It isn't necessary for command streams generated by the kernel (at least
not while we aren't storing ring or indirect buffers in VRAM).
Signed-off-by: NMichel Dänzer <michel.daenzer@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

May fix hangs in some cases.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Skip the "manual" pageflip completion checks via polling and
guessing in the vblank handler radeon_crtc_handle_vblank() on
asics which are known to reliably support hw pageflip completion
irqs. Those pflip irqs are a more reliable and race-free method
of handling pageflip completion detection, whereas the "classic"
polling method has some small races in combination with dpm on,
and with the reworked pageflip implementation since Linux 3.16.

On old asics without pflip irqs, the classic method is used.

On asics with known good pflip irqs, only pflip irqs are used
by default, but a new module parameter "use_pflipirqs" allows to
override this in case we encounter asics in the wild with
unreliable or faulty pflip irqs. A module parameter of 0 allows
to use the classic method only in such a case. A parameter of 1
allows to use both classic method and pflip irqs as additional
band-aid to avoid some small races which could happen with the
classic method alone. The setting 1 gives Linux 3.16 behaviour.

Hw pflip irqs are available since R600.

Tested on DCE-4, AMD Cedar - FirePro 2270.

v2:  agd5f: only enable pflip interrupts on DCE4+ as they are not
reliable on older asics.
Signed-off-by: NMario Kleiner <mario.kleiner.de@gmail.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Seems to make VM flushes more stable on SI and CIK.

v2: only use the PFP on the GFX ring on CIK
Signed-off-by: NChristian König <christian.koenig@amd.com>
Cc: stable@vger.kernel.org
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Doesn't seem necessary, the GART table memory should be persistent.
Signed-off-by: NMichel Dänzer <michel.daenzer@amd.com>
Reviewed-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

This adds SI support for the new ucode format.

v2: add size validation, integrate debug info
v3: update to latest version
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

We must mask out the overflow bit as well, otherwise
the wptr will never match the rptr again and the interrupt
handler will loop forever.
Signed-off-by: NChristian König <christian.koenig@amd.com>
Cc: stable@vger.kernel.org
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Reviewed-by: NMichel Dänzer <michel.daenzer@amd.com>

Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Query to find out how many compute units on a GPU.
Useful for OpenCL usermode drivers.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Replace occurrences of "v & 0xffffffff" with lower_32_bits(v)
when it's next to an upper_32_bits(v). Also remove unnecessary
"upper_32_bits(v) & 0xffffffff" code snippets.
Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

This patch makes it possible to decide how many address
bits are spend on the page directory vs the page tables.

v2: remove unintended change
Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

This patch implements support for VRAM page table entry compression.
PTE construction is enhanced to identify physically contiguous page
ranges and mark them in the PTE fragment field. L1/L2 TLB support is
enabled for 64KB (SI/CIK) and 256KB (NI) PTE fragments, significantly
improving TLB utilization for VRAM allocations.

Linear store bandwidth is improved from 60GB/s to 125GB/s on Pitcairn.
Unigine Heaven 3.0 sees an average improvement from 24.7 to 27.7 FPS
on default settings at 1920x1200 resolution with vsync disabled.

See main comment in radeon_vm.c for a technical description.

v2 (chk): rebased and simplified.
v3 (chk): add missing hw setup
v4 (chk): rebased on current drm-fixes-3.15
v5 (chk): fix comments and commit text
Signed-off-by: NJay Cornwall <jay@jcornwall.me>
Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Testing the update pending bit directly after issuing an
update is nonsense cause depending on the pixel clock the
CRTC needs a bit of time to execute the flip even when we
are in the VBLANK period.

This is just a non invasive patch to solve the problem at
hand, a more complete and cleaner solution should follow
in the next merge window.

Fixes: https://bugs.freedesktop.org/show_bug.cgi?id=76564

v2: fix source IDs for CRTC2-6
Signed-off-by: NChristian König <christian.koenig@amd.com>
Cc: stable@vger.kernel.org

Avoid a possible segfault.
Noticed-by: NDan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

May fix stability issues with some newer cards.

v2: print out mc firmware version used and size
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

Moving the pm resume up in the init order to fix
dpm seems to have regressed somes cases with the old
pm code.  Move it back to late resume.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

The reason for the false positives was fixed quite some time ago and since
most engines can still execute NOPs while being locked up it leads to false
negatives.
Signed-off-by: NChristian König <christian.koenig@amd.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>

In all cases where it really matters we are using the read functions anyway.
Signed-off-by: NChristian König <christian.koenig@amd.com>
Reviewed-by: NAlex Deucher <alexander.deucher@amd.com>

Otherwise decoding isn't really useable.

bug:
https://bugs.freedesktop.org/show_bug.cgi?id=71448Signed-off-by: NChristian König <christian.koenig@amd.com>
Cc: stable@vger.kernel.org
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

DCE5 and newer hardware only has 1 DAC.  Use the correct
offset.  This may fix display problems on certain board
configurations.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

If we are not able to properly initialize one of the gpu
engines for buffer paging, we limit vram to the size of
the cpu visible aperture.  We generally either use the gfx
or dma engine to do this.  Clean up the size limiting code
to only adjust the size based on what ring is selected
for buffer paging rather than making assumptions about which
engine is selected for paging.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Reviewed-by: NChristian König <christian.koenig@amd.com>

For consistency.  These buffers aren't used when pg is
disabled.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

pci config reset is a low level reset that resets
the entire chip from the bus interface.  It can
be more reliable if soft reset fails.

v2: hide behind module parameter
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Fill in asic family specific versions rather than
using the generic version.  This lets us handle asic
specific differences more easily.  In this case, we
disable sw swapping of the rtpr writeback value on
r6xx+ since the hw does it for us.  Fixes bogus
rptr readback on BE systems.

v2: remove missed cpu_to_le32(), add comments
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

We need more control over the ordering of dpm init with
respect to the rest of the asic.  Specifically, the SMC
has to be initialized before the rlc and cg/pg.  The pm
code currently initializes late in the driver, but we need
it to happen much earlier so move pm handling into the asic
specific callbacks.

This makes dpm more reliable and makes clockgating work
properly on CIK parts and should help on SI parts as well.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

We need to reorder the driver init sequence to better accomodate
dpm which needs to be loaded earlier in the init sequence.  Move
fw init up so that it's available for dpm init.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

I'm not entirely sure this is required and it won't work
with the dpm restructing anyway.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

This will allow userspace to correctly program the PA_SC_RASTER_CONFIG
register, so it can be considered a fix.
Signed-off-by: NMarek Olšák <marek.olsak@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

Only the render backends of the first shader engine were enabled. The others
were erroneously disabled. Enabling the other render backends improves
performance a lot.

Unigine Sanctuary on Bonaire:
  Before: 15 fps
  After:  90 fps

Judging from the fan noise, the GPU was also underclocked when the other
render backends were disabled, resulting in horrible performance. The fan is
a lot noisy under load now.
Signed-off-by: NMarek Olšák <marek.olsak@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

Some boards seem to have garbage in the upper
16 bits of the vram size register.  Check for
this and clamp the size properly.  Fixes
boards reporting bogus amounts of vram.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

The DMA ring seems to be stable now.

v2: remove pt_ring_index as well
Signed-off-by: NChristian König <christian.koenig@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

The buffers needs to be in little endian format.
Noticed-by: NSylvain BERTRAND <sylware@legeek.net>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

Prevent driver load problems if the smc is missing.

bug:
https://bugzilla.kernel.org/show_bug.cgi?id=63011Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Tested-by: NMikko Rapeli <mikko.rapeli@iki.fi>
Cc: stable@vger.kernel.org

Disable CG/PG and stop the rlc before resetting.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

s/CG/PG/ in the GFX powergating flag name.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

The internal cp interrupts need to be enabled and
disabled at specific times in order clockgating to
work properly.  This patch changes the handling
of the CP_INT_CNTL register to respect the current
state of the internal CP interrupts when making
changes to the other interrupts in CP_INT_CNTL.
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>

The vram scratch buffer needs to be initialized
before the mc is programmed otherwise we program
0 as the GPU address of the default GPU fault
page.  In most cases we put vram at zero anyway and
reserve a page for the legacy vga buffer so in practice
this shouldn't cause any problems, but better to make
it correct.

Was changed in:
6fab3febReported-by: NFrankR Huang <FrankR.Huang@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org

We need to allocate line buffer to each display when
setting up the watermarks.  Failure to do so can lead
to a blank screen.  This fixes blank screen problems
on dce6 asics.

Fixes:
https://bugs.freedesktop.org/show_bug.cgi?id=64850

Based on an initial fix from:
Jay Cornwall <jay.cornwall@amd.com>
Signed-off-by: NAlex Deucher <alexander.deucher@amd.com>
Cc: stable@vger.kernel.org