提交 e1a14d0c 编写于 作者: G Glauber de Oliveira Costa 提交者: Ingo Molnar

x86: get rid of cpucount

weighting a map will do.
Signed-off-by: NGlauber Costa <gcosta@redhat.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
上级 1161705b
......@@ -166,8 +166,6 @@ static void __cpuinit smp_callin(void)
cpu_set(cpuid, cpu_callin_map);
}
static int cpucount;
/*
* Activate a secondary processor.
*/
......@@ -585,7 +583,6 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu)
/* start_eip had better be page-aligned! */
start_eip = setup_trampoline();
++cpucount;
alternatives_smp_switch(1);
/* So we see what's up */
......@@ -656,7 +653,6 @@ static int __cpuinit do_boot_cpu(int apicid, int cpu)
cpu_clear(cpu, cpu_initialized); /* was set by cpu_init() */
cpu_clear(cpu, cpu_possible_map);
per_cpu(x86_cpu_to_apicid, cpu) = BAD_APICID;
cpucount--;
}
/* mark "stuck" area as not stuck */
......@@ -672,7 +668,6 @@ void cpu_exit_clear(void)
idle_task_exit();
cpucount --;
cpu_uninit();
irq_ctx_exit(cpu);
......@@ -795,7 +790,6 @@ static int __init smp_sanity_check(unsigned max_cpus)
return 0;
}
/*
* Cycle through the processors sending APIC IPIs to boot each.
*/
......@@ -851,7 +845,7 @@ static void __init smp_boot_cpus(unsigned int max_cpus)
if (!check_apicid_present(bit))
continue;
if (max_cpus <= cpucount+1)
if (max_cpus <= cpus_weight(cpu_present_map))
continue;
/* Utterly temporary */
for (cpu = 0; cpu < NR_CPUS; cpu++)
......@@ -878,7 +872,7 @@ static void __init smp_boot_cpus(unsigned int max_cpus)
bogosum += cpu_data(cpu).loops_per_jiffy;
printk(KERN_INFO
"Total of %d processors activated (%lu.%02lu BogoMIPS).\n",
cpucount+1,
cpus_weight(cpu_present_map),
bogosum/(500000/HZ),
(bogosum/(5000/HZ))%100);
......@@ -892,7 +886,7 @@ static void __init smp_boot_cpus(unsigned int max_cpus)
* approved Athlon
*/
if (tainted & TAINT_UNSAFE_SMP) {
if (cpucount)
if (cpus_weight(cpu_present_map))
printk (KERN_INFO "WARNING: This combination of AMD processors is not suitable for SMP.\n");
else
tainted &= ~TAINT_UNSAFE_SMP;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册