提交 fc103349 编写于 作者: R Ralf Baechle

[MIPS] Remove BSD and Sys V compat data types.

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>
上级 89e22d15
......@@ -585,13 +585,13 @@ void intc1_req1_irqdispatch(struct pt_regs *regs)
* au_sleep function in power.c.....maybe I should just pm_register()
* them instead?
*/
static uint sleep_intctl_config0[2];
static uint sleep_intctl_config1[2];
static uint sleep_intctl_config2[2];
static uint sleep_intctl_src[2];
static uint sleep_intctl_assign[2];
static uint sleep_intctl_wake[2];
static uint sleep_intctl_mask[2];
static unsigned int sleep_intctl_config0[2];
static unsigned int sleep_intctl_config1[2];
static unsigned int sleep_intctl_config2[2];
static unsigned int sleep_intctl_src[2];
static unsigned int sleep_intctl_assign[2];
static unsigned int sleep_intctl_wake[2];
static unsigned int sleep_intctl_mask[2];
void
save_au1xxx_intctl(void)
......
......@@ -80,17 +80,17 @@ static DEFINE_SPINLOCK(pm_lock);
* We only have to save/restore registers that aren't otherwise
* done as part of a driver pm_* function.
*/
static uint sleep_aux_pll_cntrl;
static uint sleep_cpu_pll_cntrl;
static uint sleep_pin_function;
static uint sleep_uart0_inten;
static uint sleep_uart0_fifoctl;
static uint sleep_uart0_linectl;
static uint sleep_uart0_clkdiv;
static uint sleep_uart0_enable;
static uint sleep_usbhost_enable;
static uint sleep_usbdev_enable;
static uint sleep_static_memctlr[4][3];
static unsigned int sleep_aux_pll_cntrl;
static unsigned int sleep_cpu_pll_cntrl;
static unsigned int sleep_pin_function;
static unsigned int sleep_uart0_inten;
static unsigned int sleep_uart0_fifoctl;
static unsigned int sleep_uart0_linectl;
static unsigned int sleep_uart0_clkdiv;
static unsigned int sleep_uart0_enable;
static unsigned int sleep_usbhost_enable;
static unsigned int sleep_usbdev_enable;
static unsigned int sleep_static_memctlr[4][3];
/* Define this to cause the value you write to /proc/sys/pm/sleep to
* set the TOY timer for the amount of time you want to sleep.
......
......@@ -65,9 +65,9 @@ int __init prom_init(int argc, char **argv, char **envp, int *prom_vec)
/* We use a0 and a1 to pass initrd start and size.
*/
if (((uint) argc > 0) && ((uint)argv > 0)) {
my_initrd_start = (uint)argc;
my_initrd_size = (uint)argv;
if (((unsigned int) argc > 0) && ((uint)argv > 0)) {
my_initrd_start = (unsigned int)argc;
my_initrd_size = (unsigned int)argv;
}
/* First argv is ignored.
......
......@@ -164,8 +164,8 @@ void __init plat_mem_setup(void)
pm_power_off = momenco_ocelot_power_off;
/*
* initrd_start = (ulong)ocelot_initrd_start;
* initrd_end = (ulong)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_start = (unsigned long)ocelot_initrd_start;
* initrd_end = (unsigned long)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_below_start_ok = 1;
*/
......
......@@ -260,7 +260,7 @@ static unsigned int apm_poll(struct file *fp, poll_table * wait)
* has acknowledge does the actual suspend happen.
*/
static int
apm_ioctl(struct inode * inode, struct file *filp, u_int cmd, u_long arg)
apm_ioctl(struct inode * inode, struct file *filp, unsigned int cmd, unsigned long arg)
{
struct apm_user *as = filp->private_data;
unsigned long flags;
......
......@@ -301,7 +301,7 @@ asmlinkage int _sys_sysmips(int cmd, long arg1, int arg2, int arg3)
*
* This is really horribly ugly.
*/
asmlinkage int sys_ipc (uint call, int first, int second,
asmlinkage int sys_ipc (unsigned int call, int first, int second,
unsigned long third, void __user *ptr, long fifth)
{
int version, ret;
......@@ -359,18 +359,18 @@ asmlinkage int sys_ipc (uint call, int first, int second,
case SHMAT:
switch (version) {
default: {
ulong raddr;
unsigned long raddr;
ret = do_shmat (first, (char __user *) ptr, second,
&raddr);
if (ret)
return ret;
return put_user (raddr, (ulong __user *) third);
return put_user (raddr, (unsigned long __user *) third);
}
case 1: /* iBCS2 emulator entry point */
if (!segment_eq(get_fs(), get_ds()))
return -EINVAL;
return do_shmat (first, (char __user *) ptr, second,
(ulong *) third);
(unsigned long *) third);
}
case SHMDT:
return sys_shmdt ((char __user *)ptr);
......
......@@ -370,8 +370,8 @@ void __init plat_mem_setup(void)
pm_power_off = momenco_jaguar_power_off;
/*
* initrd_start = (ulong)jaguar_initrd_start;
* initrd_end = (ulong)jaguar_initrd_start + (ulong)jaguar_initrd_size;
* initrd_start = (unsigned long)jaguar_initrd_start;
* initrd_end = (unsigned long)jaguar_initrd_start + (ulong)jaguar_initrd_size;
* initrd_below_start_ok = 1;
*/
......
......@@ -242,8 +242,8 @@ void __init plat_mem_setup(void)
pm_power_off = momenco_ocelot_power_off;
/*
* initrd_start = (ulong)ocelot_initrd_start;
* initrd_end = (ulong)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_start = (unsigned long)ocelot_initrd_start;
* initrd_end = (unsigned long)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_below_start_ok = 1;
*/
......
......@@ -174,8 +174,8 @@ void __init plat_mem_setup(void)
pm_power_off = momenco_ocelot_power_off;
/*
* initrd_start = (ulong)ocelot_initrd_start;
* initrd_end = (ulong)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_start = (unsigned long)ocelot_initrd_start;
* initrd_end = (unsigned long)ocelot_initrd_start + (ulong)ocelot_initrd_size;
* initrd_below_start_ok = 1;
*/
......
......@@ -119,7 +119,7 @@ static int tx4927_pcibios_read_config(struct pci_bus *bus, unsigned int devfn, i
switch (size) {
case 1:
*val = *(volatile u8 *) ((ulong) & tx4927_pcicptr->
*val = *(volatile u8 *) ((unsigned long) & tx4927_pcicptr->
g2pcfgdata |
#ifdef __LITTLE_ENDIAN
(where & 3));
......@@ -128,7 +128,7 @@ static int tx4927_pcibios_read_config(struct pci_bus *bus, unsigned int devfn, i
#endif
break;
case 2:
*val = *(volatile u16 *) ((ulong) & tx4927_pcicptr->
*val = *(volatile u16 *) ((unsigned long) & tx4927_pcicptr->
g2pcfgdata |
#ifdef __LITTLE_ENDIAN
(where & 3));
......@@ -168,7 +168,7 @@ static int tx4927_pcibios_write_config(struct pci_bus *bus, unsigned int devfn,
switch (size) {
case 1:
*(volatile u8 *) ((ulong) & tx4927_pcicptr->
*(volatile u8 *) ((unsigned long) & tx4927_pcicptr->
g2pcfgdata |
#ifdef __LITTLE_ENDIAN
(where & 3)) = val;
......@@ -178,7 +178,7 @@ static int tx4927_pcibios_write_config(struct pci_bus *bus, unsigned int devfn,
break;
case 2:
*(volatile u16 *) ((ulong) & tx4927_pcicptr->
*(volatile u16 *) ((unsigned long) & tx4927_pcicptr->
g2pcfgdata |
#ifdef __LITTLE_ENDIAN
(where & 3)) = val;
......
......@@ -106,7 +106,7 @@ static int tx4938_pcibios_read_config(struct pci_bus *bus, unsigned int devfn,
switch (size) {
case 1:
*val = *(volatile u8 *) ((ulong) & tx4938_pcicptr->g2pcfgdata |
*val = *(volatile u8 *) ((unsigned long) & tx4938_pcicptr->g2pcfgdata |
#ifdef __BIG_ENDIAN
((where & 3) ^ 3));
#else
......@@ -114,7 +114,7 @@ static int tx4938_pcibios_read_config(struct pci_bus *bus, unsigned int devfn,
#endif
break;
case 2:
*val = *(volatile u16 *) ((ulong) & tx4938_pcicptr->g2pcfgdata |
*val = *(volatile u16 *) ((unsigned long) & tx4938_pcicptr->g2pcfgdata |
#ifdef __BIG_ENDIAN
((where & 3) ^ 2));
#else
......@@ -154,7 +154,7 @@ static int tx4938_pcibios_write_config(struct pci_bus *bus, unsigned int devfn,
switch (size) {
case 1:
*(volatile u8 *) ((ulong) & tx4938_pcicptr->g2pcfgdata |
*(volatile u8 *) ((unsigned long) & tx4938_pcicptr->g2pcfgdata |
#ifdef __BIG_ENDIAN
((where & 3) ^ 3)) = val;
#else
......@@ -162,7 +162,7 @@ static int tx4938_pcibios_write_config(struct pci_bus *bus, unsigned int devfn,
#endif
break;
case 2:
*(volatile u16 *) ((ulong) & tx4938_pcicptr->g2pcfgdata |
*(volatile u16 *) ((unsigned long) & tx4938_pcicptr->g2pcfgdata |
#ifdef __BIG_ENDIAN
((where & 0x3) ^ 0x2)) = val;
#else
......
......@@ -602,7 +602,7 @@ typedef struct klcpu_s { /* CPU */
typedef struct klhub_s { /* HUB */
klinfo_t hub_info;
uint hub_flags; /* PCFG_HUB_xxx flags */
unsigned int hub_flags; /* PCFG_HUB_xxx flags */
klport_t hub_port; /* hub is connected to this */
nic_t hub_box_nic; /* nic of containing box */
klconf_off_t hub_mfg_nic; /* MFG NIC string */
......@@ -611,7 +611,7 @@ typedef struct klhub_s { /* HUB */
typedef struct klhub_uart_s { /* HUB */
klinfo_t hubuart_info;
uint hubuart_flags; /* PCFG_HUB_xxx flags */
unsigned int hubuart_flags; /* PCFG_HUB_xxx flags */
nic_t hubuart_box_nic; /* nic of containing box */
} klhub_uart_t ;
......@@ -710,7 +710,7 @@ typedef struct klvmed_s { /* VME DEVICE - VME BOARD */
/* XXX - Don't we need the number of ports here?!? */
typedef struct klrou_s { /* ROUTER */
klinfo_t rou_info ;
uint rou_flags ; /* PCFG_ROUTER_xxx flags */
unsigned int rou_flags ; /* PCFG_ROUTER_xxx flags */
nic_t rou_box_nic ; /* nic of the containing module */
klport_t rou_port[MAX_ROUTER_PORTS + 1] ; /* array index 1 to 6 */
klconf_off_t rou_mfg_nic ; /* MFG NIC string */
......@@ -733,8 +733,8 @@ typedef struct klgfx_s { /* GRAPHICS Device */
klinfo_t gfx_info;
klconf_off_t old_gndevs; /* for compatibility with older proms */
klconf_off_t old_gdoff0; /* for compatibility with older proms */
uint cookie; /* for compatibility with older proms */
uint moduleslot;
unsigned int cookie; /* for compatibility with older proms */
unsigned int moduleslot;
struct klgfx_s *gfx_next_pipe;
graphics_t gfx_specific;
klconf_off_t pad0; /* for compatibility with older proms */
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册