mmc: tmio: reset the controller after power-up

This fixes two reported problems:
1. after a system resume the controller isn't functioning until a command
   runs on a timeout and a controller reset is performed.
2. if a card is ejected during a running write operation, its re-insertion
   isn't detected.
Reported-by: NNguyen Viet Dung <nv-dung@jinso.co.jp>
Reported-by: NNguyen Hong Ky <nh-ky@jinso.co.jp>
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski+renesas@gmail.com>
Tested-by: NNguyen Viet Dung <nv-dung@jinso.co.jp>
Tested-by: NNguyen Hong Ky <nh-ky@jinso.co.jp>
Signed-off-by: NChris Ball <cjb@laptop.org>

drivers/mmc/host/tmio_mmc_pio.c

@@ -867,6 +867,8 @@ static void tmio_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
 				host->resuming = false;
 			}
 		}
+		if (host->power == TMIO_MMC_OFF_STOP)
+			tmio_mmc_reset(host);
 		tmio_mmc_set_clock(host, ios->clock);
 		if (host->power == TMIO_MMC_OFF_STOP)
 			/* power up SD card and the bus */
@@ -1186,7 +1188,6 @@ int tmio_mmc_host_runtime_resume(struct device *dev)
 	struct mmc_host *mmc = dev_get_drvdata(dev);
 	struct tmio_mmc_host *host = mmc_priv(mmc);
 
-	tmio_mmc_reset(host);
 	tmio_mmc_enable_dma(host, true);
 
 	return 0;