ipmi:bt: Set the timeout before doing a capabilities check

There was one place where the timeout value for an operation was
not being set, if a capabilities request was done from idle.  Move
the timeout value setting to before where that change might be
requested.

IMHO the cause here is the invisible returns in the macros.  Maybe
that's a job for later, though.
Reported-by: NNordmark Claes <Claes.Nordmark@tieto.com>
Signed-off-by: NCorey Minyard <cminyard@mvista.com>
Cc: stable@vger.kernel.org

drivers/char/ipmi/ipmi_bt_sm.c

@@ -504,11 +504,12 @@ static enum si_sm_result bt_event(struct si_sm_data *bt, long time)
 		if (status & BT_H_BUSY)		/* clear a leftover H_BUSY */
 			BT_CONTROL(BT_H_BUSY);
 
+		bt->timeout = bt->BT_CAP_req2rsp;
+
 		/* Read BT capabilities if it hasn't been done yet */
 		if (!bt->BT_CAP_outreqs)
 			BT_STATE_CHANGE(BT_STATE_CAPABILITIES_BEGIN,
 					SI_SM_CALL_WITHOUT_DELAY);
-		bt->timeout = bt->BT_CAP_req2rsp;
 		BT_SI_SM_RETURN(SI_SM_IDLE);
 
 	case BT_STATE_XACTION_START: