starfire: clean up properly if firmware loading fails

netdev_open() will return without cleaning up net device or hardware state
if firmware loading fails.  This results in a BUG() on a second attempt to
bring the interface up, reported in
<http://bugzilla.kernel.org/show_bug.cgi?id=15091>, and probably has even
worse effects if the driver is removed afterwards.

Call netdev_close() to clean up on failure.

Addresses http://bugzilla.kernel.org/show_bug.cgi?id=15091Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Reported-by: NMichael Moffatt <michael@moffatt.org.nz>
Tested-by: NMichael Moffatt <michael@moffatt.org.nz>
Cc: "David S. Miller" <davem@davemloft.net>
Cc: <stable@kernel.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/starfire.c

@@ -1063,7 +1063,7 @@ static int netdev_open(struct net_device *dev)
 	if (retval) {
 		printk(KERN_ERR "starfire: Failed to load firmware \"%s\"\n",
 		       FIRMWARE_RX);
-		return retval;
+		goto out_init;
 	}
 	if (fw_rx->size % 4) {
 		printk(KERN_ERR "starfire: bogus length %zu in \"%s\"\n",
@@ -1108,6 +1108,9 @@ static int netdev_open(struct net_device *dev)
 	release_firmware(fw_tx);
 out_rx:
 	release_firmware(fw_rx);
+out_init:
+	if (retval)
+		netdev_close(dev);
 	return retval;
 }