arm64: dts: Add SDHCI DT node for NS2

The IPROC SDHCI driver works fine for SDIO 3.0 on NS2 so let's enable
it for NS2 SoC in NS2 DT.
Signed-off-by: NAnup Patel <anup.patel@broadcom.com>
Reviewed-by: NVikram Prakash <vikramp@broadcom.com>
Reviewed-by: NRay Jui <rjui@broadcom.com>
Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com>

arch/arm64/boot/dts/broadcom/ns2-svk.dts

@@ -64,6 +64,10 @@
 	status = "ok";
 };
 
+&sdio0 {
+	status = "ok";
+};
+
 &nand {
 	nandcs@0 {
 		compatible = "brcm,nandcs";

arch/arm64/boot/dts/broadcom/ns2.dtsi

@@ -291,6 +291,24 @@
 			reg = <0x66220000 0x28>;
 		};
 
+		sdio0: sdhci@66420000 {
+			compatible = "brcm,sdhci-iproc-cygnus";
+			reg = <0x66420000 0x100>;
+			interrupts = <GIC_SPI 421 IRQ_TYPE_LEVEL_HIGH>;
+			bus-width = <8>;
+			clocks = <&genpll_sw BCM_NS2_GENPLL_SW_SDIO_CLK>;
+			status = "disabled";
+		};
+
+		sdio1: sdhci@66430000 {
+			compatible = "brcm,sdhci-iproc-cygnus";
+			reg = <0x66430000 0x100>;
+			interrupts = <GIC_SPI 422 IRQ_TYPE_LEVEL_HIGH>;
+			bus-width = <8>;
+			clocks = <&genpll_sw BCM_NS2_GENPLL_SW_SDIO_CLK>;
+			status = "disabled";
+		};
+
 		nand: nand@66460000 {
 			compatible = "brcm,nand-iproc", "brcm,brcmnand-v6.1";
 			reg = <0x66460000 0x600>,