Merge tag 'at91-fixes2' of...

Merge tag 'at91-fixes2' of git://git.kernel.org/pub/scm/linux/kernel/git/nferre/linux-at91 into fixes

Fixes: second batch for 4.14:
- one DT phy address fix for the new sama5d27 som1 ek
- two DT ADC patches that were forgotten while moving to
  hardware triggers for sama5d2 (iio changes already applied)

* tag 'at91-fixes2' of git://git.kernel.org/pub/scm/linux/kernel/git/nferre/linux-at91:
  ARM: dts: at91: sama5d2: add ADC hw trigger edge type
  ARM: dts: at91: sama5d2_xplained: enable ADTRG pin
  ARM: dts: at91: at91-sama5d27_som1: fix PHY ID

arch/arm/boot/dts/at91-sama5d27_som1.dtsi

@@ -67,8 +67,8 @@
 				pinctrl-0 = <&pinctrl_macb0_default>;
 				phy-mode = "rmii";
 
-				ethernet-phy@1 {
-					reg = <0x1>;
+				ethernet-phy@0 {
+					reg = <0x0>;
 					interrupt-parent = <&pioA>;
 					interrupts = <PIN_PD31 IRQ_TYPE_LEVEL_LOW>;
 					pinctrl-names = "default";

arch/arm/boot/dts/at91-sama5d2_xplained.dts

@@ -309,7 +309,7 @@
 				vddana-supply = <&vdd_3v3_lp_reg>;
 				vref-supply = <&vdd_3v3_lp_reg>;
 				pinctrl-names = "default";
-				pinctrl-0 = <&pinctrl_adc_default>;
+				pinctrl-0 = <&pinctrl_adc_default &pinctrl_adtrg_default>;
 				status = "okay";
 			};
 
@@ -340,6 +340,20 @@
 					bias-disable;
 				};
 
+				/*
+				 * The ADTRG pin can work on any edge type.
+				 * In here it's being pulled up, so need to
+				 * connect it to ground to get an edge e.g.
+				 * Trigger can be configured on falling, rise
+				 * or any edge, and the pull-up can be changed
+				 * to pull-down or left floating according to
+				 * needs.
+				 */
+				pinctrl_adtrg_default: adtrg_default {
+					pinmux = <PIN_PD31__ADTRG>;
+					bias-pull-up;
+				};
+
 				pinctrl_charger_chglev: charger_chglev {
 					pinmux = <PIN_PA12__GPIO>;
 					bias-disable;

arch/arm/boot/dts/sama5d2.dtsi

@@ -1430,6 +1430,7 @@
 				atmel,min-sample-rate-hz = <200000>;
 				atmel,max-sample-rate-hz = <20000000>;
 				atmel,startup-time-ms = <4>;
+				atmel,trigger-edge-type = <IRQ_TYPE_EDGE_RISING>;
 				status = "disabled";
 			};