iio: st_sensors: make interrupt optional

Some sensors such as magnetometers and pressure sensors doesn't
have interrupts at all, and thus no DRDY setting applies. Make
the assignment of an interrupt optional, and do not call
st_sensors_set_drdy_int_pin() if there is no drdy (data ready)
pin specified.
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
Signed-off-by: NJonathan Cameron <jic23@kernel.org>

drivers/iio/common/st_sensors/st_sensors_core.c

@@ -245,6 +245,16 @@ static int st_sensors_set_drdy_int_pin(struct iio_dev *indio_dev,
 {
 	struct st_sensor_data *sdata = iio_priv(indio_dev);
 
+	/* Sensor does not support interrupts */
+	if (sdata->sensor_settings->drdy_irq.addr == 0) {
+		if (pdata->drdy_int_pin)
+			dev_info(&indio_dev->dev,
+				 "DRDY on pin INT%d specified, but sensor "
+				 "does not support interrupts\n",
+				 pdata->drdy_int_pin);
+		return 0;
+	}
+
 	switch (pdata->drdy_int_pin) {
 	case 1:
 		if (sdata->sensor_settings->drdy_irq.mask_int1 == 0) {
@@ -285,7 +295,7 @@ static struct st_sensors_platform_data *st_sensors_of_probe(struct device *dev,
 	if (!of_property_read_u32(np, "st,drdy-int-pin", &val) && (val <= 2))
 		pdata->drdy_int_pin = (u8) val;
 	else
-		pdata->drdy_int_pin = defdata ? defdata->drdy_int_pin : 1;
+		pdata->drdy_int_pin = defdata ? defdata->drdy_int_pin : 0;
 
 	return pdata;
 }