them.  Many HP / Dell
laptops should work even without model override with this change.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the quirk for Alienware M17x with IDT 92HD73* codec chip.
It has two HP and one line-out jack, one mic jack, a built-in
speaker and a built-in mic.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Due to the previous fix of input source for IDT92HD73xx, the amp mux
and amp vol stuff became unused.  Let's rip off dead codes.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix the mux_nids to select directly the input source instead of mux
mixers so that it works with the current mux enum handler for IDT
92HD73xx codecs.

Also, clean up useless / unnecessary mixer controls and init verbs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

So far, the digital mic capture volume wasn't created.  This is because
IDT codecs have output amps for digital mics, not input amps, while
input amps should be used for other analog pins.  Thus the automatic
capture volume creation should check both directions for digital mics.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The BIOS pin configs are in fact correct and shall not be overwritten.
Signed-off-by: NWu Fengguang <fengguang.wu@intel.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The previous fix removed the definition of num_adc_nids wrongly, and
this resulted in the missing input-source control.  Now readded again.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

A few improvements for IDT 92HD83xxx codec pareser:
- Remove unused / deprecated mixer-amp controls
- Handle d-mics as normal inputs since this codec has no separate
  MUXes for analog and digital
- Don't create duplicated controls for capture volumes with Mux
  capture volumes
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Enable line-out detection for IDT/STAC codecs only when speaker pins
exist.  In some cases, the speaker itself is identified as line-out,
and this confuses the situation.  Only the extra line-outs should do
auto-muting.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The previous auto-mic patch for STAC/IDT codecs causes the Oops on
machines without digital mic pins.  This patch fixes the problem.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The new HP laptops have PCI SSID 103c:701x and requires model=hp-dv5.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

When the line-out jack is plugged/unplugged, the driver needs to check
the headphone plug, not only the line-out jack itself.  Otherwise the
headphone or the speaker may be wrongly muted/unmuted.

As a result, both STAC_HP_EVENT and STAC_LO_EVENT need to call the
same function, stac92xx_hp_detect().
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The commit fefd67f3
    ALSA: hda - Add line-out jack detection on IDT/STAC codecs
enabled wrong pins for jack detections.  Fixed to the correct ones.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The commit 24918b61 statically changes
the model from dell-bios to dell-3stack to solve the sound decreasing
regression (http://lkml.org/lkml/2008/9/12/203), however it leads to another
problem that the 2nd headphone jack doesn't work
(https://bugtrack.alsa-project.org/alsa-bug/view.php?id=3987). So I think
the commit 249**2dc is just a workaround. I would like to give a true solution
here.

The datasheet for STAC9228 says, GPIO2 is the same pin as VOL DOWN, and
the EAPD pin is GPIO0. This is why the sound decreases if we set EAPD as
GPIO2. This patch changes EAPD to GPIO0 to solve the problem.
Signed-off-by: NChengu Wang <wangchengu@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add the automatic mute of speakers via line-out jack plugging on
STAC/IDT codecs.  The feature is enabled when the HP detect is present.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

STAC/IDT codecs provide both "Input Source" and "Digital Input Source"
controls to choose the analog input source and the digital input source.
But this is far user-unfriendly.

This patch merges the input source selections into one "Input Source"
control.  To have separate digital and analog input source controls,
you can pass "separate_dmux = 1 " hint string.

At the same time, this patch gets rid of analog mixer stuff that was
already disabled in previous patches.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The commit 6479c631
    ALSA: hda - Create Capture controls dynamically
introduced typos of "Capture".  Fixed now.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The analog mix is disabled now as default (unless "analog_mixer" hint
is given), so it shoudn't appear in the digital input source as well.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added the missing initialization of DMUX connection (to analog input)
for auto-mic mode with STAC/IDT codecs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

We don't need any more static connection to the port F (which is often
used for docking stations) since its connection is done dynamically via
DAC assignment now.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Support the automatic mic-switching with some devices with IDT/STAC
codecs.  The condition is that the device has only two inputs, one
for an external mic and one for an internal mic.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Since only one event can be associated to a (pin) widget, it's safer
to avoid the multiple mapping.  This patch fixes the behavior of the
STAC/IDT codec driver.

Now stac_get_event() doesn't take the type argument but simply returns
the first hit element.  Then enable_pin_detect() checks the validity
of the type, and returns non-zero only if a valid entry.  The caller
can call stac_issue_unsol_event() after checking the return value.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The analog mixer unit on IDT 92HD71Bxx codecs is almost useless
since we use only the direct connections from DAC to pin.

Remove the controls to avoid unneeded confusion as default now.
This can be still back via "analog_mixer = 1" hint.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Instead of static snd_kcontrol_new arrays, create "Capture Volume"
and "Capture Switch" controls dynamically based on the mixer attr
values (made via HDA_COMPOSE_AMP_VAL()).
This reduces the code size and gives more flexibility to change
the number of controls later.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The current driver creates always the digital input source mixer
elements for IDT 92HD71x codecs no matter whether digital mics are
present.  This patch adds the proper check to avoid the creation of
these controls if unnecessary.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

The sentense "Unknown model for xxx, ..." makes people too nervous
and drives them to a direction to a wrong "fix" by giving any
mismatching model option.

Let's rephrase the messages to be more nice and easy (at least that
won't make people suspect conspiracies).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Added a quirk entry for Dell Studio 1555.

Reference: Novell bnc#525244
	https://bugzilla.novell.com/show_bug.cgi?id=525244Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add a helper macro to retrieve the widget type from wiget cap bits.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

This patch adds a check to snd_hda_get_connections() routine for
presence of AC_WCAP_CONN_LIST. Also, make sure that negative error
codes from noted route are handled on all places as errors.
Signed-off-by: NJaroslav Kysela <perex@perex.cz>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>