[media] iguanair: explain tx carrier setup

Just comments. No functional changes.
Signed-off-by: NSean Young <sean@mess.org>
Signed-off-by: NMauro Carvalho Chehab <m.chehab@samsung.com>

drivers/media/rc/iguanair.c

@@ -286,10 +286,10 @@ static int iguanair_receiver(struct iguanair *ir, bool enable)
 }
 
 /*
- * The iguana ir creates the carrier by busy spinning after each pulse or
- * space. This is counted in CPU cycles, with the CPU running at 24MHz. It is
+ * The iguanair creates the carrier by busy spinning after each half period.
+ * This is counted in CPU cycles, with the CPU running at 24MHz. It is
  * broken down into 7-cycles and 4-cyles delays, with a preference for
- * 4-cycle delays.
+ * 4-cycle delays, minus the overhead of the loop itself (cycle_overhead).
  */
 static int iguanair_set_tx_carrier(struct rc_dev *dev, uint32_t carrier)
 {
@@ -316,7 +316,14 @@ static int iguanair_set_tx_carrier(struct rc_dev *dev, uint32_t carrier)
 		sevens = (4 - cycles) & 3;
 		fours = (cycles - sevens * 7) / 4;
 
-		/* magic happens here */
+		/*
+		 * The firmware interprets these values as a relative offset
+		 * for a branch. Immediately following the branches, there
+		 * 4 instructions of 7 cycles (2 bytes each) and 110
+		 * instructions of 4 cycles (1 byte each). A relative branch
+		 * of 0 will execute all of them, branch further for less
+		 * cycle burning.
+		 */
 		ir->packet->busy7 = (4 - sevens) * 2;
 		ir->packet->busy4 = 110 - fours;
 	}