提交 f41c70c4 编写于 作者: M Marcel Holtmann 提交者: Johan Hedberg

Bluetooth: Add driver setup stage for early init

Some drivers require a special stage for their early init. This is
always specific to the driver or transport. So call back into driver to
allow bringing up the device.

The advantage with this stage is that the Bluetooth core is actually
handling the HCI layer now. This means that command and event processing
is available.
Signed-off-by: NMarcel Holtmann <marcel@holtmann.org>
Signed-off-by: NJohan Hedberg <johan.hedberg@intel.com>
上级 7b1abbbe
......@@ -293,6 +293,7 @@ struct hci_dev {
int (*open)(struct hci_dev *hdev);
int (*close)(struct hci_dev *hdev);
int (*flush)(struct hci_dev *hdev);
int (*setup)(struct hci_dev *hdev);
int (*send)(struct sk_buff *skb);
void (*notify)(struct hci_dev *hdev, unsigned int evt);
int (*ioctl)(struct hci_dev *hdev, unsigned int cmd, unsigned long arg);
......
......@@ -1127,26 +1127,33 @@ int hci_dev_open(__u16 dev)
goto done;
}
if (test_bit(HCI_QUIRK_RAW_DEVICE, &hdev->quirks))
set_bit(HCI_RAW, &hdev->flags);
/* Treat all non BR/EDR controllers as raw devices if
enable_hs is not set */
if (hdev->dev_type != HCI_BREDR && !enable_hs)
set_bit(HCI_RAW, &hdev->flags);
if (hdev->open(hdev)) {
ret = -EIO;
goto done;
}
if (!test_bit(HCI_RAW, &hdev->flags)) {
atomic_set(&hdev->cmd_cnt, 1);
set_bit(HCI_INIT, &hdev->flags);
ret = __hci_init(hdev);
clear_bit(HCI_INIT, &hdev->flags);
atomic_set(&hdev->cmd_cnt, 1);
set_bit(HCI_INIT, &hdev->flags);
if (hdev->setup && test_bit(HCI_SETUP, &hdev->dev_flags))
ret = hdev->setup(hdev);
if (!ret) {
/* Treat all non BR/EDR controllers as raw devices if
* enable_hs is not set.
*/
if (hdev->dev_type != HCI_BREDR && !enable_hs)
set_bit(HCI_RAW, &hdev->flags);
if (test_bit(HCI_QUIRK_RAW_DEVICE, &hdev->quirks))
set_bit(HCI_RAW, &hdev->flags);
if (!test_bit(HCI_RAW, &hdev->flags))
ret = __hci_init(hdev);
}
clear_bit(HCI_INIT, &hdev->flags);
if (!ret) {
hci_dev_hold(hdev);
set_bit(HCI_UP, &hdev->flags);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册