提交 e0f4258b 编写于 作者: J Jonas Bonn 提交者: David S. Miller

ethoc: Add device tree configuration

This patch adds the ability to describe ethernet devices via a flattened
device tree.  As device tree remains an optional feature, these bits all
need to be guarded by CONFIG_OF ifdefs.

MAC address is settable via the device tree parameter "local-mac-address";
however, the selection of the phy id is limited to probing, for now.
Signed-off-by: NJonas Bonn <jonas@southpole.se>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 3f0a069a
......@@ -19,6 +19,7 @@
#include <linux/platform_device.h>
#include <linux/sched.h>
#include <linux/slab.h>
#include <linux/of.h>
#include <net/ethoc.h>
static int buffer_size = 0x8000; /* 32 KBytes */
......@@ -982,10 +983,23 @@ static int __devinit ethoc_probe(struct platform_device *pdev)
/* Allow the platform setup code to pass in a MAC address. */
if (pdev->dev.platform_data) {
struct ethoc_platform_data *pdata =
(struct ethoc_platform_data *)pdev->dev.platform_data;
struct ethoc_platform_data *pdata = pdev->dev.platform_data;
memcpy(netdev->dev_addr, pdata->hwaddr, IFHWADDRLEN);
priv->phy_id = pdata->phy_id;
} else {
priv->phy_id = -1;
#ifdef CONFIG_OF
{
const uint8_t* mac;
mac = of_get_property(pdev->dev.of_node,
"local-mac-address",
NULL);
if (mac)
memcpy(netdev->dev_addr, mac, IFHWADDRLEN);
}
#endif
}
/* Check that the given MAC address is valid. If it isn't, read the
......@@ -1113,6 +1127,16 @@ static int ethoc_resume(struct platform_device *pdev)
# define ethoc_resume NULL
#endif
#ifdef CONFIG_OF
static struct of_device_id ethoc_match[] = {
{
.compatible = "opencores,ethoc",
},
{},
};
MODULE_DEVICE_TABLE(of, ethoc_match);
#endif
static struct platform_driver ethoc_driver = {
.probe = ethoc_probe,
.remove = __devexit_p(ethoc_remove),
......@@ -1120,6 +1144,10 @@ static struct platform_driver ethoc_driver = {
.resume = ethoc_resume,
.driver = {
.name = "ethoc",
.owner = THIS_MODULE,
#ifdef CONFIG_OF
.of_match_table = ethoc_match,
#endif
},
};
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册