staging: et131x: Remove redundant struct adapter members

adapter->speed_duplex was never referenced.
adapter->registry_phy_coma was always set to zero, even in the vendor driver.

Removing all member references and associated dead code.
Signed-off-by: NMark Einon <mark.einon@gmail.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

drivers/staging/et131x/et1310_phy.c

@@ -496,12 +496,6 @@ void et131x_mii_check(struct et131x_adapter *adapter,
 
 			/* Setup ET1310 as per the documentation */
 			et131x_adapter_setup(adapter);
-
-			/* Setup the PHY into coma mode until the cable is
-			 * plugged back in
-			 */
-			if (adapter->registry_phy_coma == 1)
-				et1310_enable_phy_coma(adapter);
 		}
 	}
 

drivers/staging/et131x/et131x_adapter.h

@@ -178,9 +178,7 @@ struct et131x_adapter {
 	struct address_map __iomem *regs;
 
 	/* Registry parameters */
-	u8 speed_duplex;	/* speed/duplex */
 	u8 wanted_flow;		/* Flow we want for 802.3x flow control */
-	u8 registry_phy_coma;	/* Phy Coma mode enable/disable */
 
 	u32 registry_rx_mem_end;	/* Size of internal rx memory */
 	u32 registry_jumbo_packet;	/* Max supported ethernet packet size */

drivers/staging/et131x/et131x_initpci.c

@@ -250,14 +250,12 @@ void et131x_error_timer_handler(unsigned long data)
 		    "No interrupts, in PHY coma, pm_csr = 0x%x\n", pm_csr);
 
 	if (!(adapter->bmsr & BMSR_LSTATUS) &&
-	    adapter->registry_phy_coma &&
 	    adapter->boot_coma < 11) {
 		adapter->boot_coma++;
 	}
 
 	if (adapter->boot_coma == 10) {
-		if (!(adapter->bmsr & BMSR_LSTATUS)
-		    && adapter->registry_phy_coma) {
+		if (!(adapter->bmsr & BMSR_LSTATUS)) {
 			if ((pm_csr & ET_PM_PHY_SW_COMA) == 0) {
 				/* NOTE - This was originally a 'sync with
 				 *  interrupt'. How to do that under Linux?