staging: lustre: make lustre dependent on LNet

In the case of lustre routers you only need a functioning
LNet stack. Especially since often the routers are very
light weight and want to avoid any addition software that
would create additional pressures on the system.
Signed-off-by: NJames Simmons <jsimmons@infradead.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/Makefile

@@ -30,7 +30,7 @@ obj-$(CONFIG_WIMAX_GDM72XX)	+= gdm72xx/
 obj-$(CONFIG_LTE_GDM724X)	+= gdm724x/
 obj-$(CONFIG_FIREWIRE_SERIAL)	+= fwserial/
 obj-$(CONFIG_GOLDFISH)		+= goldfish/
-obj-$(CONFIG_LUSTRE_FS)		+= lustre/
+obj-$(CONFIG_LNET)		+= lustre/
 obj-$(CONFIG_DGNC)			+= dgnc/
 obj-$(CONFIG_MTD_SPINAND_MT29F)	+= mt29f_spinand/
 obj-$(CONFIG_GS_FPGABOOT)	+= gs_fpgaboot/

drivers/staging/lustre/Kconfig

-source "drivers/staging/lustre/lustre/Kconfig"
-
 source "drivers/staging/lustre/lnet/Kconfig"
+
+source "drivers/staging/lustre/lustre/Kconfig"

drivers/staging/lustre/lnet/Kconfig

 config LNET
 	tristate "Lustre networking subsystem (LNet)"
-	depends on LUSTRE_FS
+	depends on INET && m
 	help
 	  The Lustre network layer, also known as LNet, is a networking abstaction
 	  level API that was initially created to allow Lustre Filesystem to utilize

drivers/staging/lustre/lustre/Kconfig

 config LUSTRE_FS
 	tristate "Lustre file system client support"
-	depends on INET && m && !MIPS && !XTENSA && !SUPERH
+	depends on m && !MIPS && !XTENSA && !SUPERH
 	select LNET
 	select CRYPTO
 	select CRYPTO_CRC32